Samsung Syncmaster 225uw Quick Start Guide

 
 
   
1. Turn off your monitor and unplug its power cord.
2. Lay the LCD monitor face-down on a flat surface with a cushion beneath it to protect the 
screen.
3. Remove four screws and then remove the stand from the LCD monitor.
4. Align the mounting interface Pad with the holes in the rear cover mounting pad and 
secure it with four screws that came with the arm-type base, wall mount hanger or other 
base.
  
 
zDo not use screws longer than the standard dimension, as they may damage the inside of...

 
 
 
 
 
 
 
This monitor can be used as a normal monitor for video communications and for viewing multimedia files simply by connecting the power cable and the USB cable to your PC. 
Minimum baseline spec 
 
zIntel Pentium4 1.73GHz or later, or AMD Equivalent Processor zMicrosoft Windows XP Service Pack2(SP2), Windows Vista  z256MB RAM, USB2.0 
Unified Communication
Auto Setup for the web camera,  microphone and speaker
 
Connect your monitor and PC using a USB cable, as shown in the figure below.
 

 
 
 
  
 
The web camera, microphone and speaker will be set up automatically and appear on the status 
bar. 
 
  
 
If the camera is recognized as a USB1.1 device, the screen quality may be degraded and noise 
may occur. Make sure to upgrade to USB 2.0. 
Because of the characteristics of USB communication, the device is recognized whenever it is 
turned off and on. When the recognition process is finished, you can use it normally.  
If you remove the cable while your PC is recognizing a USB device, it...

 
 
  
The symbol showing that the device has failed to be installed is displayed as shown in 
In this case, click “Scan for hardware changes” to run the Setup Wizard again. 
  At this time, if the installation fails, click   and right-click it. Select ‘Driver Update’ from the 
displayed menu.
Checking the configuration 
After the installation, you can check the configuration by following these steps:
  
Right-click My computer, click Properties - System Properties - Hardware tab. 
  
 
  
Click on...

 
 
  
A list of installed devices will be displayed, as shown in the figure below.
  
 
  
Checking the Web Camera Setup
Double-click My Computer on the Windows Desktop.
Double-click the USB Video Device #2. You should find that the web camera has been set up 
normally, as shown in the figure below. 
 

 
 
      
Checking the Microphone and Speaker Setup
Double-click Sounds and Audio Devices in the Control Panel.
  
 
    
Select the Voice tab and click on Test Hardware.
  
 
 
 

 
 
   
    
If the sound from your monitor is too soft, adjust the volume after setting the volume of your PC to 
the maximum. 
  
Follow the steps described below. You should find that the microphone and speaker have been 
set up.
  
 
    
UC Monitor Limitations
This monitor is a UC monitor and therefore when connecting cameras and audio devices to it, 
cameras and audio devices except for the monitor display are recognized as USB devices and 
not as a camera or audio device.
This monitor must be...

  
This monitor supports Windows XP Service Pack 2 or later only. 
Service Pack 1 or earlier is not supported. 
This monitor is designed for optimal performance using Windows XP Service Pack 2 and USB 
2.0.
  
The UC monitor may not work normally with versions earlier than USB 2.0.
  
If you connect multiple UC monitors, the USB devices recognized by these monitors may not 
work normally. 
  
Noise may occur from the MIC and speaker if this monitor is placed too near.
  
 
 
 Monitor Driver 
When...

 
 
 
 
   
 system.  
The certified driver will be posted on Samsung Monitor homepage  
 
htt
p://www.samsung.com/ 
Monitor driver installation is completed. 
Installing the Monitor Driver (Manual)
Windows Vista | Windows XP | Windows 2000 | Windows ME | Windows NT | Linux 
Microsoft® Windows Vista™ Operating System   
 
Insert your Manual CD into your CD-ROM drive.
Click  (Start) and Control Panel. Then, double-click on Appearance and Personalization.  
 
 
   
Click Personalization and then Display...

 
 
    
This monitor driver is under certifying MS logo, and this installation doesnt damage your 
system.  
The certified driver will be posted on Samsung Monitor homepage  
 
http://www.samsung.com/ 
Click Update Driver… in the Driver tab.  
 
 
   
Check the Browse my computer for driver software checkbox and click Let me pick from a list 
of device drivers on my computer.  
 
 
   
Click Have Disk… and select the folder (for example, D:\Drive) where the driver setup file is 
located, and click OK....