Samsung SCX 4200 User Manual

Getting started
2.8
System requirements
Before you begin, ensure that your system meets the minimum 
requirements.
Windows
Your machine supports the following Windows operating systems. 
NOTE: 
• Internet Explorer 5.0 or higher is the minimum requirement 
for all Windows operating systems.
• Users who have an administrator right can install the 
software.
Operating 
SystemRequirement (recommended)
CPURAMfree HDD 
space
Windows 
2000Pentium II 400 MHz 
(Pentium III 933 MHz)64 MB 
(128 MB)600 MB
Windows...

Loading original documents and paper
3.1
3Loading original 
documents and paper
This chapter introduces you to how to load documents and print 
materials into your machine.
This chapter includes:
• Loading document
• Selecting print materials
• Loading paper
• Setting the paper size and type
• Selecting an output location
Loading document
You can use the document glass to load an original document 
for copying and scanning.
1Lift and open the document cover.
2Place the document face down on the document...

Loading original documents and paper
3.2
Selecting print materials
You can print on a variety of print materials, such as plain 
paper, envelopes, labels, and transparencies. Always use print 
materials that meet the guidelines for use with your machine. 
Paper that does not meet the guidelines outlined in this user’s 
guide may cause the following problems:
• Poor print quality
• Increased paper jams
•Premature wear on the machine.
Properties, such as weight, composition, grain, and moisture 
content,...

Loading original documents and paper
3.3
Paper size supported in each mode
Envelope
(continued)Envelope C6 114 x 162 mm
(4.48 x 6.37 
inches)60 to 90 
g/m2 (16 to 
24 lb)1 sheet of 
paper for 
the manual 
feeder
Transparency Letter, A4 Refer to the Plain 
paper section138 to 148 
g/m
21 sheet of 
paper for 
the manual 
feeder
Labels Letter, Legal, 
Folio, A4, JIS 
B5, ISO B5, 
Executive, 
A5, A6Refer to the Plain 
paper section120 to 150 
g/m
2 (32 to 
40 lb)1 sheet of 
paper for 
the manual 
feeder
Card...

Loading original documents and paper
3.4
Guidelines for special materials
Paper TypeGuidelines
Envelopes • Successful printing on envelopes depends upon the 
quality of the envelopes. When selecting envelopes, 
consider the following factors:
- Weight: The weight of the envelope paper should 
not exceed 90 g/m
2 (24 lb) or jamming may 
occur.
- Construction: Prior to printing, envelopes should 
lie flat with less than 6 mm (0.25 inches) curl, and 
should not contain air.
- Condition: Envelopes should not...

Loading original documents and paper
3.5
Loading paper
In the paper input tray
Load the print material you use for the majority of your print 
jobs in the paper input tray. The paper input tray can hold a 
maximum of 250 sheets of 20 lb (
75 g/m2) plain paper. 
To load paper, pull open the paper input tray and load paper 
with the side to be printed on face down.
You can load letterhead paper with the design side face down. 
The top edge of the sheet with the l o g o  s h o u l d  be  p l a c e d a t  t...

Loading original documents and paper
3.6
2Adjust the manual feeder guides to the width of the print 
material without bending it.
3After loading paper, you need to set the paper type and 
size for the manual feeder. See page 3.6 for copying or the 
Software Section for PC-printing.
NOTE: The settings made from the printer driver override the 
settings on the control panel.
4If you want to use the rear cover, open the rear cover.
Tips on using the manual feeder
• Print materials should be loaded face up...

Loading original documents and paper
3.7
2Take the paper out manually.
3Close the scan unit. In order to close the cover, push the 
tab to the left and hold it down. Then lower the cover 
carefully until the cover is holding down the tab. Then you 
can move your hand and finish lowering the cover.
Be careful not to pinch your fingers!
NOTES:
• If you continuously print many pages, the surface of the 
output tray may become hot. Be careful not to touch the 
surface, and especially keep children away from...

Copying
4.1
4Copying
This chapter gives you step-by-step instructions for copying 
documents.
This chapter includes:
•Copying
• Changing the settings for each copy
• Using special copy features
• Changing the default settings
• Setting the time out option
Copying
1Place a document on the document glass.
2Customize the copy settings including copy size, darkness, 
and original type, by using the control panel buttons. See 
page 4.1.
If necessary, you can use special copy features, such as 
Poster copying...

Copying
4.2
3Press OK to save the selection.
Changing the default settings
The copy options, including darkness, original type, copy size 
and number of copies, can be set to the most frequently used 
modes. When you copy a document, the default settings are 
used unless they are changed by using the menus on the 
control panel.
To create your own default settings:
1Press Menu until Copy Setup appears on the top line of 
the display. 
2Press OK when Default-Change appears.
3Press the scroll button (  or...