Samsung Rm 25 Kgrs Owners Manual

31
INSTALLATION INSTRUCTIONS
REATTACHING THE REFRIGERATOR DOORS
Reattaching the Fridge Door
1) Reattach a phillips screw (
➀) and two hex head
screws (➁) to the hinge completely.2) Place the hole in the bottom of the door (➃)
over the hinge (
➂).
3) Insert the upper hinge shaft (➄) into the hole (➅). After levelling between the hinge brackets (➆).
Reattach and close the latch (
➇) along the arrow.
4) Put the front part of the upper hinge cover (➈) on the front part of the upper hinge (➉) and reattach it...

32
REATTACHING THE REFRIGERATOR DOORS
FRONT LEG  COVER
Reattaching the Front  Leg Cover
Hold the front leg-cover with both hands and insert it by sliding the hooks along the
guide at the bottom.
Then, lift up the leg-front-cover a little bit and snap the upper ribs into the locking tabs.
Tighten two phillips screws to the front leg cover.
RIB
HOOK
%&	


 

.

 

33
INSTALLATION INSTRUCTIONS
CHECKING THE WATER DISPENSER LINE
1) In order to operate the ice maker properly, water pressure of 1.4 ~ 8.5kgf/cm2 (0.14~0.83Mpa,
19.9~120.9psi, 1.37~8.3bar) is required.
In this range a 100 cc paper cup can be filled in 10 seconds.
2) The water filter removes particles. It does not sterilize or destroy any micro-organisms.
3) If the refrigerator is installed in an area with low water pressure (1.4kgf/cm
2, 0.14Mpa, 19.9psi,
1.37bar), you should install a booster pump to...

34
INSTALLATION OF THE WATER DISPENSER LINE
Connect the water line to the refrigerator
Compression Nut
Compression fitting Sleeve
Compression Nut
Ferrule
Ferrule
-  Slip the compression nut and plastic ferrule through the plastic tube.
-  After inserting the sleeve, tighten the compression nut onto 1/4”
compression fitting(union).
Do not overtighten the compression nut.NOTE
Waterline must be connected to drinkable water onlyNOTE -  Slip  the compression ferrule and nut on copper
(or plastic) tubing as...

INSTALLATION OF THE WATER DISPENSER LINE
35
INSTALLATION INSTRUCTIONS
- Using clip ”A”, fix the water line to the wall (the back of refrigerator).
- When the water line is secure, make sure whether the
water line is not excessively bent, pinched or squashed.
Complete the installation of the water supply line.
- Power on the refrigerator and press the lever on the right of the
dispenser until water runs out through the water line and all air has been empty.
- At this time, check for any possible leakages...

36
WATER ICE
INSTALLATION OF THE WATER DISPENSER LINE
Remove any residual matter inside the water supply line after installing filter.
1) Turn on the main water supply & shut-off the valve of the
water supply line.
2) Run water through the dispenser until the water runs clear
(6~7 minutes). This will clean the water supply system and
clear air from the lines.
3) Additional flushing may be required in some households.
4) Open the fridge door and check if water leaks around the
water filter.
• A...

37
INSTALLATION INSTRUCTIONS
INSTALLATION OF THE WATER DISPENSER LINE
3) Important Facts About Your Dispenser :
Do not add ice from trays or bags to the storage bin. It may not crush or dispense well.
Avoid overfilling glass with ice and use of narrow or extra-tall glasses. Backed-up ice can jam the
chute or cause the door in the chute to freeze shut. If ice is blocking the chute, poke it through with
a wooden spoon.
Beverages and foods should not be quick-chilled in the ice storage bin.
To keep...

38
BEFORE YOU CALL FOR SERVICE...
Problem
The refrigerator does not
work sufficiently or at all
The food in the refrigera-
tor is frozen
Unusual noises or
sounds are heard
The front corners and
sides of the cabinet are
hot; condensation occurs
Ice is not dispensed
You can hear water bub-
bling in the refrigerator
There is a bad smell in
the refrigerator
Frost forms on the wall of
the freezer
No water is supplied
Door/ drawer does not
close by itself• Disconnected power plug
• Is the temperature control...

39
INSTALLATION INSTRUCTIONS
BEFORE YOU CALL FOR SERVICE...
Problem
Small or hollow cubes
Slow ice cube freezing
Orange glow in the freezer
Cube dispenser does not
work(on some models)
Water has poor taste/odor
(on some models)
Water in first glass is
warm (on some models)
Water dispenser does not
work(on some models)
Water spurting from dis-
penser (on some models)
Water is not dispensed 
(on some models) but 
icemaker is working
Water on kitchen floor or
on bottom of freezer
No water or ice cube...

Ambient Room Temperature Limits
This appliance is designed to operate at the ambient temperatures specified by its temperature
class marked on the rating plate.
NOTE:The internal temperature may be affected by such factors as the location of the appli-
ance, ambient temperature and the frequency with which you open the doors.
Adjust the temperature as required to compensate for these factors.
Temperature SymbolAmbient Temperature
Class Maximum   Minimum
Extended TemperateSN 32°C (90°F) 10°(50°F)...