Samsung Plasma HDTV PN60E8000 User Manual

Antenna function also determines 
the signal source the TV is tuned to. 
For example, if you receive your TV 
signal over the air, and you select 
Cable, you will see only snow. You 
must select Air  to see a picture.
Auto Program
Menu  → Channel 
→ Auto Program
The Auto Program function memorizes 
all channels that are available over the 
air or through your cable system and  

adds them to the Channel list.
To start the Auto Program, follow these 
steps:1.  
Go to the Auto Program menu.
2.  
Select  Air or Cable or both, and then 
select  Next. A 
c mark appears in 
the check box.
 
NIf you selected  Air or Cable in the 
Antenna  menu, your choice will 
already be selected.
3.  
If you selected the Cable, the cable  

system screen appears. Select the 
Digital Cable System.
 
NIf you selected the Air  only, the 
Auto Program starts.
4.
  Select the correct cable signal format 
-  STD, HRC or  IRC.
 
NMost cable systems use STD 
(Standard).
5.  
Repeat  for  Analog Cable System .
6.  
Select  Next. The Auto Program 
starts. 

 
NAfter all the available channels are 
stored, the  Auto Program removes 
scrambled channels. When done, 
the Auto Program menu then 
reappears. This process can take 
up to 30 minutes. 

Other FeaturesClear Scrambled Channel
Menu  → Channel 
→ Clear Scrambled 
Channel
This function filters out scrambled 
channels after the Auto Program is 
completed. This process may take up 
to 30 minutes.
 
NThis function is only available in 
Cable mode.
How to Stop the Clear Scrambled Channel  

function1. 
To stop the Clear Scrambled Channel 
function, select Stop.
2.  
The  message  Stop searching for 
scrambled channels? appears. Select 
Ye s .
3.  
The  Clear Scrambled Channel 
function will be stopped.
Fine Tune
Menu  → Channel 
→ Fine Tune
(analog channels only) 

If the reception is clear, you do not 
have to fine tune the channel, as this is 
done automatically during the search 
and store operation. If the signal is 
weak or distorted, fine tune the channel 
manually. Scroll to the left or right until 
the image is clear.
 
NSelect the channel, and then select 
Fine Tune.
 
NFine tuned channels that have been 
saved are marked with an asterisk “*”  

on the right-hand side of the channel 
number in the channel banner.
 
NTo reset fine-tuning, select the 
channel, select Fine Tune, and then 
select  Reset on the Fine Tune screen.
Crosstalk Noise Reduction
Menu  → Channel 
→ Crosstalk Noise 
Reduction
(analog channels only)
This function reduce diagonal noise 
in picture caused by the crosstalk of  

signals. If your TV displays with a 
noise while watching TV, turns on this 
function. 

Changing the Preset Picture ModePicture Mode
Menu  → Picture 
→ Picture Mode
Picture modes apply preset adjustments 
to the picture.
 
NWhen your TV is connected to a PC 
via the HDMI to DVI cable, you can 
only select Entertain  and Standard .
 
●Dynamic
Brightens the screen. Suitable for a 
bright room.
Basic Feature