Samsung Plasma E7000 User Manual

Samsung recommends using IEEE 
802.11n. When you play video over a 
network connection, the video may not 
play smoothly.
 
NTo use a wireless network, your TV 
must be connected to a wireless IP 
sharer (either a router or a modem). 
If the wireless IP sharer supports 
DHCP, your TV can use a DHCP or 
static IP address to connect to the 
wireless network. 

 
NSelect a channel for the wireless IP 
sharer that is not currently being 
used. If the channel set for the 
wireless IP sharer is currently being 
used by another device nearby, 
this will result in interference and 
communication failure.
 
NYour TV supports only the following 
wireless network security protocols: 
 
– Authentication Mode : WEP, 
WPAPSK, WPA2PSK  

 
– Encryption Type : WEP, TKIP, AES
 
NIf you select the Pure High-
throughput (Greenfield) 802.11n 
mode and the Encryption type 
is set to WEP, TKIP or TKIP AES 
(WPS2Mixed) on your AP or wireless 
router, Samsung TVs will not support 
a connection in compliance with new 
Wi-Fi certification specifications.
 
NIf your wireless router supports 
WPS (Wi-Fi Protected Setup), you  

can connect to the network via PBC 
(Push Button Configuration) or PIN 
(Personal Identification Number). 
WPS will automatically configure the 
SSID and WPA key in either mode.
 
NIf your router, modem, or device is 
not certified, it may not connect to 
the TV.
 
NConnection Methods: You can set up 
the wireless network connection in 
four ways: 

 
– Auto Setup (Using the Auto 
Network Search function)
 
– Manual Setup
 
– WPS(PBC)
 
– Plug & Access 

Setting up the Wired Network
Network Settings
Menu → Network
 
→  Network Settings
Set the wired or wireless network 
connection to use various Internet 
services such as  Smart Hub, AllShare 
Play  and perform software upgrades.
Automatic Wired Network Setup You can configure your TV's wired 
network connection automatically when 
connecting your TV to a network that  

supports DHCP.
 
NWhen connecting LAN cable, the 
screen pop-up appears directly to 
set wired network.
To set up your TV’s wired network 
connection automatically, follow these 
steps: 1.  
Go to the Network Settings screen. 
(Network  
→  Network Settings)
2.  
Select  Start. The network test screen 
appears and verifies the network  

connection.
3.  
When the connection has been 
verified, the You are connected to the 
Internet. If you have any problems 
using online services, please contact 
your Internet Service Provider.  
message appears.
 
NIf the connection process fails, check 
the LAN port connection.
 
NIf the automatic process cannot find 
the network connection values or  

if you want to set the connection 
manually, go to the next section, 
"Manual Network Setup."
Manual Wired Network Setup You can configure your TV's wired 
network connection manually when 
connecting your TV to a network that 
requires a Static IP address.
 
NTo get the IP address, subnet mask, 
gateway, and DNS values, contact 
your Internet Service Provider (ISP). 

To set up your TV's wired network 
connection manually, follow these 
steps:1.  
Go to the Network Settings screen. 
(Network  
→  Network Settings)
2.  
Select  Start. The network connection 
screen appears and the verification 
process starts.
3.  
Select  Stop. The verification process 
stops. Select IP Settings on network 
connection screen. The IP Settings