Samsung ML 2010 User Manual

							SPECIFICATIONS6.6
Paper Specifications
Paper Output Capacity
CategorySpecifications
Acid Content 5.5 ~ 8.0 pH
Caliper 0.094 ~ 0.18 mm (3.0 ~ 7.0 mils)
Curl in Ream Flat within 5 mm (0.02 in.)
Cut Edge ConditionsCut with sharp blades with no visible 
fray.
Fusing CompatibilityMust not scorch, melt, offset, or release 
hazardous emissions when heated to 
200 °C (392 °F) for 0.1 second.
Grain Long Grain
Moisture Content 4 % ~ 6 % by weight
Smoothness 100 ~ 250 Sheffield
Output TrayCapacity
Face-down output 
tray100 sheets of 75 g/m2 bond (20 lb) 
paper
Downloaded From ManualsPrinter.com Manuals 
						

							SPECIFICATIONS6.7
6
Printer and Paper Storage Environment
Paper storage environmental conditions directly affect the feed 
operation.
Ideally, the printer and paper storage environment should be at 
or near room temperature, and not too dry or humid. Remember 
that paper is hygroscopic; it absorbs and loses moisture rapidly.
Heat works with humidity to damage paper. Heat causes the 
moisture in paper to evaporate, while cold causes it to condense 
on the sheets. Heating systems and air conditioners remove 
most of the humidity from a room. As paper is opened and used, 
it loses moisture, causing streaks and smudging. Humid 
weather or water coolers can cause the humidity to increase in 
a room. As paper is opened and used it absorbs any excess 
moisture, causing light print and dropouts. Also, as paper loses 
and gains moisture it can become distorted. This can cause 
paper jams.
Care should be taken not to purchase more paper than can be 
used in a short time (about 3 months). Paper stored for long 
periods may experience heat and moisture extremes, which can 
cause damage. Planning is important to prevent damage to 
large supplies of paper.
Unopened paper in sealed reams can remain stable for several 
months before use. Opened packages of paper have more 
potential for environment damage, especially if they are not 
wrapped with a moisture-proof barrier.
The paper storage environment should be properly maintained 
to ensure optimum printer performance. The required condition 
is 20° to 24°C (68° to 75°F), with a relative humidity of 45% to 
55%. The following guidelines should be considered when 
evaluating the paper’s storage environment:
• Paper should be stored at or near room temperature.
• The air should not be too dry or too humid.
• The best way to store an opened ream of paper is to rewrap it 
tightly in its moisture-proof wrapping. If the printer 
environment is subject to extremes, unwrap only the amount 
of paper to be used during the day’s operation to prevent 
unwanted moisture changes.
Downloaded From ManualsPrinter.com Manuals 
						

							1
INDEX
C
cancel, print 3.10
card, print 3.9
clean, printer 4.6
connect
power cord
 2.10
USB cable 2.9
control panel, use 1.6
D
demo page, print 2.11
E
envelopes, print 3.8
error, solve 5.17
I
install, toner 2.4
L
labels, print 3.8
load paper 2.7, 3.6
M
Macintosh
common problems
 5.18
O
output tray 3.6
P
paper guidelines 3.3
paper jams, clear 5.6
paper load capacity 3.3
paper load, in tray 2.7, 3.6
preprinted paper, print 3.10
print
demo page
 2.11
printer cable, connect 2.9
printer, clean 4.6
problem
Linux
 5.19
windows 5.18
problem, solving
checklist
 5.2
general 5.3
Macintosh 5.18
paper jams 5.6
Q
quality problem, solve 5.12
S
software
overview
 2.12
system requirements
Windows 2.13
specification
paper
 6.3
printer 6.2
system requirements
Windows
 2.13
T
toner
install
 2.4
life 4.2
redistribute 4.3
replace 4.5
toner save 4.5
Downloaded From ManualsPrinter.com Manuals 
						

							2
transparencies, print 3.9
turn on, printer 2.10
U
unpack 2.2
USB cable, connect 2.9
Downloaded From ManualsPrinter.com Manuals 
						

							Samsung Printer
Software User’s Guide
Downloaded From ManualsPrinter.com Manuals 
						

							1
CONTENTS
Chapter 1: INSTALLING PRINTER SOFTWARE IN WINDOWS
Installing Printer Software  ........................................................................................................  3
Changing the Software Language  ..............................................................................................  4
Reinstalling Printer Software  .....................................................................................................  5
Removing Printer Software  .......................................................................................................  5
Chapter 2: BASIC PRINTING
Printing a Document  ................................................................................................................  6
Printer Settings  .......................................................................................................................  7
Layout Tab  .................................................................................................................... 7
Paper Tab ...................................................................................................................... 8
Graphics Tab  .................................................................................................................  9
Extras Tab  ...................................................................................................................  10
About Tab  ...................................................................................................................  10
Printer Tab  ..................................................................................................................  10
Using a Favorite Setting  ................................................................................................  11
Using Help ...................................................................................................................  11
Chapter 3: ADVANCED PRINTING
Printing Multiple Pages on One Sheet of Paper (N-Up Printing)  .....................................................  12
Printing Posters  .....................................................................................................................  13
Printing Booklets   ..................................................................................................................  13
Printing on Both Sides of Paper (Manual Duplex)  .......................................................................  14
Printing a Reduced or Enlarged Document  ................................................................................  15
Fitting Your Document to a Selected Paper Size  .........................................................................  15
Using Watermarks  .................................................................................................................  16
Using an Existing Watermark  .........................................................................................  16
Creating a Watermark  ...................................................................................................  16
Editing a Watermark  .....................................................................................................  17
Deleting a Watermark  ...................................................................................................  17
Downloaded From ManualsPrinter.com Manuals 
						

							2
Using Overlays  ......................................................................................................................  17
What is an Overlay? ......................................................................................................  17
Creating a New Page Overlay  .........................................................................................  17
Using a Page Overlay  ....................................................................................................  18
Deleting a Page Overlay  ................................................................................................  19
Chapter 4: SHARING THE PRINTER LOCALLY
Setting Up a Host Computer  ...................................................................................................  20
Setting Up a Client Computer  .................................................................................................. 20
Chapter 5: USING STATUS MONITOR
Opening the Troubleshooting Guide  .........................................................................................  21
Changing the Status Monitor Program Settings  ..........................................................................  21
Chapter 6: USING YOUR PRINTER IN LINUX
System Requirements  ............................................................................................................ 22
Installing the Printer Driver .....................................................................................................  23
Changing the Printer Connection Method  .........................................................................  24
Uninstalling the Printer Driver  ........................................................................................  25
Using the Configuration Tool  ................................................................................................... 25
Changing LLPR Properties  ....................................................................................................... 26
Chapter 7: USING YOUR PRINTER WITH A MACINTOSH
Installing Software for Macintosh  ............................................................................................. 27
Setting Up the Printer  ............................................................................................................  28
For a Network-connected Macintosh  ................................................................................  28
For a USB-connected Macintosh  .....................................................................................  28
Printing ................................................................................................................................  28
Printing a Document  .....................................................................................................  28
Changing Printer Settings  ..............................................................................................  29
Printing Multiple Pages on One Sheet of Paper  ..................................................................  30
Downloaded From ManualsPrinter.com Manuals 
						

							Installing Printer Software in Windows
3
1Installing Printer 
Software in Windows
This chapter includes:
• Installing Printer Software
• Changing the Software Language
• Reinstalling Printer Software
•Removing Printer Software
Installing Printer Software
All applications should be closed on your PC before beginning 
installation. 
NOTE: If the “New Hardware Wizard” window appears during 
the installation procedure, click   in the upper right corner of 
the box to close the window, or click Cancel.
1Insert the supplied CD-ROM into your CD-ROM drive.
The CD-ROM should automatically run and an installation 
window appears.
If the installation window does not appear, click 
Start and 
then 
Run. Type X:\Setup.exe, replacing “X” with the 
letter which represents your drive and click 
OK.
NOTE: If your printer is not already connected to the 
computer, the following window will appear.
• After connecting the printer, click 
Next.
• If you don’t want to connect the printer at this time, click 
Next, and No on the following screen. Then the installation 
will start and a test page will not be printed at the end of the 
installation.
• The installation window that appears in this User’s 
Guide may differ depending on the printer and 
interface in use.
Downloaded From ManualsPrinter.com Manuals 
						

							Installing Printer Software in Windows
4
2Choose the type of installation. 
• 
Typical: Installs the most common software for your 
printer. This is recommended for most users.
• 
Custom: Allows you to choose both the language of the 
software and the individual components you want to 
install. After selecting the language and the 
component(s), click 
Next.
• 
View User’s Guide: Allows you to view the User’s 
Guide. If your computer doesn’t have Adobe Acrobat, 
click on this option and it will automatically install Adobe 
Acrobat Reader for you.
3After the installation is finished, a window asking you to 
print a test page appears. If you choose to print a test 
page, select the checkbox and click 
Next.
Otherwise, just click 
Next and skip to step 5.
NOTE: If your printer is not connected to the computer, the 
window asking you to print a test page will not appear. 
4If the test page prints out correctly, click Yes.
If not, click 
No to reprint it.
5To register yourself as a user of Samsung Printers in order 
to receive information from Samsung, select the checkbox 
and click 
Finish. You are now sent to the Samsung web 
site.
Otherwise, just click 
Finish.
NOTE: If your printer driver doesn’t work properly, reinstall 
the printer driver. See “Reinstalling Printer Software” on 
page 5.
Changing the Software 
Language
After installation of the software, you can change the display 
language. 
1Click the Windows Start menu.
2Select Programs or All Programs and then your printer 
driver name
.
3Select Language Selection.
4Select the desired language from the language selection 
window, and click 
OK.
Downloaded From ManualsPrinter.com Manuals 
						

							Installing Printer Software in Windows
5
Reinstalling Printer Software
You can reinstall the software if installation fails.
1Start Windows.
2From the Start menu select Programs or All Programs 
→ your printer driver name → Maintenance.
Or place the CD-ROM into the CD-ROM drive.
3Select Repair.
You will see a component list so that you can reinstall any 
item individually.
NOTE: If your printer is not already connected to the 
computer, the following window will appear.
• After connecting the printer, click 
Next.
• If you don’t want to connect the printer at this time, click 
Next, and No on the following screen. Then the installation 
will start and a test page will not be printed at the end of the 
installation.
• The reinstallation window that appears in this User’s 
Guide may differ depending on the printer and 
interface in use.
4Select the components you want to reinstall and click 
Next.
If you select Printer, the window asking you to print a test 
page appears. Do as follows:
a. To print a test page, select the check box and click 
Next.
b. If the test page prints out correctly, click Yes.
If it doesn’t, click 
No to reprint it.
5When the reinstallation is done, click Finish.
Removing Printer Software
1Start Windows.
2From the Start menu select Programs or All Programs 
→ your printer driver name → Maintenance.
Or place the CD-ROM into the CD-ROM drive.
3Select Remove.
You will see a component list so that you can remove any 
item individually.
4Select the components you want to remove and then click 
Next.
5When your computer asks you to confirm your selection, 
click 
Yes.
The selected driver and all of its components are removed 
from your computer.
6After the software is removed, click Finish.
Downloaded From ManualsPrinter.com Manuals