Samsung Ht Tq22r Instruction Manual

GB
10
STANDBYOPEN/CLOSEVOLUMEFUNCTION
The remote control can be used up to approximately 23 feet/7 meters in a straight line. It can also
be operated at a horizontal angle of up to 30° from the remote control sensor.
Range of Operation of the Remote Control 
PREPARATION
Insert Remote Batteries
Caution
Remove the battery
cover on the back of
the remote by pressing
down and sliding the
cover in the direction of
the arrow.1Insert two 1.5V AAA
batteries, paying
attention to the correct
polarities (+ and...

Rear Speakers
•Place these speakers behind your listening position.
•If there isnt enough room, place these speakers so they face each other.
•Place them about 60 to 90cm (2 to 3feet) above your ear, facing slightly
downward.
*Unlike the front and center speakers, the rear speakers are used to
handle mainly sound effects and sound will not come from them all
the time.
Subwoofer
•The position of the subwoofer is not so critical. 
Place it anywhere you like.
Front Speakers  
•Place these speakers in front...

GB
12
CONNECTIONS
Connecting the Speakers
Black
Press down the terminal
tab on the back of the
speaker. 1Insert the black wire into the
black terminal (–) and the red
wire into the red (+) terminal,
and then release the tab.2Connect the correct color speaker cable
to the same color speaker output terminal
on the rear of the subwoofer, according
to the polarity markings (+/–).
Example: Connect the green center speaker cable
to the green center speaker output
terminal on the rear of the subwoofer
according...

13
Front Speaker (R)
Rear Speaker (R)
Subwoofer Center Speaker
Front Speaker (L)
Rear Speaker (L)
Front Speaker (R)
Rear Speaker (R)
Subwoofer Center Speaker
Front Speaker (L)
Rear Speaker (L)
HT-TQ22
HT-TQ25
Connecting the Speakers
HT-Q20(1~40P) GB  3/1/06 2:40 PM  Page 16
 

GB
14
CONNECTIONS
Front Speaker (R)
Rear Speaker (L)
Subwoofer Center SpeakerFront Speaker (L)
Rear Speaker (R)
TX card
Slanted side faces 
WIRELESS RECEIVER MODULE To connect the rear speakers wirelessly, you have to additionally purchase the wireless receiving module and 
TX card from your Samsung retailer.
Connecting the optional Wireless Receiving Amplifier
When you have purchased the wireless receiving module (SWA-3000)
Connect the front, center and 
subwoofer speakers, referring to page 12.
Insert...

15
WIRELESS RECEIVER MODULE
•When the wireless receiving module setting is complete, no audio signal is output from the Rear Speaker OUT ports on the back
of the main unit.
•The wireless receiving antenna is built into the wireless receiver module. Keep the unit away from water and moisture.
•For optimal listening performance, make sure that the area around the wireless receiver module location is clear of any
obstructions.
•Sound will be heard from the wireless rear speakers in DVD 5.1-CH or Dolby Pro...

GB
METHOD 2   Scart ...............
Better Quality
If you television is equipped with an SCART input, connect an Scart Jack (not supplied) from the
AV OUT jack on the back panel of the system to the SCART IN jack on your television.
METHOD 1   Composite Video ...............
Good Quality
Connect the supplied video cable from the VIDEO OUT jack on the back panel of the
system to the VIDEO IN jack on your television.
METHOD 3   Component (Progressive Scan) Video ...............
Best Quality
If your...

17
Press STOP button.
•If playing a disc, press the STOPbutton twice so that “STOP”, appears on the display.
Press and hold P.SCAN button on the remote control for over 5 seconds.
•Pressing and holding the button for over 5 seconds will select Progressive Scan and Interlace Scan
alternately.
•When you select P.SCAN, P.SCAN will appear on the display.
•To set P.Scan mode for DivX discs, press the P.SCANbutton on the remote control for more than 
5 seconds with no disc in the unit (“NO DISC on the...

GB
18
CONNECTIONS
Connecting External Components
Connect AUX (Audio) In on the Home Theater to Audio Out on the external analog
component.
•Be sure to match connector colors.
1
Press AUXbutton on the remote control to select ‘AUX’ input.
•You can also use the FUNCTIONbutton on the main unit.
The mode switches as follows: DVD/CD 
➝AUX ➝USB ➝FM 
2
Example:   Analog signal components such as a VCR.
Connecting an External Analog Component
Audio Cable
(not supplied)
If the external analog
component has only...

19
•This unit does not receive AM broadcasts.Note
Connecting the FM Antenna
The cooling fan supplies cool air to the unit to  prevent overheating.
Please observe the following cautions for your safety.
•Make sure the unit is well-ventilated. If the unit has poor ventilation, the temperature inside the unit could rise
and may damage it.
•Do not obstruct the cooling fan or ventilation holes. (If the cooling fan or ventilation holes are covered with a
newspaper or cloth, heat may build up inside the unit...