Samsung HL P5063W DLP TV User Manual

1-800-SAMSUNG (1-800-726-7864)
Samsung Electronics America 
Service Division
400 Valley Road, Suite 201
Mount Arlington, NJ 07856
www.samsungusa.com
Samsung Electronics Canada Inc. 
Samsung Customer Care
7037 Financial Drive  
Mississauga, Ontario  
L5N 6R3
www.samsung.ca
BP68-00283A-02
DLPTV
HL-P4663W/HL-P5063W/HL-P5663W/HL-P6163W
DLPTV
This device is a Class B digital apparatus.
INSTRUCTION MANUAL
BP68-00283A-02(cover)  5/6/04  12:15 PM  Page 2 

Special Features ...............................................................................................46
Customizing Your Remote Control ..........................................................................46
Remote Control Codes ..........................................................................................47
Fine Tuning Channels ...........................................................................................48
LNA (Low Noise Amplifier)...

Your New Wide TV
SAMSUNG
BP68-00283A-02(02~13)  5/6/04  11:31 AM  Page 4 

Your New Wide TV
6
• For replacement, you will need a 5.91 Inches-long Phillips screwdriver and a pair of gloves.
Replacing the Lamp•Why do I need to replace the lamp?
The lamp used in a projection TV has a limited lifespan. For the best screen quality it needs to be
replaced periodically. After replacing the lamp, the screen quality will be bright and clear as new.
•When do I need to replace it?
It should be replaced when the screen becomes darker, less clear or when all three LEDs on the front
(Timer,...

9
8
Side Panel ButtonsThe buttons on the right side panel control your TV’s basic features, including the on-screen menu
system. To use the more advanced features, you must use the remote control.
List of FeaturesYour TV was designed and engineered using the latest technology. It is a full-featured, high-performance
unit that exceeds industry standards. In addition, it has these special features:
• Easy-to-operate remote control
• Easy-to-use on-screen menu system you can access from the side panel or...

11
Your New Wide TV
10
Front Panel LED Indicators The three lights on the front panel indicate the status of your TV.
: Light is On
: Light is Blinking
: Light is Off•  It takes about 30 seconds for the TV to warm up, so normal brightness may not appear immediately.
•  The TV has a fan to keep the inside lamp from overheating. You’ll occasionally hear it working.TIMER
Standby state.
The picture will automatically appear in about 15 seconds.
Auto Timer ON/OFF has been set and the set will automatically...

Installing Batteries in the Remote ControlWith normal use, the batteries in the remote control should last about a year. If you notice a performance
degradation while using the remote, the batteries may need to be replaced. Make sure you replace both
batteries and do not mix old and new batteries in the remote control. If you won’t be using the remote
control for a long time, remove the batteries and store them in a cool dry place.1
Slide the back cover all the way out
to open the battery compartment of...

Connections
SAMSUNG
BP68-00283A-02(14~23)  5/6/04  11:30 AM  Page 14 

1617
Connections
Connecting VHF and UHF AntennasIf you do not have a cable system, you will need to connect an antenna to your TV.  Antennas with 300-ohm Flat Twin LeadsIf your antenna looks like this:                           it has 300-ohm flat twin leads.1
Place the wires from the twin
leads under the screws on the
300-75 ohm adaptor (not
supplied). Use a screwdriver
to tighten the screws.
2
Plug the adapter into the
“ANT 1 IN” terminal on the
rear panel. 
Antennas with 75-ohm Round LeadsIf your...

19
Connections
18
Connecting Cable TV and VCRYou can connect different cable systems to your TV, including cable without a cable box, and
cable with a cable box that descrambles some or all channels.Cable without a Cable BoxIf you want to connect cable, and you do not need to use a cable box:1
Plug the incoming cable
into the “ANT 1 IN”
terminal on the rear panel.
Cable with a Cable Box that Descrambles All Channels1
Find the cable that is
connected to the
ANTENNA OUT terminal
on your cable box. This...