Samsung 460ut-b Manual

							 The Add on the same level button is enabled only if at least one group is created. 
3Enter the group name.
Deleting Groups
1Select a group name, and click Edit.
2In the Edit Group window displayed, click Delete.
3Click Yes. The group will be deleted.
Renaming Groups
1Select a group name, and click Edit.
2In the Edit Group window displayed, click Rename.
3If a cursor appears in the old group name, enter a new group name. 
						

							Schedule Management
Creating Schedules
Create and register a schedule on a group basis.
1Click All Schedule List in the schedule section on the left side of the program window. The Add 
button will be enabled in the middle.
2Click the Add button. The Add Schedule window will appear. 
						

							3Click Add below the Device Group item, and select the group you want to add a schedule to.
4Select Date&Time/Action and click OK. The schedule will be added and a list of schedules will 
appear in the set list window.
Device Group: Select a group.
Date&Time
Instant Execution: Run the schedule immediately.
Timer Set the date, time and interval to run the schedule.
Action: Select a function that will activate at the specified time and interval.
Schedule Modification
To modify a schedule, select the schedule and click Edit.
Deleting a Schedule
To delete a schedule, select the schedule and click Delete. 
						

							Troubleshooting Guide
 This program may malfunction sometimes due to a communication problem between the PC and 
display or electromagnetic waves emitted from nearby electronic devices.
 
IssueSolution
The display you want to control 
does not appear on the system 
information chart. 1. Check the connection of the RS232C cable (check that the 
cable is properly connected  to appropriate serial port).
2. Check that another display with a duplicate  ID is not 
connected. Connecting displays with a duplicate  ID can 
cause the displays not  to be shown due to data collision.
3. Check that the display  ID is within the range of 0 and 99. 
(Change the ID using the Display menu.)
 For a display that supports the ID in a range of 0 to 99, 
the ID should be set between 0 and 99.
 
The display you want to control 
does not appear on the other 
Control Info Grids. Check that the display is powered on
. (See the power status in 
the system information chart.)
Ensure you select the input sour ce the display is connected to.
The following message appears 
repeatedly. Check that the display you want to control is selected.
Displays power on or  off at different 
time from one another  even though 
On Time  or Off Time  is set. Adjust the time on the PC to syn
chronize the time between the 
connected displays.
The remote contro l does not work. The remote control ma y not work if the RS-232C cable is 
removed or the program is closed abnormally while the  Remote 
Control  function is  Disable. To resolve this, run the program 
again and set  Remote Control  to Enable . 
						

							How display properties are shown when multiple displays are used
1When no display is selected: The default value is displayed.
2When one display is selected: Settings for the selected display are displayed.
3When two displays are selected (e.g. in sequence of ID 1 andID 3): The settings for ID 1 are 
displayed before the settings for ID 3.
4When the All+Select checkbox is checked and all displays are selected: The default settings are 
displayed.