Ryobi 4 Cycle Trimmer Owners Manual
Here you can view all the pages of manual Ryobi 4 Cycle Trimmer Owners Manual. The Ryobi manuals for Trimmer are available online for free. You can easily download all the documents as PDF.
Page 21
MAINTENANCE AND REPAIR INSTRUCTIONS 21 CARBURETOR ADJUSTMENT The idle speed of the engine is adjustable. An idle adjustment screw is reached though a hole in the top of the engine cover (Fig 37). NOTE:Careless adjustments can seriously damage your unit. An authorized service dealer should make carburetor adjustments. Check Fuel Old fuel is usually the main reason for the unit not running properly. Drain and refill the tank with clean, fresh unleaded fuel prior to doing any adjustments. Refer to Oil and...
Page 22
MAINTENANCE AND REPAIR INSTRUCTIONS 22 4. Disconnect the spark plug wire. 5. Clean dirt from around the spark plug. Remove the spark plug from the cylinder head by turning a 5/8 in. socket counterclockwise. 6. Remove the engine cover (Fig. 39). 7. Clean dirt from around the rocker arm cover. Remove the screw holding the rocker arm cover with a large flat blade screwdriver or Torx T25 bit (Fig. 41). Remove the rocker arm cover and gasket. 3. Remove the screw behind the engine cover (Fig. 40). Remove...
Page 23
MAINTENANCE AND REPAIR INSTRUCTIONS 23 10. If the clearance is not within specification: a. Turn the adjusting nut using a 5/16 inch (8 mm) wrench or nut driver (Fig. 42). •To increase clearance, turn the adjusting nut counterclockwise. •To decrease clearance, turn the adjusting nut clockwise. b. Recheck both clearances, and adjust as necessary. 11. Reinstall the rocker arm cover using a new gasket. Torque the screw to 20–30 in •lb (2.2–3.4 N•m). NOTE:A rocker arm cover gasket, Part # 182099 can be...
Page 24
MAINTENANCE AND REPAIR INSTRUCTIONS 24 ACCESSORIES/REPLACEMENT PARTS 4-Cycle Oil . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 181786 Oil Fill Plug / Dipstick . . . . . . . . . . . . . . . . . . . . . 182378 Spark Plug . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 180852 Spark Arrestor Screen . . . . . . . . . . . . . . . . . . . . . 180890 Replacement Line Cartridge . . . . . . . . . . . . . . . . 181460 Inner Reel Spring . . . . . . . . . . . . . . . . . . . . . . . ....
Page 25
CLEANING AND STORAGE 25 LONG TERM STORAGE If the unit will be stored for an extended time, 1. Drain all gasoline from the gas tank into a container . Do not use gas that has been stored for more than 60 days. Dispose of the old gasoline in accordance to Federal, State, and Local regulations. 2. Start the engine and allow it to run until it stalls. This ensures that all gasoline has been drained from the carburetor. 3. Allow the engine to cool. Remove the spark plug and put 1 oz. (30 ml) of high quality...
Page 26
TROUBLESHOOTING 26 CAUSE ACTION Oil in cutting head Clean the cutting attachment If further assistance is required, contact your authorized service dealer. CAUSE ACTION Cutting head bound with grass Stop the engine and clean cutting attachment Cutting head out of line Refill with new line Inner reel bound up Replace the inner reel Cutting head dirty Clean inner reel and outer spool Line welded Disassemble, remove the welded section and rewind the line Line twisted when refilled Disassemble and rewind...
Page 27
SPECIFICATIONS 27 ENGINE Engine Type . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Air-Cooled, 4-Cycle Displacement . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.6 cu. in. (26.2 cc) Clutch Type . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ....
Page 29
29 The California Air Resources Board and Ryobi Outdoor Products (ROP), are pleased to explain the emission control system warranty on your 2000 and later small off-road engine. In California, new small off-road engines must be designed, built and equipped to meet the States stringent anti-smog standards. ROP must warrant the emission control system on your small off-road engine for the periods of time listed below provided there has been no abuse, neglect or improper maintenance of your small off-road...
Page 30
ALL IMPLIED WARRANTIES ARE LIMITED IN DURATION TO THE TWO (2) YEAR WARRANTY PERIOD OR NINETY (90) DAYS FOR PRODUCTS USED FOR ANY COMMERCIAL PURPOSE. ACCORDINGLY, ANY SUCH IMPLIED WARRANTIES INCLUDING MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, OR OTHERWISE, ARE DISCLAIMED IN THEIR ENTIRETY AFTER THE EXPIRATION OF THE APPROPRIATE TWO-YEAR OR NINETY DAY WARRANTY PERIOD. RYOBI’S OBLIGATION UNDER THIS WARRANTY, IS STRICTLY AND EXCLUSIVELY LIMITED TO THE REPAIR OR REPLACEMENT OF DEFECTIVE PARTS,...