Runco Vx 22i Projector User Manual

							Runco VX-22i Installation/Operation Manual 67 
PREL
IMINARY
7.1 
VX-22i Specifications
Table 7-1 lists the VX-22i specifications.  
7Specifications
Table 7-1. VX-22i Specifications 
Projector Type:Digital Light Processing (DLP), 3-chip, 16:9 DMD
Native Resolution:1920 x 1080 (16:9)
Aspect Ratios: 4:3, Letterbox, 16:9, VirtualWide, Cinema, Virtual Cinema
Video Standards:NTSC, NTSC 4.43, PAL B/G/H/I/M/N , SECAM
DTV Compatibility:480i/576i, 480p, 576p, 1080i 50/60, 720p 50/60,1080p 
24/50/60, 1080psf
Scan Frequency:Horizontal: 15 - 100 kHz 
Vertical: 28 - 78 Hz
Picture Size (16:9 Screen):Recommended Width: 72 - 120 in. 
Maximum Width: 250 in.
Throw Distance 
(Factor x Screen Width):Refer to Table 3-3
Horizontal and Vertical 
Offset:Refer to Table 3-4
Lamp:300W UHP
Estimated Lamp Life: 2000 hours
Inputs: (1) Composite
(1) S-Video
(1) HD Video, R (Pr), G (Y), B (Pb), H, V - RCA connectors
(1) HD Video/Computer, R (Pr), G (Y), B (Pb), H, V - BNCs
(1) HD Video/Computer, R (Pr), G (Y), B (Pb), H, V -  
    15-pin D-Sub connector
(2) HDMI with HDCP
Trigger Outputs: (3) +12 VDC, each rated at 750 mA and thermal 
fuse-protected
Control Options:- Discrete infrared remote
- Serial commands via RS-232 interface
- Built-in keypad on rear panel
RS-232 Communication 
Parameters: 19200 bps, no parity, 8 data bits, 1 stop bit, no flow control 
						

							68 Runco VX-22i Installation/Operation Manual
PREL
IMINARY
Brightness and Contrast: Cinema Standards Measurement System (CSMS) 
Specifications
- Brightness: 58.7 foot-Lamberts (fL) 
- Contrast Ratio: 321:1 
These measurements are taken from the projector in a controlled, 
home theater environment. All measurements are made to 
ANSI/NAPM IT7.228-1997 specifications using the Photo Research 
PR-650 SpectraColorimeter and Minolta LS-100 Luminance Meter, 
Video Essentials test DVD and a 1.3 gain, 72-inch wide screen. The 
projector is calibrated to a color temperature of 6,500K and has a 
minimum of 150 hours of usage.
The foot-Lambert (fL) is the unit of measurement used in commercial 
movie theaters to express image brightness at the screen surface. The 
Society of Motion Picture and Television Engineers (SMPTE) specifies 
16 fL as the target image brightness for film-based projectors using an 
open gate (without film in the projector). More importantly, today 
SMPTE specifies 12 fL as the target image brightness in Digital 
Cinema theaters. The foot-Lambert measurement is dependent on 
screen size, screen gain and projector light output.
Home Theater Calibration Specifications
- Light Output: 1391 ANSI Lumens
- Contrast Ratio: 321:1
These specifications are obtained by calibrating the projector as 
described above for CSMS measurements. 
Industry-Standard Specifications
- Light Output: 2850 ANSI Lumens
- Contrast Ratio: 4000:1
These are typical projector brightness and contrast specifications 
found in most companies’ sales literature. Runco includes these 
measurements in its literature to allow for direct comparison with other 
manufacturers’ projectors. These measurements are typically taken at 
9,000K to 13,000K to get expected performance data when the 
projector is used in professional, commercial and industrial displays.
Power Requirements: 100 to 240 VAC (auto-sensing), 50/60 Hz, 530 Watts 
(1808.9
 BTUs/hour)
Operating Environment:41°F to 95°F (5°C to 35°C), 0% to 90% humidity 
(non-condensing) 
Dimensions:See Figure 7-1
Weight (without lens):99.21 lbs. (45.00 kg)
Regulatory Approvals:Complies with FCC Class B, CE, C-Tick, GOST, TUV-GS, 
cTUV-US
Limited Warranty: Projector: Two (2) years parts and labor from the date of 
delivery to the end user.
Lamp: 1000 hours or six (6) months, whichever comes first. 
Specifications are subject to change without notice. 
Table 7-1. VX-22i Specifications (continued) 
						

							Runco VX-22i Installation/Operation Manual 69 
PREL
IMINARY
7.2 
VX-22i Dimensions
Figure 7-1 shows the VX-22i dimensions (all dimensions are in inches). 
Figure 7-1. VX-22i/CineWide with AutoScope Dimensions
8.39
10.07 4.2314.18 10.04 6.47
0
7.23
11.48
15.73
29.29 10.83
0
3.91
16.26 10.08
10.2329.77
20.8136.23 
						

							70 Runco VX-22i Installation/Operation Manual
PREL
IMINARY
7.3 
Supported Timings
Table 7-2 lists the signal types supported by each input on the VX-22i.
Table 7-2. Supported Signal Timings by Input 
FormatResolutionRefresh 
Rate (Hz)Horizontal 
Frequency 
(kHz)Pixel Frequency 
(MHz)
Supported? (√ = Yes, – = No)
HD 1/HD 2/HD 3HDMI 1
HDMI 2
Composite
S-VideoRGBHVComponent
640x480640x480
60.0031.46925.175√–√–
72.0037.86131.500√–√–
75.0037.50031.500√–√–
85.0043.26936.000√–√–
800x600800x600
60.0037.87940.000√–√–
72.0048.07750.000√–√–
75.0046.87549.500√–√–
85.0053.67456.250√–√–
1024x7681024x768
60.0048.36365.000√–√–
70.0056.47675.000√–√–
75.0060.02378.750√–√–
85.0068.67794.500√–√–
1152x8641152x86475.0067.500108.000√–√–
1280x7681280x768
60.0047.39668.250√–√–
60.0047.77679.500√–√–
75.0060.289102.250√–√–
85.0068.633117.500√–√–
1280x9601280x96060.0060.000108.000√–√–
85.0085.938148.500√–√–
1280x10241280x1024
60.0063.981108.000√–√–
75.0079.976135.000√–√–
85.0091.146157.500√–√–
1360x7681360x76860.0047.71285.500√–√–
1400x10501400x1050
60.0064.744101.000√–√–
60.0065.317121.750√–√–
75.0082.278156.000√–√–
1600x12001600x120060.0075.000162.000√–√–
1920x12001920x120060.0074.038154.000√–√– 
						

							Runco VX-22i Installation/Operation Manual 71 
PREL
IMINARY
480/60i720x48759.9415.73413.500√√√√
480/60p720x48359.9431.46927.000√√√–
576/50i720x57650.0015.62514.750√√√√
576/50p720x57650.0031.25029.000√√√–
720/50p1280x72050.0037.50075.250√√√–
720/60p1280x72060.0045.00074.250√√√–
1080/50i1920x108050.0028.125/31.25074.250/72.000√√√–
1080/60i1920x108059.94/60.0033.716/33.75074.175/74.250√√√–
1080/24p1920x108023.98/24.0026.978/27.00074.175/74.250√√√–
1080/50p1920x108050.0056.250148.500√√√–
1080/60p1920x108059.94/60.0067.433/67.500148.350/148.500√√√–
NTSC 3.58–59.94/60.0015.734/15.7503.580√√√√
NTSC 4.43–59.94/60.0015.734/15.7504.430√√√√
PAL-B/G–50.0015.6254.430√√√√
PAL-M–59.94/60.0015.734/15.7503.580√√√√
PAL-N–50.0015.6253.580√√√√
PAL-60–59.94/60.0015.734/15.7504.430√√√√
SECAM–50.0013.5004.250/4.410–––√
Table 7-2. Supported Signal Timings by Input (continued)
Format ResolutionRefresh 
Rate (Hz)Horizontal 
Frequency 
(kHz)Pixel Frequency 
(MHz)Supported? (√ = Yes, – = No)
HD 1/HD 2/HD 3
HDMI 1
HDMI 2Composite
S-Video
RGBHV Component 
						

							72 Runco VX-22i Installation/Operation Manual
PREL
IMINARY
Notes: 
						

							Runco CL-810 Owner’s Operating Manual
S
www.runco.com
SERIAL NUMBER
020-0838-00 rev. A
November 2007