Runco Cl 410 Projector User Manual

OW N E R’S  OP E R A T I N G  MA N U A L
CL-410
DLP™ Projector 

2
Table of Contents
Limited Warranty ............................................................................3
Preface  ............................................................................................
6
Warnings  .............................................................................................................7
Product Disposal  ..................................................................................................
7
Introduction...

3
TWO YEAR LIMITED WARRANTY
For Projectors, Video Processors and Controllers
Congratulations  on  your  purchase  of  a  Runco  video  product  and  welcome  to  the  Runco  family!  We  believe 
Runco  produces  “The  World’s  Finest  Home  Theater  Products”.  With  proper  installation,  setup  and  care,  you 
should enjoy many years of unparalleled video performance.
This  is  a  LIMITED WARRANTY  as  defined  in  the  Magnuson-Moss  Warranty  Act.  Please  read  it  carefully  and 
retain it with...

4
Runco  limits  its  obligations  under  any  implied  warranties  under  state  laws  to  a  period  not  to  exceed  the  warranty 
period. There are no express warranties. Runco also excludes any obligation on its part for incidental or consequential 
damages related to the failure of this product to function properly. Some states do not allow limitations on how long 
an  implied  warranty  lasts,  and  some  states  do  not  allow  the  exclusion  or  limitation  of  incidental  or  consequential...

5
ADDITIONAL INFORMATION:
To locate the name and address of the nearest Runco Authorized Service Center, or for additional information about 
this Limited Warranty, please call or write:
RUNCO INTERNATIONAL, INC. 
Attn: Customer Service Department 2900 Faber Street
Union City, CA 94587 Ph: (510) 324-7777
Fax: (510) 324-9300
Toll Free: (800) 23-RUNCO
RUNCO VIDEO PRODUCT INFORMATION
 
RETAIN THIS INFORMATION FOR YOUR RECORDS
                               
Model Purchased                Date...

ABOUT THIS MANUAL
This manual is designed for use with the CL-410 Projector. Information in this document 
has been carefully checked for accuracy; however, no guarantee is given to the 
correctness of the contents. The information in this document is subject to change 
without notice.
COPYRIGHT
© Copyright 2005 Runco International
This document contains proprietary information protected by copyright. All rights are 
reserved. No part of this manual may be reproduced by any mechanical, electronic or...

7

WARNING! To meet FCC requirements, a shielded power cord is required 
in order to prevent interference. It is essential that only the supplied power 
cord is to be used. Use only shielded cables to connect I/O devices to this 
equipment. You are cautioned that changes or modifications not approved 
by the party responsible for compliance could void your authority to operate 
the equipment.
WARNING!  The projector cooling fan continues to run for approximately 
90 seconds after the projector is turned...

8

Introduction
W ith the Reflection CL-410, Runco brings its famous video performance to a new 
level of affordability, putting Runco quality within reach of many aspiring home theater 
aficionados. 
By combining a highly efficient optical light engine with broad installation and integration 
options, the CL-410 establishes the perfect balance between performance and 
affordability. 
Runco has implemented a host of advancements into the projector’s light engine to 
take full advantage of its...

9

Introduction
Projector  
(Front and Top View)Focus ring 
Adjusts focus
Lens shift dial
 
(Horizontal)
Shifts image right 
and left
Temperature  indicatorIndicates
overheating Power indicator
Blue LED for standby Remote control
 
sensor
Exhaust vent Adjustment feet
Raises or lowersZoom ring
Enlarges or 
reduces
display size
Lens shift dial (Vertical)
Shifts image up 
 
and down
Remote control  sensor
Intake vent 

10

Projector 
(Rear and Side View)
Introduction
AC socket
Input: 100 - 240V
3.5A, 50/60Hz
Component 1 Input
Inputs for component YPbPr / YCbCr.
RS-232 terminal
Component 2 Input
Inputs for component
YPbPr / YCbCr
RGB HD Input
Input for computer VGA
DVI / Computer Input
Input for connecting to 
Digital Video Interface
Lamp cover
Exhaust vent
WARNING!  As the projector lamp becomes extremely hot, air blowing out 
from the ventilation slots can also be uncomfortably hot.
S-Video Input
Input for connecting...