Roland FJ 540 User Manual

29
2. Basic Operation
This describes the sequence of basic operations from switching on
the power to performing printing.
Downloaded From ManualsPrinter.com Manuals 

30Chapter 2 - Basic Operation
2-1 Switching the Power On and Off
Switching On the Power
Leave the main power switch turned on, and use the
[POWER] key to switch the power on and off in day-to-
day use.
Points to Keep in Mind When Switching the Power On and Off
Do not switch off the main power while the sub power is switched on. The printing heads may be left uncapped (that is, the
printing carriage may remain over the platen). If the machine is allow to stand to with the printing heads uncapped for a...

31Chapter 2 - Basic Operation
2-1 Switching the Power On and Off
Switching Off the Power at the End of the Day
Press and hold down the [POWER] key for one second or
longer to switch off the sub power.The POWER LED goes out
Leave the pinch rollers raised when not in use.
Deformation may occur if left lowered for a prolonged period.
Raise
Downloaded From ManualsPrinter.com Manuals 

32Chapter 2 - Basic Operation
2-2 Loading Media
Loading Roll Media
1Open the front cover.
2Line up with the core diameter of the loaded roll media and refit the left- and right-hand media flanges.
3Fit the hole on the left side of the roll media all the way onto the left-hand media flange.
Be sure to install the media guide when loading roll media.
Otherwise the roll may fall and cause injury.
Load roll media at the proper position.
Otherwise the roll may fall, resulting in injury.
1) 2)
3) 4)2 in.
3...

33Chapter 2 - Basic Operation
2-2 Loading Media
4Fit the right-hand media flange all the way into the hole on the right-hand side of the roll media, and
tighten the retainer screw to secure in place.
5Move the media clamps to the two ends of the platen.
6Pass the end of the media from the back of the
machine to the front.
Pull out the media until the sensor is hidden
from view.
7Grasp the center of the end of the media at the
front of the machine, and slowly pull the media
out straight to the position...

34Chapter 2 - Basic Operation
2-2 Loading Media
8Slowly turn the media flanges at the back of the machine to pull back the media to the position shown
in the figure.
When you roll back the media until the sensor comes into view, a tight seal is formed between the media and the platen, and
the media is stretched taut.
9With the media pulled out from the roll stretched
taut with no slack, move the sheet loading le-
ver toward LOAD.
The pinch rollers lower to hold the media in place.
10Close the front...