Ricoh Projector PJ WUL6280 User Manual

							11
About the batteries
Explains things that you should follow in regard to the batteries.
 WARNING
  For safe operation, follow the warnings below regarding the batteries used in 
the remote control. If you use the batteries incorrectly, it may result in fire or 
injury due to batteries leaking or exploding.
  Do not use batteries other than the ones specified.
  Do not mix and use batteries that are different types or that are new and 
old.
  Correctly insert batteries according to the polarity (+/-).
  Do not charge non-rechargeable batteries.
  Do not heat or throw the batteries into fire or water.
  Do not connect the positive and negative terminals on a battery with a 
wire.
  Remove the batteries from the remote control that are past their sug-
gested use period or that are depleted.
  Remove the batteries when they will not be used for extended periods.
  Keep the batteries out of the reach of children. Children may swallow or 
choke on the batteries. If this happens, contact a doctor immediately.
 WARNING
  What to do if a battery has leaked
  If leakage from a battery adheres to your skin, rinse it with water immedi-
ately, and then contact a doctor.
  Wipe off the leakage with tissue paper while being careful not to touch it.
  Soak the tissue paper that you used in water, and then throw it away as 
burnable trash. 
						

							12
About the Laser light source
Explains things that you should follow in regard to the laser light source.
 WARNING
  Do not look into the lens or vent when the product is on. The bright light may 
damage your eyes. Be especially careful in an environment with children.
CAUTION
  This projector has built-in laser module. Possibly hazardous optical rad\
iation 
emitted from this product. Do not stare into the beam. May be harmful to\
 the 
eyes.
 CAUTION
  Use of controls or adjustments or performance of procedures other than 
those specified herein may result in hazardous radiation exposure.
 CAUTION
  Do not block the projection light when it is on. If you do so, the part that is 
blocking the projection light may get quite hot and deform, deteriorate or 
cause a burn or fire. The reflected light may make the lens hot and cause a 
product failure. To temporarily suspend projection, select the mute function. 
To suspend longer, turn off the product.
Moving
This section explains safety precautions about moving the machine.
 CAUTION
  Unplug the power cord from the wall outlet before you move the machine. 
While moving the machine, take care that the power cord is not damaged 
under the machine. Failing to take these precautions could result in fire or 
electric shock. 
						

							13
Other Information
Copyrights to Images
When projecting images using the projector, be careful not to infringe the copyright 
of protected materials.
The following are examples that may infringe the copyright of protected materials.
•  Broadcasting images or movies for commercial purposes
•  Modifying images or movies using functions such as freeze, magnify , or zoom to 
broadcast images for commercial pur poses or public viewing
•  Varying the aspect ratio of images or movies using a function that changes the 
screen size to broadcast images for com  mercial purposes or public viewing 
						

							14
Safety Labels of This Machine
Positions of WARNING and CAUTION labels
This machine has labels for  WARNING and  CAUTION at the positions shown be-
low. For safety, please follow the instructions and handle the machine as indicated.
Main unit
1
5
2
3
46
1
Do not look into the lens when the product is on. The bright light may damage your 
eyes.
Do not place anything in front of the lens. The object may become very hot and 
cause a fire or burn. To blank the image temporarily, turn on the mute function.
2
Do not put your face or hand near the exhaust vents. Doing so could result in burns 
or an accident due to hot air coming from the exhaust vents. 
						

							15
3
4
5 Notice: User in USA
6 Notice: Users in USA
6 Notice: Users in EU countries and Japan and China
Power Switch Symbols
The meanings of the symbols for the switches on this machine are as follows:
   : STANDBY 
						

							16
Laws and Regulations
User Information on Electrical and Electronic Equipment
If you wish to discard this product, please contact your local authorities, the shop where you bought this product, your local dealer or sales/service representatives. 
						

							17
Regulation & Safety Notices
This appendix lists the general notices of your Projector. 
Notice: Users in the United States of America
FCC notice 
MODEL NAME: RICOH PJ WUL6280/ RICOH PJ WXL6280
NOTE: This equipment has been tested and found to comply with the 
limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. 
These limits are designed to provide reasonable protection against harmful 
interference when the equipment is operated in a commercial environment. 
This equipment generates, uses, and can radiate radio frequency energy 
and, if not installed and used in accordance with the instruction manual, 
may cause harmful interferenceto radio communications. Operation of this 
equipment in a residential area is likely to cause harmful interference \
in 
which case the user will be required to correct the interference at his own 
expense.
CAUTION: Changes or modifications not expressly approved by the party 
responsible for compliance could void the user’s authority to operate the 
equipment. 
						

							18
Notice: Shielded cables 
All connections to other computing devices must be made using 
shielded cables to maintain compliance with FCC regulations. 
Caution 
Changes or modifications not expressly approved by the manu-
facturer could void the user’s authority, which is granted by the 
Federal Communications Commission, to operate this projector. 
Notes to Users in the State of California
Perchlorate Material - special handling may apply, See www.dtsc.ca.gov/
hazardouswaste/perchlorate. 
WARNING: Handling the cord on this product will expose you to lead, 
a chemical known to the State of California to cause cancer, and birth 
defects or other reproductive harm. Wash hands after handling. 
						

							19
Declaration of Conformity for EU countries 
▀■  EMC Directive 2004/108/EC (including amendments) 
▀■  Low Voltage Directive 2006/95/EC
WARNING: This is a Class A product. In a domestic environment this 
product may cause radio interference in which case the user may be 
required to take adequate measures.
Notice: Users in EU countries 
CE Marking Traceability Information (For EU 
Countries Only)
Manufacturer:Ricoh Co., Ltd.3-6 Nakamagome 1-chome, Ohta-ku, Tokyo. 143-8555, Japan
Importer:Ricoh Europe PLC20 Triton Street, London. NW1 3BF, United Kingdom
User Information on Electrical and Electronic 
Equipment
Users in the countries where this symbol shown in this section has been 
specified in national law on collection and treatment of E-waste.
Our Products contain high quality components and are designed to facilitate recy-cling.Our products or product packaging are marked with the symbol below .
This product contains substances which are harmful to humans and the environ-
ment. 
						

							20
Notice: Users in Turkey
All Other Users
If you wish to discard this product, please contact your local authorities, the shop 
where you bought this product, your local dealer or sales/service representatives.
Laser Notice
• This Product is classified as Class 3R of IEC60825-1:2007 and also complies with 21 CFR 1040.10 and 1040.11 except for  deviations pursuant to Laser Notice No.50, dated June 24,2007. (For USA)• IEC 60825-1:2014: CLASS 1 LASER PRODUCT - RISK GROUP 2. (For EU coun-tries and Japan and China)
Laser source specification
3.5W laser diode x 38 
Wavelength: 440-455nm
Pulse duration: 1.08ms
Laser emissionport