Ricoh Aficio MP 1500 User Manual

Removing Toner
55
5 Removing Toner
 1: Open the front cover of the machine.
 2: Lift the green lever.
 3: Push the green lever, and then gently 
pull out the holder.
 4: Press the toner bottle back to raise its top, 
and then gently pull it out.
Downloaded From ManualsPrinter.com Manuals 

Troubleshooting
56
5Inserting Toner
 1: Hold the new bottle horizontally and 
shake it from side to side five or six times.
2: Remove the black cap.
Note
❒Do not remove the black cap before 
shaking.
❒Do not remove the inner cap.
 3: Put the toner bottle on the holder, and 
then pull its top forward.
 4: Push in the green lever until it clicks.
 5: Press down the green lever.
 6: Close the machines front cover.
Downloaded From ManualsPrinter.com Manuals 

x Clearing Misfeeds
57
5 x Clearing Misfeeds
R CAUTION:
Important
❒When clearing misfeeds, do not turn off the power switch. If you do, your
copy settings are cleared.
❒To prevent misfeeds, do not leave any torn scraps of paper inside the ma-
chine.
❒If paper misfeeds occur repeatedly, contact your service representative.
Note
❒More than one misfeed area may be indicated. If this is the case, check every
applicable area. Refer to the following charts: A, B, P, R, Y, Z.
❒You can find a sticker explaining...

Troubleshooting
58
5
Downloaded From ManualsPrinter.com Manuals 

Changing the Paper Size
59
5 Changing the Paper Size
Preparation
Be sure to select the paper size
with User Tools and the paper size
selector. If you do not, misfeeds
might occur. See p.38 “Tray Paper
Size: Tray 1”.
Reference
For details about paper sizes and
types, see p.78 “Copy Paper”.
Changing the Paper Size of the 
Paper Tray
AMake sure the paper tray is not in
use.
BPull the paper tray out slowly un-
til it stops.
Note
❒Remove any remaining copy
paper.
CWhile pressing the release lever,
adjust the...

Troubleshooting
60
5
EWhile pressing the release lever,
adjust the side fences.
FPush the metal plate down.
GSquare the paper and set it in the
tray.
Important
❒Be sure to set the paper under
the roller.
❒Do not stack paper over the lim-
it mark.
HWhile pressing the release lever,
adjust the side and back fences to
the new paper size.
Important
❒When setting small quantities of
copy paper, be careful not to
squeeze in the side fence too
much or paper will not feed in
properly.
IPress down the lock...

61
6. Other Functions
Other Functions
Displaying the Total Counter
You can display the total counter val-
ue used for all functions.
APress the {User Tools/Counter} key.
BSelect [Counter] using {U} or {T},
and then press the {OK} key.
CTo print the counter list, press
[Print].
Note
❒To print the counter list, set the
paper size to larger than A4 or
8
1/2 × 11.
DPress the {Start} key.
A counter list prints out.
EPress the {User Tools/Counter} key.
Changing the Language
You can change the language used on...

Other Functions
62
6
Downloaded From ManualsPrinter.com Manuals 

63
7. Remarks
Dos and Donts
R CAUTION:
Important
❒Do not turn the power off while
the On indicator is lit or blinking.
Doing so may damage the memo-
ry.
❒Before unplugging the power cord
or turning off the main power
switch, make sure remaining
memory space is at 100%, as
shown on the display. See p.16
“Turning Off the Power” and p.16
“Turning Off the Main Power”.
 When you use this machine for a
long time in a confined space with-
out good ventilation, you may de-
tect an odd smell. To keep the...

Remarks
64
7Where to Put Your Machine
Machine Environment
Choose your machines location care-
fully. Environmental conditions
greatly affect its performance.
Optimum environmental conditions
R CAUTION:
R CAUTION:
 Temperature: 10-32 °C (50-89.6 °F)
(humidity to be 54% at 32 °C, 89.6 °F)
 Humidity: 15-80% (temperature to
be 27 °C, 80.6 °F at 80%)
 A strong and level base.
 The machine must be level within
5 mm, 0.2 inches: both front to rear,
and left to right.
 To avoid possible buildup of
ozone, be...