Quasar Room Air Conditioner Hq2052uh Installation And Operating Instructions

INSTALLATION AND OPERATING INSTRUCTIONS
Room Air Conditioner
Model: HQ-2052UH
Please read these operating instructions thoroughly
before using your air conditioner and keep for future
reference.
For assistance, please call: 1-800-211-PANA(7262) or 
Register your product at : http://www.panasonic.com/register
CW382820391E 

About the Controls on the Air Conditioner
Features and Installation
Before you call for service...2
Safety Precautions
FOR YOUR RECORDS
Write the model and serial numbers here:
Model #
Serial #
You can find them on a label on the side of the unit.
Dealers Name
Date Purchased
Staple your receipt here for proof of purchase.
Inside you will find many helpful hints on how to use and
maintain your air conditioner properly. Just a little preventive
care on your part can save you a great deal of time and
money...

WARNING
3
Safety PrecautionsSafety Precautions
To prevent injury to the user or other people and property damage, the following instructions must be followed:
Incorrect operation will cause harm or damage. The seriousness is classified by the following indications.
Because of the weight of the product, it is recommended that you have a helper to assist in the installation.
Use Caution! Sharp Edges! See Warning, page 4.
WA R N I N G:This symbol indicates the possibility of death or serious injury....

Sharp edges
When the air filter is to be
removed, do not touch the
metal parts of the unit.
•They are sharp and may cause
an injury.
Do not clean the air
conditioner with water.
•Water may enter the unit and
degrade the insulation. It may
causeanelectricshock.
Whentheunitistobe
cleaned, switch the unit off,
and unplug it.
•Since the fan rotates at high
speed during operation, it may
cause an injury.
Do not operate the unit
without the air filter or when
the front intake grille has
been removed.
•It could...

5
About the Controls on the Air Conditioner
About the Controls on the air conditioner
The controls will look like the following.
Controls
TEMPERATURE SETTING
MODE
ECONOMY,  FAN and DRY.
• Every time you push this button it is set as follows.
  {High(F2)  Low(F1)  High(F2)...}.is
DRY
• When this unit is in dry mode, the fan rotates at low speed.  
The fan stops when the compressor stops cooling.
Approximately every 3 minutes the fan will turn on and the 
unit checks the room air temperature to set...

6
About the Controls on the Air Conditioner
Remote controller
Precaution:The Remote Controller will not function properly if strong light strikes the sensor window of the
air conditioner or if there are obstacles between the Remote Controller and the air conditioner.
1.Remove the cover from the back of the remote
controller
2.Insert two batteries.
•Be sure that the (+) and (-) directions are correct.
•Be sure that both batteries are new.
3.Re-attach the cover.•Do not use rechargeable
batteries. Such...

7
About the Controls on the Air Conditioner
TURN THE AIR CONDITIONER OFF AND REMOVE THE PLUG FROM THE POWER OUTLET.
• TO CLEAN FILTER
The air filter will become dirty as it removes
dust from the inside air.
It should be washed at least every 2 weeks.
If the air filter remains full of dust, the air
flow will decrease and the cooling capacity
will be reduced, possibly damaging the unit.
1. Pull the inlet grille forward and pull out the
air filter. (Fig. 1)
2. Wash the air filter in warm 104°F(40°C) water....

8
Features and Installation
1
85
3
2
67
9
4
10
Wire netGroove
Learning parts name prior to installation will help you understand the installation procedure.
Features
1. CABINET
2. HORIZONTAL AIR DEFLECTOR
3. COOL AIR DISCHARGE
4. FRONT GRILLE
5. INLET GRILLE6. AIR FILTER
7. CONTROL BOARD
8. AIR INTAKE
9. UPPER GUIDE
10. REMOTE CONTROLLER
How to install wire net on the back side of the cabinet
(Optional : CW353020031B)
Insert the rear grill wire ends into the 4 respective slots provided along the groove...

9
Features and Installation
OUTDOORS INDOORSINNER
SILL
OUTER
SILL
INNER
SILL WOOD STRIP MOUNTED
ON TOP OF INNER SILL1
WOOD STRIP
FOR 
L BRACKET
3/4
CLEARANCE
STORM
WINDOW
FRAME
OUTDOORS INDOORS
OUTER
SILL
TYPE B: Qty:5
(WOOD SCREW)
HARDWARE
TYPE A: Qty:11
(SHORT SCREW)TYPE C: Qty:3
(L BRACKET)
TYPE E: Qty:1
(SASH SEAL)
(Not adhesive backed)
TYPE D: Qty:1
(SEAL STRIP)
(Adhesive backed)
TYPE F: Qty:2
(GUIDE PANEL)TYPE G: Qty:1
(SUPPORT BRACKET)
25/64
(10mm)
5/8
(16mm)
DRAIN PIPE
Qty:1
NOTE: All supporting...

10
Features and Installation
ROOM SIDE
CENTER LINE
INNER SILL
SEAL STRIP
(TYPE D)
CENTER LINE
OUTSIDEINSIDE
L BRACKET OUTER SILLINNER SILL
TYPE A
8
8CENTER LINE
SEAL WINDOW FRAME
BOTTOM
GUIDE
ABOUT 1/4
L BRACKET UPPER GUIDE
TYPE A
TYPE A
A. BEFORE INSTALLATION
1. Insert the guide panels into the guides of the air
conditioner. Fasten the curtains to the unit with
screws (TYPE A), as shown Fig. 6.
2. Cut the adhesive-backed seal strip (TYPE D) to the
window width.
Remove the backing from the seal strip and...