Proxima Projector Dp2810 User Manual

UserÕs Guide  ¥  3Ð1 Chapter 3  ¥  Using the Desktop Projector
This chapter provides detailed information on the Desktop
Projector settings, the Control Panel keys, the Menu windows,
and the warning indicators.
The following figure shows the Control Panel:
BrightnessSync
Volume
VideoMenu/Lamp
OVERTEMPREPLACE LAMP
Figure 3-1
Desktop Projector Control Panel
Arrow Keys
The four arrow keys allow you to:
¥ Make small adjustments to the position of the projected
image. The image shifts in the direction...

3Ð2  ¥  UserÕs Guide Chapter 3  ¥  Using the Desktop Projector
BRIGHTNESS Keys
The BRIGHTNESS keys increase and decrease the intensity level
of the projected image. Press the top key to increase brightness
and the bottom key to decrease it.
LAMP Key
The LAMP key toggles the projection lamp on and off.
¥ If you turn the lamp off but leave the projector on, the fan
will continue to run.
¥ You can turn the projector off without allowing the fan to
cool down the unit. However, the projector will take a...

UserÕs Guide  ¥  3Ð3 Chapter 3  ¥  Using the Desktop Projector
Note:  Press the MENU key twice in rapid succession to:
¥ Go directly to the Setup Menu, or
¥ Exit the Menu Window from the Levels Menu.
Hold down the MENU key for several seconds to calibrate
Cyclops. For more information, refer to the Cyclops UserÕs Guide.
Note: You cannot use Cyclops and ProximaÕs Presentation
Control Software at the same time. To disable Cyclops and use
the software, hold the MENU key on the Control Panel down
when you...

3Ð4  ¥  UserÕs Guide Chapter 3  ¥  Using the Desktop Projector
VOLUME Keys
The VOLUME keys are used to adjust the audio level of the
projectorÕs internal speakers. Press the Up or Down key to
increase or decrease the speakersÕ audio level.
The Menu window displays the current settings for the Desktop
Projector. To display the Menu window in the lower portion of
the projected image:
1. Press the MENU key on the Control Panel or the remote
control to display the Levels Menu.
2. Press the MENU key a second...

UserÕs Guide  ¥  3Ð5 Chapter 3  ¥  Using the Desktop Projector
Press the MENU key once to display the Levels Menu. From
here, you can change the levels for the projectorÕs image and audio
controls. The menus vary according to the current video source.
BRIGHTNESS
SYNC
VOLUME
RED
GREENBLUE
Figure 3-2
Levels Menu for computer video
BRIGHTNESS
R     TINT     G
SIG LEVELVOLUME
Figure 3-3
Levels Menu for NTSC/PAL/SECAM and SÐVHS video
BRIGHTNESS
Adjust this setting to increase and decrease the image intensity....

3Ð6  ¥  UserÕs Guide Chapter 3  ¥  Using the Desktop Projector
VOLUME
Use this setting to adjust the volume. Use the up or down arrow
key to increase or decrease the volume level.
Note:  For optimal sound control when using an external
amplifier (such as a stereo system), preset the VOLUME setting
to 50% (5 bars) before adjusting the volume on the amplifier to a
comfortable listening level.
RGB Controls: RED, GREEN & BLUE
The RED, GREEN and BLUE controls are used to individually
adjust the color signals....

UserÕs Guide  ¥  3Ð7 Chapter 3  ¥  Using the Desktop Projector
To access the Setup Menu, do either of the following:
¥ Push the MENU key to access the Levels Menu. Press the
MENU key again to access the Setup Menu, or
¥ Press the MENU key twice to skip the first window and go
directly to the Setup Menu.
SOURCEIMAGECOLORSPROJECTION
FREQUENCYLANGUAGESTORE?SETTINGSVGA640x480NORMAL226981FORWARD
8 0 0 ENGLISH NOFACTORY
Figure 3-4
Setup Menu
SOURCE
SOURCE is both a status and selection box. When you connect a...

3Ð8  ¥  UserÕs Guide Chapter 3  ¥  Using the Desktop Projector
The projector can store a full set of values for each video mode.
This allows you to switch between video inputs and retain your
adjusted settings. When the projector starts up, it automatically
returns to the last-stored entries for each video mode.
Note:  If you would like to add video to audio-enabled models,
you can order the Video Adapter Kit; see Appendix B for ordering
information.
IMAGE
This control allows you to switch between NORMAL...

UserÕs Guide  ¥  3Ð9 Chapter 3  ¥  Using the Desktop Projector
Color
ModeDescription Primary Use
8 Typically results
in lower color
resolution but
brighter imageText screens
3,375 Best for
VGA/Macintosh
business
graphics or
other
applications
requiring bright,
high contrast
colorsComputer video
226,981*Best for complex
computer
graphicsGraphics, animation or
NTSC/PAL/SECAM/S-VHS
2M* For NTSC, PAL,
SECAM or S -
VHS videoNTSC/PAL/SECAM/S-VHS
* Not available in EGA/CGA/MDA/Hercules computer video mode....

3Ð10  ¥  UserÕs Guide Chapter 3  ¥  Using the Desktop Projector
LANGUAGE
LANGUAGE allows you to select the language for the Menu
Window. You can choose between English, German, Italian,
French and Spanish. Use the Up or Down arrow key to cycle
through the choices.
STORE?
This function lets you save the current settings in both menus.
The saved settings will be used until you either define new settings
or return to the factory-configured defaults. If you change the
settings but donÕt store them, they will...