Philips Projector HDP1550 User Manual

US
Screeneo
User Manual
Register your product and get support at
www.philips.com/welcome
HDP1550
HDP1590
LU UST_EN_US.book  Page 1  Jeudi, 11. décembre 2014  9:03 09 

2Philips · HDP15x0
Table of Contents
Overview ................................................... 3
Dear Customer  ................................................................... 3About this User Manual ..................................................... 3What's in the Box  ............................................................... 3Product Highlights  .............................................................. 3
1 General Safety Information ................ 4
Setting up the Device...

   3
Over view
Dear Customer
Thank you for purchasing our projector.
We hope you enjoy your device and its many functions!
About this User Manual
With the installation guide on the following pages, you 
can start using your device quickly and easily. Detailed 
descriptions can be found in the following sections of 
this user manual.
Read the entire user manual carefully. Follow all safety 
instructions in order to ensure proper operation of 
your device. The manufacturer accepts no liability if 
these...

4Philips · HDP15x0
1 General Safety Information
Do not make any changes or settings that are not 
described in this user manual. Physical injury or damage 
to the device or loss of data can result from improper 
handling. Take note of all warning and safety notes indi
-cated.
Setting up the Device
The unit is for indoor use only. The device should be 
placed securely on a stable, flat surface. Position all 
cables in such a way that no one will stumble on them, 
thus avoiding possible injuries to persons...

  General Safety Information 5
Power Supply
Before turning on your device, check that the outlet 
that you are going to plug it into conforms to the indi-cations shown on the information plate (voltage, cur-rent, power network frequency) located on your 
device. This device shall be connected to a single phase 
power network. The device shall not be installed on 
bare ground.
Only use the power cable that is supplied with your 
device. Your device is delivered with a grounded power 
cord. It is...

6Philips · HDP15x0
2Overview
Front View
1 Control panel for navigation and operation
u – To display the home menu
¿ – One menu step back, one directory level back 
/ cancelling a function
//À/Á – Navigation keys / navigate the 
menu / modify settings
 – Confirms selection
B– Long press: Power on /off the projector  Short press: ECO mode on / off
2 Ï – Audio output – headphone connection or con-nection for external speakers
3 	 3– HDMI port for a playback device
4 
 – Memory card slot
5 ý – USB...

  Overview 7
Remote Control
1 Long press: Power off the projector. To power the 
projector on use the B key on the control panel. Short press: ECO mode on / off
2 Playback keys
 – Skip backward (music only)
 – To stop playback
 – Skip forward (music only)
 – To rewind
 – To start / pause playback
 – To fast-forward
3 3D – To display the 3D menu.
4 To display the home menu.
5 TAB key for browsing the Internet without exter-nal keyboard.
6 Navigation keys
 – Confirms selection
/, À/Á – Navigation keys...

8Philips · HDP15x0
Browsing the user interface
Navigation for setting menu 
Navigation can be done by navigation keys (,, 
À,Á, OK and ¿) on the control panel or the re-mote control, as well as by an air mouse.
Navigation by keys:•/ scrolls trough the menu level up and 
down. 
•OK/Á goes one level down, with À / ¿ one 
level up.
•u goes back to the main screen.• In the final level,  accepts a setting and goes 
back to the last sub menu.
• The ¿ key aborts a setting and goes back to the 
last sub...

  Overview 9
Symbols in the Statusbar
1 – Time
2 – Date
3 – LAN status display
4 – Bluetooth status display
5 – WiFi status display
ab dce
LU UST_EN_US.book  Page 9  Jeudi, 11. décembre 2014  9:03 09 

10Philips · HDP15x0
3 Initial Operation
Setting up the Device
Before installing your device, make sure that the 
projector is turned off and the power cord is 
unplugged from the power outlet.
You can position the device so that it lies flat on a table 
in front of the projection surface; it is not necessary to 
tilt it towards the projection surface. The device com
-pensates for the distortion from the slanted projection 
(pincushion distortion).
Check that the projection surface is appropriated to the...