Philips Lx700 User Manual

11
English
Basic Functions
Selecting the surround mode
IMPORTANT!
–For proper surround sound, make sure you have
followed the “Connections” and “Preparations”
procedures fully.
–The center and surround speakers only operate
when the system is set to surround sound mode and
the source material being played is recorded or
broadcast in Dolby Digital, DTS, Dolby Pro Logic or
Pro Logic II surround sound.
–Stereo broadcasts or recordings will produce some
surround channel effects when played in a surround...

12
English
Volume Control
Changing the volume level
●Adjust VOLUME button (or press VOL +/-) to increase or
decrease the volume level.
➜ “VOL XX” is displayed.
➜ “VOL MAX” is displayed if volume is at maximum level.
●Press SUBW +/- to adjust the level of the subwoofer
speaker volume.
➜ “SUBW XXDB” is displayed.
➜ The range is from -15dB to 10dB.
●Press REAR +/- to adjust the level of the surround speakers
volume.
➜ “REAR XXDB” is displayed.
➜ The range is from -15dB to 10dB.
●Press CENTER +/- to adjust...

13
English
Others Functions
System Setup
The system setup enables you to customize the Receiver. You
can adjust the following features:
Center Delay
–If the listening position is closer to the center speaker
than the front speakers, you can set the center delay time to
improve the center sound effect.
–Options : 5ms, 3ms, 2ms, 1ms, OFF.
Rear Delay
–If the listening position is closer to the rear surround
speakers than the front speaker s, you can set the rear delay
time to improve the rear sound effect....

14
English
Tuning to radio stations
–In TUNER mode, press S or T  briefly and
repeatedly until the right frequency or optimum reception is
obtained.
–Press S or T  more than 1 second if you want to
activate automatic search tuning. Tuning automatically stops
when a station of sufficient strength has been found.
–Press TUNER again to select the desired band : FM or
MW.
Presetting radio stations
You can preset up to 40 stations .
1Tune to your desired radio station by pressing the S or
T button on the...

15
English
Troubleshooting
WARNING!
Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty.  Do
not open the system as there is a risk of electric shock.
If a fault occurs, first check the points listed below before taking the system for repair. If you are unable to
solve a problem by following these hints, consult your dealer or service center.
Problem Solution
No power.–Check the connection to the AC power cord.
No sound or distorted sound–Check the...

16
English
Specifications
 AMPLIFIER SECTION
Output power
Stereo mode (DIN) ........................................................................\
.......... 2 x 50 W
Surround mode (1 kHz) ...........................................  50W RMS / channel
T otal Harmonic Distor tion ...................10% at rated power (1 kHz)
Frequency Response .........................................180Hz ~ 14 kHz / ±1 dB
Signal-to-Noise Ratio ................................................................ >65 dB...