Philips Cclear Xg1air Brilliance Projector User Manual

>
Switch off and disconnect the projector before cleaning.
1Press the Standby button twiceto switch off the projector.
– The Standby indicator star ts blinking orange.
2Wait until the cooling fan has stopped (about 3 minutes after the projector has been put in
Standby) and disconnect the mains lead and all other cables.
Cleaning the cabinet
•When the cabinet is dusty, clean it by gently wiping with a soft cloth.
•A chamois leather slightly moistened with water is sufficient for cleaning the housing.
•Do...

>
When operation time reaches the last 100 hours of the average lamplife, the message ‘Warning:
lamplife has almost expired’ will be displayed on the screen, each time the projector is switched
on. The lamp indicator lights up orange.
The lamplife remaining can be checked using the OSD menu.
1Press Menu.
– The menu bar appears on the screen.
2Use Cursor Control to move the cursor to ‘Settings’.
3Use Cursor Control to select ‘Lamp counter’.
– The remaining lamplife hours are displayed in the action windo...

<
•Always use the same type of lamp: See ‘Optional accessories’ for the correct type of lamp
for your projector.
•Do not touch lamp or point lamp housing opening at anyone.
•Do not drop, as the impact may cause the lamp to break.
8Place the lamp holder in the guiding slots and inser t into the lamp compar tment.
9Tighten screw B again.
10Put the lamp door back in place and press tab A back in its original position.
– The Mains inlet socket will open again.
11Inser t the mains lead into both the projector...

>
If a fault occurs, first check the points listed below before taking the projector for repair.
If you are unable to solve a problem by following these hints, consult your dealer or ser vice
organisation.
Under no circumstances should you tr y to repair the projector yourself as this could invalidate the
guarantee.
– Possible cause
•Solution
General
– Mains lead is not correctly connected.
•Correctly connect mains lead.
– The filter holder is not installed correctly or is damaged.
•Install the filter...

>
In Data mode
– Input resolution is too high (and keystoning is applied).
•If you wish to keep the keystone correction, decrease the input resolution until the image is
correctly displayed. For this, refer to the User Guide or suppor t information of the
computer.
•If you wish to keep the input resolution as it is, decrease keystoning until the image is
correctly displayed. For this, use ‘Keystone correction’ option in the ‘Settings’ menu.
– Input resolution is too high (and no keystoning is applied)....

– Distance is too large.
•Reduce distance.
– Batteries are exhausted.
•Replace batteries (see ‘Inser ting the batteries in the remote control’).
– IR sensor is obstructed.
•Remove obstacle.
Lamp indicator
– green: normal lamp condition.
– orange: lamp life has almost expired (less than 100 hours to go).
•See warning messages on the star t up screen for details.
– red: lamp life has expired.
•Replace lamp. See ‘Maintenance’.
– red (fast blinking): lamp star t has failed.
•Disconnect projector from the...

General:
•Check that the batteries have been installed properly in the remote control and/or replace
the batteries.
•Check that the projector receives the signals from the remote control.
•Check that the USB cable or PS/2 cable has been properly connected.
•Check that both projector and computer are switched on.
•Unplug the USB cable or PS/2 cable and then reconnect.
In case of PS/2 connection:
– The PS/2 mouse of the connected laptop has priority over the projector mouse loop through
connection....