Philips Bcool Sv1 Projector User Manual

Turn off and disconnect the projector before cleaning.
1Press the Standby button twiceto turn off the projector.
–The Standby indicator light turns red.
2Wait until the cooling fan has stopped (about 1 minute after the projector has been put in
Standby) and disconnect the mains lead and all other cables.
Cleaning the cabinet
•When the cabinet is dusty, clean it by gently wiping with a soft cloth.
•A chamois leather slightly moistened with water is sufficient for cleaning the housing.
•Do not use cleaning...

>
When operation time reaches the last 100 hours of the average lamplife, the message ‘Lamp life
has almost exceeded’will be displayed on the screen. When operation time reaches 1500 hours,
the message ‘Lamplife has exceeded’will be displayed.
The lamplife remaining can be checked using the OSD menu.
1Press Menu.
2Use Cursor Control to move the cursor to ‘Setup’.
3Use Cursor Control to select ‘Lamp counter’.
1Turn off the projector and wait until the lamp has cooled down before disconnecting the...

>
1Press Menu.
–The menu bar appears on the screen.
2Use Cursor Control to select ‘Setup’in the menu bar.
3Use Cursor Control to select ‘Lamp counter’in the sub menu.
4Press OK to reset the lamp counter.
5If required, select another item you wish to adjust or press Menu to exit.Resetting the lamplife
time
Philips Multimedia Projector33English User guide bCool SV1
6. Maintenance
Temp.OK
Menu
Source Auto Image
LampTemp.OK
Menu
Source Auto Image
Lamp 

>
If a fault occurs, first check the points listed below before taking the projector for repair.
If you are unable to correct a problem by following these hints, consult your dealer or ser vice
center.
Under no circumstances should you tr y to repair the projector yourself as this could void your
warranty.
– Possible cause
•Solution
General
– Mains lead is not correctly connected.
•Check the mains lead connection.
– Lamp holder cover is not closed correctly or the lamp holder is damaged.
•Check cover for...

>
•Adjust ‘Brightness’,‘Contrast or ‘Colour tracking’(see ’Picture adjustment’under ‘Operation’-
‘On Screen Display Menu’).
•Reset all projector settings in the ‘Setup’menu (‘Factor y settings’).
– Image is not focused.
•Adjust focus ring.
– Distance between projector and screen is not correct.
•Adjust the distance between the projector and the screen.
– Signal cable is not correctly connected.
•Check signal cable connection.
– Signal cable is not correctly connected.
•Check signal cable connection.
–...

– ’Childlock’ active.
•Switch off ‘Childlock’in the ‘Features’menu.
•Check proper installation of the batteries in the remote control and/or replace the batteries.
•Check the projector to make sure it is receiving signal from the remote control.
•Check that the USB cable has been properly connected.
•Check that both projector and computer are turned on.
•Unplug the USB cable and then reconnect.
•Connect another USB device (mouse, scanner, webcam, etc.) and see if it works.
If it does not work, there is a...