Philips 32pfl5604 User Manual

							28
   
 
 
 
 
TV channel issues
 
 
 
Previously installed channels do not appear in 
the channel list:
   
Check that the correct channel list is 
selected.
   
 
 
No digital channels were found during the 
installation:
   
Check that the T V suppor ts DVB -T or 
DVB -C in your countr y. See the listed 
countries on the back of the T V.
   
 
 
 
 
Picture issues
 
 
 
The TV is on, but there is no picture:
   
Check that the antenna is properly 
connected to the TV.
   
Check that the correct device is selected 
as the T V source.
   
 
 
There is sound but no picture:
   
Check that the picture settings are 
correctly set.
   
 
 
There is poor TV reception from an antenna 
connection:
   
Check that the antenna is properly 
connected to the TV.
   
Loud speakers, unear thed audio devices, 
neon lights, high buildings and other large 
objects can in uence reception quality. 
If possible, tr y to improve the reception 
quality by changing the antenna direction 
or moving devices away from the T V.
   
If reception on only one channel is poor, 
 ne tune this channel.
   
 
 
There is poor picture quality from connected 
devices:
   
Check that the devices are connected 
properly.
   
Check that the picture settings are 
correctly set. 
   
 
 
The TV did not save your picture settings:
   
 
 
Check that the T V location is set to the 
home setting. This mode offers you the 
 exibility to change and save settings. •
•
•
•
•
•
•
•
•
•
•
   
 
 
 
 
 
9 Troubleshooting
 
 
This section describes commonly encountered 
issues and accompanying solutions.
   
 
 
General TV  issues
 
 
 
The TV does not switch on:
   
Disconnect the power cable from the 
power outlet. Wait for one minute then 
reconnect it.
   
Check that the power cable is securely 
connected.
   
 
 
The remote control is not working properly:
   
Check that the remote control batteries 
are correctly inser ted according to the 
+/- orientation.
   
Replace the remote control batteries if 
they are  at or weak.
   
Clean the remote control and T V sensor 
lens.
   
 
 
The standby light on the TV blinks red:
   
Disconnect the power cable from the 
power outlet. Wait until the T V cools 
down before reconnecting the power 
cable. If the blinking reoccurs, contact 
Philips Consumer Care. 
   
 
 
You forgot the code to unlock the child lock 
feature
   
Enter ‘0711’.
   
 
 
The TV menu is in the wrong language
   
Change the TV menu to your preferred 
language.
   
 
 
When turning the TV on/off/to standby, you 
hear a creaking sound from the TV chassis:
   
No action is required. The creaking sound 
is normal expansion and contraction of 
the T V as it cools and warms up. This 
does not impact per formance. •
•
•
•
•
•
•
•
•
EN
 
						

							29
audio cable is connected to  AUDIO L/R 
 
or  AUDIO IN 
 (mini-jack only).
 
 
 
 
 
 
Computer connection issues
 
 
 
The computer display on the TV is not stable:
   
Check that a suppor ted resolution and 
refresh rate is selected on the computer.
   
Set the T V picture format to unscaled.
 
 
 
 
 
 
Contact us
 
 
 
If you cannot resolve your problem, refer to 
the FAQs for this T V at w w w.philips.com/
suppor t. 
   
If the problem remains unresolved, contact 
Philips Consumer Care in your country as 
listed in this user manua.
  Warning
 
Do not at tempt to repair the T V yourself. This 
may cause severe injur y, irreparable damage to 
your T V or void your warranty.•
  Note
 
Make a note of your T V model and serial 
number before you contact Philips. These 
numbers are printed on the back of the T V 
and on the packaging.•
•
•
   
 
 
 
 
The picture does not  t the screen; it is too 
big or too small:
   
Tr y using a different picture format.
   
 
 
The picture position is incorrect:
   
Picture signals from some devices may 
not  t the screen correctly. Check the 
signal output of the device.
   
 
 
 
 
Sound issues
 
 
 
There is picture but no sound from the TV:
 
Note
 
If no audio signal is detected, the T V 
automatically switches the audio output off 
— this does not indicate malfunction.•
   
Check that all cables are properly 
connected.
   
Check that the volume is not set to 0.
   
Check that the sound is not muted.
   
 
 
There is picture but sound quality is poor:
   
Check that the sound settings are 
correctly set.
   
 
 
There is picture but sound comes from one 
speaker only:
   
Verify that sound balance is set to the 
center.
   
 
 
 
 
HDMI connection issues
 
 
 
There are problems with HDMI devices:
   
Note that HDCP suppor t can delay the 
time taken for a T V to display content 
from a HDMI device. 
   
If the T V does not recognize the HDMI 
device and no picture is displayed, tr y 
switching the source from one device to 
another and back again.
   
If there are intermittent sound 
disruptions, check that output settings 
from the HDMI device are correct.
   
If a HDMI-to-DVI adaptor or HDMI to 
DVI cable is used, check that an additional  •
•
•
•
•
•
•
•
•
•
•
English
EN
 
						

							30
   
Factory settings  18 
   
Favorite list 
   
select  12 
   
set up   12 
 
 
 
 
H
 
 
HDMI cable 
   
troubleshooting  29 
   
Home mode  18 
 
 
 
 
I
 
 
Installation 
   
automatic  19 
   
manual  19 
 
 
 
 
L
 
 
Language 
   
troubleshooting  28 
   
Location  18 
 
 
 
 
M
 
 
Menu 
   
language  28 
   
main menu    
  9 
   
troubleshooting  28 
   
Multimedia 
   
technical speci cations   26 
   
Music 
   
USB  16 
   
with slideshow   16 
 
 
 
 
P
 
 
Picture format 
   
troubleshooting  28 
   
Picture settings  9 
   
PIN code  28 
   
Power  
28 
 
 
 
 
R
 
 
Reception  28 
   
Remote control 
   
over view   
  5 
   
technical speci cations   26 
 
 
 
 
 
 
 
10 Index
 
 
 
B
 
 
Batteries   4 ,  29 
   
Bracket  27 
 
 
 
 
C
 
 
Channel list 
   
favorite  12 
   
troubleshooting  28 
   
update  12 
   
Channels 
   
favorite list   12 
   
install 
   
automatic  19 
   
manual  19 
   
rearrange  20 
   
rename  19 
   
Clock  14 
   
Computer format 
   
technical speci cations   26 
   
Connections 
   
HDMI 
   
troubleshooting  29 
   
mains cord   21 
   
technical speci cations   26 
   
troubleshooting  
29 
 
 
 
 
D
 
 
Demo  18 
   
Display 
   
resolution  26 
   
screen saver   17 
 
 
 
 
E
 
 
EasyLink 
   
disable  24 
   
enable  24 
   
Environmental care  
4 
 
 
 
 
F
EN
 
						

							31
   
upload a picture from   17 
   
view photos   15 
 
 
 
 
V
 
 
Video format 
   
video format technical speci cations   26 
   
Volume 
   
adjust  
8 
 
 
 
 
W
 
 
Wallpaper  17 
   
     
troubleshooting  
28 
 
 
 
 
S
 
 
Screen saver  17 
   
Settings assistant  9 
   
Sleep timer  13  
   
Slideshow 
   
with music   16 
   
Smart settings  10 ,  11  
   
Software 
   
update 
   
analog  18 
   
version  17 
   
Sound settings  11 ,  11  
   
Standby 
   
troubleshooting  
28 
 
 
 
 
T
 
 
Technical specifcations  26 
   
Timer 
   
on timer   13  
   
sleeptimer  13  
   
standby  13  
   
Transmission 
   
troubleshooting  28 
   
Troubleshooting  28 
   
TV 
   
adjust volume   8 
   
menu   9 
   
software  17 
   
standby  7 
   
switch channels   7 
   
switch off   7 
   
switch on   7 
   
troubleshooting  28 
   
tuner technical speci cations   26 
   
wall mount    27 
   
TV lock 
   
lock channels   14 
   
lock connected devices   14 
   
PIN code   
28 
 
 
 
 
U
 
 
USB 
   
listen to music   16 
English
EN
 
						

							© 2009 Koninklijke Philips Electronics N.V.
All rights reserved.
Document order number:  72-PNS000-X781A