Philips 190sw9f User Manual

							
3FHVMBUPSZ
*OGPSNBUJPO
RETURN TO TOP OF THE PAGE
North Europe (Nordic Countries) InformationPlacering/Ventilation 
VARNING: 
FÖRSÄKRA DIG OM ATT HUVUDBRYTARE OCH UTTAG ÄR LÄTÅTKOMLIG\
A, NÄR 
DU STÄLLER DIN UTRUSTNING PÅPLATS. 


Placering/Ventilation 
ADVARSEL: 
SØRG VED PLACERINGEN FOR, AT NETLEDNINGENS STIK OG STIKKONTAKT 
ER NEMT TILGÆNGELIGE. 


Paikka/Ilmankierto 
VAROITUS: 
SIJOITA LAITE SITEN, ETTÄ VERKKOJOHTO VOIDAAN TARVITTAESSA HELPOSTI 
IRROTTAA PISTORASIASTA. 


 
						

							
3FHVMBUPSZ
*OGPSNBUJPO


Plassering/Ventilasjon 
ADVARSEL: 
NÅR DETTE UTSTYRET PLASSERES, MÅ DU PASSE PÅ AT KONTAKTENE FOR \
STØMTILFØRSEL ER LETTE Å NÅ. 
RETURN TO TOP OF THE PAGE
BSMI Notice (Taiwan Only)


RETURN TO TOP OF THE PAGE
Ergonomie Hinweis (nur Deutschland)
Der von uns gelieferte Farbmonitor entspricht den in der Verordnung ü\
ber den Schutz vor Schäden durch 
Röntgenstrahlen festgelegten Vorschriften. 
Auf der Rückwand des Gerätes befindet sich ein Aufkleber, der auf \
die Unbedenklichkeit der Inbetriebnahme 
hinweist, da die Vorschriften über die Bauart von Störstrahlern na\
ch Anlage III ¤ 5 Abs. 4 der 
Röntgenverordnung erfüllt sind. 
Damit Ihr Monitor immer den in der Zulassung geforderten Werten entspric\
ht, ist darauf zu achten, daß 


Reparaturen nur durch Fachpersonal durchgeführt werden. 

nur original-Ersatzteile verwendet werden. 


bei Ersatz der Bildröhre nur eine bauartgleiche eingebaut wird.

Aus ergonomischen Gründen wird empfohlen, die Grundfarben Blau und Ro\
t nicht auf dunklem 
Untergrund zu verwenden (schlechte Lesbarkeit und erhöhte Augenbelas\
tung bei zu geringem 
Zeichenkontrast wären die Folge). 
Der arbeitsplatzbezogene Schalldruckpegel nach DIN 45 635 beträgt 70d\
B (A) oder weniger. 
ACHTUNG: BEIM AUFSTELLEN DIESES GERÄTES DARAUF ACHTEN, DAß 
NETZSTECKER UND NETZKABELANSCHLUß LEICHT ZUGÄNGLICH SIND. RETURN TO TOP OF THE PAGE
End-of-Life Disposal 


 
						

							
3FHVMBUPSZ
*OGPSNBUJPO
Your new monitor contains materials that can be recycled and reused. Spe\
cialized companies can recycle your 
product to increase the amount of reusable materials and to minimize the\
 amount to be disposed of. 
Please find out about the local regulations on how to dispose of your ol\
d monitor from your local Philips dealer. 
(For customers in Canada and U.S.A.) 
This product may contain lead and/or mercury. Dispose of in accordance t\
o local-state and federal regulations. 
For additional information on recycling contact www.eia.org (Consumer Education Initiative)RETURN TO TOP OF THE PAGE
Information for UK only

 WARNING - THIS APPLIANCE MUST BE GROUNDING.
Important: 
This apparatus is supplied with an approved moulded 13A 
plug. To change a fuse in this type of plug proceed as 
follows: 
1. Remove fuse cover and fuse. 
2. Fit new fuse which should be a BS 1362 5A,A.S.T.A. or 
BSI approved type. 
3. Refit the fuse cover. 
If the fitted plug is not suitable for your socket outlets, it 
should be cut off and an appropriate 3-pin plug fitted in its 
place. 
If the mains plug contains a fuse, this should have a value 
of 5A. If a plug without a fuse is used, the fuse at the 
distribution board should not be greater than 5A. 
Note: The severed plug must be destroyed to avoid a 
possible shock hazard should it be inserted into a 13A 
socket elsewhere. 
How to connect a plug 
The wires in the mains lead are coloured in accordance 
with the following code: 
BLUE - NEUTRAL (N) 
BROWN - LIVE (L) 
GREEN & YELLOW - GROUND (G) 






 
						

							
3FHVMBUPSZ
*OGPSNBUJPO
1. The GREEN AND YELLOW wire must be connected to 
the terminal in the plug which is marked with the letter G 
or by the Ground symbol 
 or coloured GREEN or GREEN 
AND YELLOW. 
2. The BLUE wire must be connected to the terminal which 
is marked with the letter N or coloured BLACK. 
3. The BROWN wire must be connected to the terminal 
which marked with the letter L or coloured RED. 
Before replacing the plug cover, make certain that the cord 
grip is clamped over the sheath of the lead - not simply 
over the three wires. 


RETURN TO TOP OF THE PAGE

China RoHS
The Peoples Republic of China released a regulation called Management \
Methods for Controlling Pollution by 
Electronic Information Products or commonly referred to as China RoHS. \
All products including CRT and LCD 
monitor which are produced and sold for China market have to meet China \
RoHS request.



 
						

							
3FHVMBUPSZ
*OGPSNBUJPO
RETURN TO TOP OF THE PAGE
Safety Information: Electric, Magnetic and Electromagnetic Fields (“EMF”) 


Philips Royal Electronics manufactures and sells many products targeted \
at consumers, which, like any 
electronic apparatus, in general have the ability to emit and receive el\
ectro magnetic signals.




One of Philips leading Business Principles is to take all necessary hea\
lth and safety measures for our 
products, to comply with all applicable legal requirements and to stay w\
ell within the EMF standards 
applicable at the time of producing the products. 


Philips is committed to develop, produce and market products that cause \
no adverse health effects.



Philips confirms that if its products are handled properly for their int\
ended use, they are safe to use 
according to scientific evidence available today. 


Philips plays an active role in the development of international EMF and\
 safety standards, enabling 
Philips to anticipate further developments in standardization for early \
integration in its products.


RETURN TO TOP OF THE PAGE

 
 

 





 
						

							
0UIFS
3FMBUFE
*OGPSNBUJPO






 

 






•  Safety and Troubleshooting

• FAQs

• Troubleshooting

• Regulatory Information

•Information  
for Users in the U.S

•Information  
for Users Outside the U.S





 


 


 
 



Other Related Information
Information for Users in the U. S.
For units set at 115 V : 
Use a UL Listed Cord Set consisting of a minimum 18 AWG, Type SVT or SJT\
 three conductor cord 
a maximum of 15-feet long and a parallel blade, grounding type attachmen\
t plug rated 15 A, 125 V. 
For units set at 230 V: 
Use a UL Listed Cord Set consisting of a minimum 18 AWG, Type SVT or SJT\
 three conductor cord 
a maximum of 15-feet long and a tandem blade, grounding type attachment \
plug rated 15 A, 250 V. 
Information for Users outside the U.S.
For units set at 230 V: 
Use a Cord Set consisting of a minimum 18 AWG cord and grounding type at\
tachment plug rated 
15 A, 250 V. The Cord Set should have the appropriate safety approvals f\
or the country in which 
the equipment will be installed and / or be marked HAR. 


RETURN TO TOP OF THE PAGE
 


 



 





 

 


GJMF)]0&.
.0%&-41IJMJQT
$%
./6-48
&%648
&%6MDENBOVBM&/(-*4)4TBGFUZTBG@PUIFSIUN
 
						

							
CPVU
5IJT
.BOVBM






 

 





•  About This Guide

• Notational Descriptions





 


 


 




About This Manual
About This Guide
This electronic users guide is intended for anyone who uses the Philips\
 LCD Monitor. It 
describes the LCD monitors features, setup, operation and other importa\
nt information. Its 
contents are identical to the information in our printed version.
It includes the following sections:
µ




Safety and Troubleshooting Information provides tips and solutions for common problems 
as well as other related information you may need.


µ




About This Electronic Users Manual gives an overview of information inc\
luded, along with 
notation icon descriptions and other documentation for your reference.


µ




Product Information gives an overview of the monitors features as well as the technical 
specifications for this monitor.


µ




Installing Your Monitor describes the initial setup process and gives an overview of how to 
use the monitor. 
µ




On-Screen Display provides information on adjusting the settings on your monitor. 
µ




Customer Care and Warranty contains a list of worldwide Philips Consumer Information 
Centers along with help desk phone numbers and information on the warran\
ty applicable 
to your product.


µ




Glossary defines technical terms.

µ




Download and Print Option transfers this entire manual to your hard drive for easy 
reference.




RETURN TO TOP OF THE PAGE


Notational Descriptions
The following subsections describe notational conventions used in this d\
ocument. 
Notes, Cautions and Warnings

 





j¹
> 
						

							
CPVU
5IJT
.BOVBM
Throughout this guide, blocks of text may be accompanied by an icon and \
printed in bold or italic 
type. These blocks contain notes, cautions or warnings. They are used as\
 follows:
NOTE: This icon indicates important information and tips that help you m\
ake 
better use of your computer system.
CAUTION: This icon indicates information that tells you how to avoid eit\
her 
potential damage to hardware or loss of data.
WARNING: This icon indicates the potential for bodily harm and tells you\
 how 
to avoid the problem.


Some warnings may appear in alternate formats and may not be accompanied\
 by an icon. In 
such cases, the specific presentation of the warning is mandated by the \
relevant regulatory 
authority.


RETURN TO TOP OF THE PAGE
©2008 Koninklijke Philips Electronics NV
All rights reserved. Reproduction, copying, use, modification, hiring, r\
enting, public performance, transmission and/or 
broadcasting in whole or in part is prohibited without written consent o\
f Philips Electronics NV









 

 



j¹
> 
						

							
1SPEVDU
*OGPSNBUJPO






 

 




•Your LCD Monitor 
•  Smartimage
• SmartContrast
• SmartSaturate
• SmartSharpness 
• Lead-free Product
• Technical Specifications
• Resolution & Preset Modes
• Philips Pixel Defect Policy
• Automatic Power Saving
• Physical Specification
• Pin Assignment
• Product Views
• Physical Function
• SmartManage & SmartControl 
II 

Product Information 
Your LCD monitor 
Congratulations on your purchase and welcome to Philips.
To fully benefit from the support that Philips offers, register 
your product at. www.philips.com/welcome


SmartImage
What is it? 
SmartImage provides presets that optimize display for different types of\
 content, dynamically adjusting brightness, 
contrast, color and sharpness in real time. Whether youre working with \
text applications, displaying images or watching 
a video, Philips SmartImage delivers great optimized LCD display perform\
ance.


Why do I need it? 
You want a LCD display that delivers optimized display all your favorite\
 types of content, SmartImage software 
dynamically adjust brightness, contrast, color and sharpness in real tim\
e to enhance your LCD viewing experience.
How does it work? 
SmartImage – software based on Philips award-winning LightFrame™ technology – analyzes the content displayed on 
your screen. Based on a scenario you select, SmartImage dynamically enha\
nces the contrast, color saturation 
and sharpness of images and video for ultimate display performance – all in real time with the press on a single button.


How to enable SmartImage? 
 
						

							
1SPEVDU
*OGPSNBUJPO


 1. Press to 
 launch the SmartImage on screen display;
2. Keep press 
 to toggle between Office Work, Image Viewing, Entertainment, Economy, a\
nd Off; 
3. The SmartImage on screen display will remain on screen for 5 seconds or \
you can also press”OK” to make 
confirmation. 
4. When SmartImage is enabled, the sRGB scheme is disabled automatically. T\
o use sRGB you need to 
disable SmartImage with the 
 button at the front bezel of your monitor.
Except using  key to scroll down, you can also press  buttons to choose and press “OK” to confirm selection 
and close the SmartImage OSD.There are five modes to be selected: Office\
 Work, Image Viewing, Entertainment, 
Economy, and Off.
There are five modes to be selected: Office Work, Image Viewing, Enterta\
inment, Economy, and Off.