Panasonic Wifi Phone For Skype Kx Wp1050 Operating Instructions

Getting Started
For assistance, please visit http://www.panasonic.com/help51
PPPoE Configuration: (Point to Point Protocol over Ethernet) Allows the base unit to 
receive an IP address from a PPPoE server.
SettingDescription
[User Name]LEnter the user name (1 – 63 characters) assigned by your 
Internet service provider or the hotel you are staying in this 
data field.
[Password]LIf you have the password assigned by your Internet service 
provider or the hotel you are staying in, enter password (1 – 
63...

Getting Started
52For assistance, please visit http://www.panasonic.com/help
AP Configuration: Allows the base unit to work as an access point when you have a 
router at home. (AP Configuration is not available in the HOTEL mode.) [DNS Server 1]LIf you have the DNS (Domain Name System) server address 
assigned by your Internet service provider or the hotel you 
are staying in, enter them in this data field. They usually 
have two addresses.
LSet 4 numbers (0 – 255) separated by periods such as...

Getting Started
For assistance, please visit http://www.panasonic.com/help53
SettingDescription
[Connection Mode]LSelect [AP-DHCP] for Connection Mode if the DHCP server 
is operating in the router or modem with a built-in router you 
are using. Select [AP-Static] if you want to assign Static IP 
address.
[IP Address]For [AP-Static]:
LEnter the IP address and subnet mask corresponding to 
your local network.
LSet 4 numbers (0 – 255) separated by periods such as 
“192.168.102.253”.
Note:
LThere are some...

Getting Started
54For assistance, please visit http://www.panasonic.com/help
Troubleshooting for installation
If problems occur while installing the base unit, you can refer to the check list below.
For up-to-date support information, visit http://www.panasonic.com/help. Please refer 
to it along with this guide for troubleshooting.
Connection:
ProblemSolution
The modem is connected 
but the WAN indicator is 
off.LCheck that the modem and this product are connected.
LCheck that the power of the modem and...

Getting Started
For assistance, please visit http://www.panasonic.com/help55
Initialization Setup:
ProblemSolution
Initialization Setup is not 
displayed.LDialog boxes may not be displayed immediately due to 
the state of the LAN.
LCheck that the LAN or WIRELESS indicator lights in 
green. Also, check if the LAN card or wireless LAN card 
is on. If not, check that the LAN is connected.
LCheck that the power supply was turned on in the 
following order: modem, router (if you have one), base 
unit,...

Getting Started
56For assistance, please visit http://www.panasonic.com/help
Internet access:
ProblemSolution
I cannot connect to the 
Internet.LCheck the modem connection. Also check the 
connection between this product and the LAN.
LCheck the information received from Internet service 
provider or the hotel you are staying in regarding 
Internet connection.
LWhen instructed to do so by the Internet service 
provider, set a web browser proxy server (page 207).
LCheck that the power supply was turned on...

Getting Started
For assistance, please visit http://www.panasonic.com/help57
Setting up the handset
Battery installation/replacement
1Press the notch of the handset cover firmly, and slide it in the direction of the arrow.
LFor replacement, remove the old battery.
2Insert the battery (A), and press it down until it snaps into position (B). Then close the 
handset cover (C, D).
Important:
LUse only the rechargeable Panasonic battery noted on page 17.
Note:
LThe battery terminal indicated “ ” is not used...

Getting Started
58For assistance, please visit http://www.panasonic.com/help
Battery charge
Connect the included charge cable to the CHARGE port of the handset. Connect the other 
end to the CHARGE port of the base unit that is connected to the power supply.
Charge the battery for 6 hours before initial use.
LWhile charging, the charge indicator on the handset lights in red. When the battery is 
fully charged, the indicator goes out.
LYou can use the included handset stand while charging the battery. To...

Getting Started
For assistance, please visit http://www.panasonic.com/help59
Battery level:
Note:
LWhen the battery needs to be charged, the handset beeps intermittently during a call or 
a voicemail.
Panasonic battery performance:
Note:
LBattery operating time may be shortened over time depending on usage conditions and 
surrounding temperature.
LBattery operating time may be shortened when you connect to a different access point, 
or after you change settings in the handset.
LThe battery level may not...

Getting Started
60For assistance, please visit http://www.panasonic.com/help
Text entry
The dial keys are used to enter characters and numbers. Each dial key has multiple 
characters assigned to it. Use the character table (page 62) and symbol table (page 62) for 
reference when you enter characters or numbers.
Text entry screen
1Cursor: It is a pointer that indicates a position to insert or erase the 
character(s).
2Remaining number: It indicates the number of remaining character(s) you can 
enter. The...