Panasonic Ramsa Audio Mixer Wr Da7 Users Guide

Ground loop.A type of interference in audio equipment that is grounded in
more then one location, often through cables or connections, that can be
the source of hum interference due to small currents that exists between
the two pieces of equipment. Ground loop eliminator devices can prevent
this type hum. All equipment should be grounded for safe operation.
Hertz (Hz).The unit of measure of frequency. 1 hertz equals one cycle per
second. 1KHz equals 1000 cycles per second. (K in the metric system is...

Glossary 
DA7 Users’ Guide
Glossary
Glossary-7 MIDI Timecode.An addition to the MIDI Standard to allow the
synchronization of audio equipment, such as the DA7, to MIDI equipped
devices.
Mix.The combination of various audio signals. The DA7provides an almost
limitless number of ways to combine audio signals. Complex settings can
be saved as “scenes” and recalled later.
mixing bus.An audio mixer where signals from different microphones
and/or preamps are connected and where mixing is actually done. Also...

PPM/Peak Program MeterA peak oriented type of volt meter system
designed to detect signal overloads easily. A PPM responds to input signals
very quickly, several times faster than a Volt Unit meter.
peaking.A broad band equalizer process used to increase or decrease a wide
band of frequencies. The DA7equalizer has 4 Q controls per input fader
to adjust the frequencies affected from broad to narrow.
Phase.Signal connections. In-phase is a properly wired connections; signals
can be mixed (added) to other...

Glossary 
DA7 Users’ Guide
Glossary
Glossary-9 equalizer. See equalizer.
Routing.The designation of inputs, faders, buses, outputs and processes’ of
the signal. See Signal Path.
RS-422.A protocol for communication that specifies which pins in a 9-pin
cable connector are supposed to do what.
Scene Memory.The part of the DA7’s memory used to store scene settings.
Serial port or interface.See RS-422.
Shelving.An Equalization process usually used to cut or boost either high or
low frequencies.The name comes...

Talk Back.A DA7feature that allows the person operating the mixer to talk
to the studio from the control room.
TDIF/Teac Digital Interface Format.An 8-channel digital audio interface for
use with DA-88 type digital multitrack recorders (DTRS).
timecode.An eight-digit number that identifies a specific frame in a tape. It
is also an electronic timing signal, based on the 24-hour clock, that is
recorded along the length of the tape and provides markers for locating
specific program material. There are two...

Index-1
DA7 Users’ Guide
Index
Index-1
Index
A
A/B button [DYNAMICS] window
9-6
[EQUALIZER] window 7-6
AC inlet Rear Panel 2-25
ADAT + DA7 17-2
using with BRC Clock master
17-3—17-4
ADAT digital I/O card
options 17-2—17-4
Additional TAPE sends and
returns
quick start outboard tools
3-14—3-15
AES/EBU & S/PDIF card 17-7
ALL AUX button
SOLO/MON window 16-2,
16-4
Analog 2-track sends and
returns
quick start outboard tools
3-14
Analog 4-track sends and
returns
quick start outboard tools
3-15Area
defined 1-6...

Index
Index-2
DA7 Users’ Guide
Index
B
[BATTERY] area
OSC/BATT window 16-8
[BAUD RATE] area
[MIDI>SETUP] window
11-2
Backup
bulk 1-8
BUF CLR button
[SETUP] window,
AUTOMATION button 14-3
BULK OUT button 1-8
BUS ASSIGN section. See
PAN/ASSIGN/SURROUND 2-
5, 2-9
BUS Fader Strip
BUS ASSIGN section
[BUS/AUX] meter window
[MIDI>BULK] window
11-10
[BUS/AUX] meter window
METER group windows 5-
18
C
Cancel button 11-12
[MIDI>BULK] window
11-10
CH LIB button
[MIDI>BULK] window
11-10
CH or AUX 2 LED
LED status...

Index
Index-3
DA7 Users’ Guide
Index
AUTO DISP CHANGE selection
16-9
Connections 16-9
ADAT + BRC + DA7 17-3
ADAT + DA7 17-2
DA88 + DA7 17-5
SMPT Card 17-9
TANDEM card 17-11—17-15
CONSOLE LOCK LED status
indicator
Display Bridge 2-23
CONTRAST control knob
Display Bridge 2-24
COPY button
[EVT EDIT] window 14-18
Create locate points
[EXECUTE] window 14-10
Creating a fader group
[FADER GRP] window 13-4
Creating a mute group
[MUTE GRP] window 13-6
[CTRL ASGN] window
[CONTROL CHANGE TABLE]
area 11-8—11-9
CTRL...

Index
Display Bridge
[taskbar] area 2-21—2-22
CONSOLE LOCK LED status
indicator 2-23
CONTRAST control knob 2-
24
L/R meter display 2-22
LCD screen 2-20—2-22
MEMORY numeric readout 2-
23
MULTI-CH VIEW LED button
2-24
sample [CHANNEL] window
display 2-20
section illustration 2-20
SOLO LED status indicator 2-
23
[DITHER] window
[AUX SEND 1/2] area 12-16
[REC OUT] area 12-16
[SLOT 1] area 12-16
[SLOT 2] area 12-17
[SLOT 3] area 12-17
warnings 12-15
DLY and GAIN LED button 2-5, 2-
12
DYN button
SCENE MEMORY...

Index
Index-5
DA7 Users’ Guide
Index
FREQ or SL knob 7-5
GAIN or SUB knob 7-4
H, HM, and L LED buttons
7-5
overview 7-1—7-2
Q or L knob 7-4
quick start onboard tools 3-
6
[EQUALIZER] window
multi-channel view 7-2, 7-10
[EQ] button 7-6
[HPF] filter button 7-7
[LPF] filter button 7-7
[PEQ] buttons 7-7
[SHH] filter button 7-7
[SHL] filter button 7-7
A/B button 7-6
filter types 7-7
quick start onboard tools 3-
6—3-8
[EVT EDIT] (event edit) window
7-2, 7-6
[CH] 14-18
[DATA] 14-18
[EDIT CHANNEL SELECT]
area...