Panasonic Pv Dv103 Operating Instructions Manual

41
Digital Features
Digital Features
1Set POWER to CAMERA or VCR.
2Press MENU to display the menu
screen.
3Rotate JOG KEY to select DIGITAL
 EFFECT in the CAMERA or VCR
mode menu screen, then press JOG
KEY to display the DIGITAL EFFECT
menu screen.
4Rotate JOG KEY to select EFFECT  in
the CAMERA mode menu screen or
 EFFECT1 / EFFECT2 in the VCR
mode menu screen, and then press
JOG KEY repeatedly to select one of
the Digital Functions listed on the left.
5To cancel the Digital Function, press
JOG KEY...

42For assistance,  please call :  1-800-211-PANA(7262) or send e-mail to : [email protected]
Digital Features
3, 4JOG
         KEY
1POWER
Picture in Picture (PinP)
You can display a PinP (still image) screen
on the Main Picture.
PinP position is fixed at the bottom right of
the screen.
Note
1Set POWER to CAMERA.
2Press MENU to display the CAMERA
FUNCTIONS menu screen.
3Rotate JOG KEY repeatedly to select
 DIGITAL EFFECT , then press JOG
KEY to display the DIGITAL EFFECT
menu screen.
4Press...

43
Editing Features
Editing Features
The original sound can be replaced with
new sound using the built-in Palmcorder
microphone.
Audio Dubbing using the
Built-in Microphone
1Set POWER to VCR.
If you have the optional Remote
Control, you can set the Palmcorder to
stop automatically at a specified point
on the tape. See “Memory-Stop
Editing” on page 44.
2Press  (PLAY). Then press (PAUSE) where you  want dubbing to
begin.
3Press MENU to display the VCR
FUNCTIONS menu screen.
Rotate JOG KEY to select...

44For assistance,  please call :  1-800-211-PANA(7262) or send e-mail to : [email protected]
Editing Features
4Press  (PAUSE) to start Audio
Dubbing. “A.DUB ” indication
appears.
Connect the Palmcorder to the TV in
order to monitor the sound.
(p. 37)
Only NTSC (National Television Standards
Committee) recorded tapes can be audio
dubbed. The following screen appears if
the tape was not recorded in NTSC format.
5Press  (PAUSE) to stop Audio
Dubbing. To listen to the desired audio sound, set...

45
Editing Features
Editing Features
Video In
VHF Connecting
Cable (not
supplied)TV
(To View)
A/V Cable
(Supplied)
To Audio In
To Video In
Recording:
VCR (Rear)
For technical reasons, dubbing a tape
may reduce its quality.
Press DISPLAY ON TV on the Palmcorder
Remote Control (optional) to eliminate
EVF/LCD Monitor indications.
If the Time Code is displayed in the EVF
or LCD monitor, it cannot be reset.
Only the DATE/TIME, when displayed, will
be recorded on the tape.
    CAUTION:Unauthorized...

46For assistance,  please call :  1-800-211-PANA(7262) or send e-mail to : [email protected]
Editing Features
3, 4
PLAY
3, 4, 5PAUSE
3, 4PLAY
6STOP
4REC High quality digital-to-digital copying can be
accomplished if both Palmcorders incorpo-
rate the DV Input/Output (i.LINK) Connec-
tor (DV Interface cable (i.LINK) is not
supplied).
1Insert a pre-recorded tape into the
source (playing) Palmcorder, and set
POWER to VCR.
2Insert a blank tape with the record
tab closed into the target...

47
PC Connection
PC Connection
DV Interface Cable (i.LINK)
(6-to-4 pin) (not supplied)
PC Connector
DV Input/Output
(i.LINK)
Connector
During Palmcorder playback, do not disconnect the DV Interface Cable (i.LINK) or turn
the Palmcorder off as this may cause a PC hang-up error.
Note
PC Connection with DV Interface Cable (i.LINK)
A video clip can be transferred directly to your PC (Personal Computer) via a DV Interface
Cable (i.LINK) (not supplied) using products and software from a number of video...

48For assistance,  please call :  1-800-211-PANA(7262) or send e-mail to : [email protected]
PC Connection
2
4
To PC Connector
PHOTOVU LINK Driver (Optional)
System Requirements for PHOTOVU LINK Driver (Optional)
• IBM PC/AT or compatible
 Intel® Pentium® Processor
 Microsoft Windows 98/98SE/ME/2000/XP
 RAM: 16 MB or more
 2 MB minimum available hard disk space
 256 color monitor (full color recommended) 3.5 inch 1.44 MB floppy disk drive
(for installation)
 RS-232C serial port (D-Sub...

49
PC Connection
Running the Software
PHOTOVU LINK:
You can transfer images from your
Palmcorder tape to your PC.
1Turn your PC (Personal Computer) on
and start up Windows.
2Insert PHOTOVU LINK DRIVER Disk
(Optional) into a floppy disk drive.
3Click on Start, then “Run
… …… …
…”
4Type in “a:\setup.exe” and click OK.
 If your 3.5 inch floppy disk drive is not
“A”, use the appropriate letter.
5Follow the instructions as they appear
on the PC screen until the installation
is complete.
 Setup window will...

50For assistance,  please call :  1-800-211-PANA(7262) or send e-mail to : [email protected]
Using Tape Image Data
Pictures captured with the Palmcorder
can be transferred to your PC.
1Repeat steps 1 and 2 on page 49 to
run the Software.
2“Preview Window” screen appears.
3Search and Select a still scene you
want to transfer to your PC using VCR
Operation Buttons on the “Preview
window” screen. Then click  on
“Transfer” to transfer selected image
from camcorder to “Preview Window”
in PLAY or...