Panasonic Memory Card SRecorder AG-AC90P AG-AC90PJ AG-AC90PX Operating Instructions

							- 11 -
∫
About batteries that you can use with this unit
(AG-AC90P/PJ)
The battery that can be used with this unit is CGA-D54.
(AG-AC90PX)
The battery that can be used with this unit is CGA-D54s.
Preparation
Power supply
It has been found that counterfeit battery packs which look very similar to the genuine 
product are made available to purchase in some markets. Some of these battery packs 
are not adequately protected with internal protection to meet the requirements of 
appropriate safety standards. There is a possibility that these battery packs may lead to 
fire or explosion. Please be advised that we are not liable for any accident or failure 
occurring as a result of use of a counterfeit battery pack. To ensure that safe products are 
used we would recommend that a genuine Panasonic battery pack is used.
AG-AC90-VQT4M99_mst.book  11 ページ  ２０１２年９月２５日　火曜日　午後１２時６分 
						

							- 12 -
Charging the battery
Important:
≥Do not use the AC cable with any other equipment as it is designed only for this unit. Also, 
do not use the AC cable from other equipment with this unit.
≥ It is recommended to charge the battery in a temperature between 10 oC and 30 oC (50 °F to 
86 °F).
(The battery temperature should also be the same.)
C AG-AC90P/PJ: AC cable (K2CA2CA00025; supplied)
AG-AC90PX: AC cable (K2CA2YY00129; supplied)
≥ Insert the plugs as far as they will go.
1Connect the AC cable to the battery charger and the AC outlet.(AG-AC90P/PJ only)
≥Use the AC cable (K2CA2CA00025; supplied) dedicated for the battery charger.
2Insert the battery into the battery charger by aligning the arrows.
≥We recommend using Panasonic batteries ( l14).
≥ If you use other batteries, we cannot guarantee the quality of this product.
≥ Do not heat or expose to flame.
≥ Do not leave the battery(ies) in a car exposed to direct sunlight for a long period of time with 
doors and windows closed.
When this unit is purchased, the battery is not charged. Charge the battery fully before 
using this unit for the first time.
Charging lamp [CHARGE]
ALights up:
Charging (Battery charging time:  l14)
Goes off:
Charging completed
Flashing:
Be sure to connect the unit correctly ( l11 4 )
Power lamp B≥This will light up when the AC cable is 
connected.
AG-AC90-VQT4M99_mst.book  12 ページ  ２０１２年９月２５日　火曜日　午後１２時６分 
						

							- 13 -
Inserting/removing the battery
Install the battery by inserting it in the direction shown in the figure.
Removing the batteryMake sure that the power switch is set to OFF 
and the status indicator is turned off, and then 
remove by holding onto it taking care not to 
drop. (l18)
While pressing the battery release button, 
remove the battery.
Insert the battery until it clicks and locks.
AG-AC90-VQT4M99_mst.book  13 ページ  ２０１２年９月２５日　火曜日　午後１２時６分 
						

							- 14 -
Charging and recording time
∫Charging/Recording time
≥Temperature: 25 oC (77 oF)/humidity: 60%RH
≥ When using the viewfinder (times in parentheses are when using the LCD monitor)
≥ These times are approximations.
≥ The indicated charging time is for when the battery has been discharged completely. 
Charging time and recordable time vary depending on the usage conditions such as high/
low temperature.
≥The actual recordable time refers to the recordable time when repeatedly starting/stopping 
recording, turning the unit on/off, moving the zoom lever etc.
≥ The batteries heat up after use or charging. This is not a malfunction.
Battery model number
[Voltage/Capacity  (minimum)]Charging timeRecording formatMaximum 
continuously 
recordable timeActual 
recordable time
Supplied battery/
CGA-D54 and CGA-D54s  (optional)
[7.2 V/5400 mAh] 6hPS 1080/60p
6h25min
(5h45min) 4h
(3h35min)
PH 1080/60i 6h45min
(6 h) 4h10min
(3h40min)
PH 1080/30p 6h50min
(6h5min) 4h15min
(3h45min)
PH 1080/24p 7h10min
(6h20min) 4h25min
(3h55min)
HA 1080/60i 6h45min
(6 h) 4h10min
(3h45min)
HE 1080/60i 6h55min
(6h5min) 4h15min
(3h45min)
SA 480/60i 7h5min
(6h15min) 4h20min
(3h50min)
Battery capacity indication≥ The display changes as the battery capacity reduces.  #### 
If the battery discharges, then   will flashes red.
AG-AC90-VQT4M99_mst.book  14 ページ  ２０１２年９月２５日　火曜日　午後１２時６分 
						

							- 15 -
Connecting to the AC outlet
The unit is in the standby condition when the AC adaptor is connected. The primary circuit is always 
“live” as long as the AC adaptor is connected to an electrical outlet.
Important:
≥Use the supplied AC adaptor. Do not use the AC adaptor of another device.
≥ Do not use the AC cable with any other equipment as it is designed only for this unit. Also, 
do not use the AC cable from other equipment with this unit.
(AG-AC90P/PJ)
A AC cable (K2CB2CB00022; supplied) (AG-AC90PX)
B
AC cable (K2CA2YY00129; supplied)
≥ Insert the plugs as far as they will go.
1Connect the AC cable to the AC adaptor and the AC outlet.(AG-AC90P/PJ only)
≥ Use the AC cable (K2CB2CB00022; supplied) dedicated for the AC adaptor.
2Connect the AC adaptor to the DC input terminal [DC IN].
∫ Removing the AC adaptor
≥Make sure to set the power switch to OFF an d the status indicator is turned off when 
disconnecting the AC adaptor.

 


 


AG-AC90-VQT4M99_mst.book  15 ページ  ２０１２年９月２５日　火曜日　午後１２時６分 
						

							- 16 -
The unit can record motion pictures or still pictures to an SD card.
Cards that you can use with this unit
Use SD cards conforming to Class 4 or higher of the SD Speed Class Rating* for motion 
picture recording.
* SD Speed Class Rating is the speed standard regarding continuous writing. Check 
via the label on the card, etc.
≥Please check the latest information on the support website below.
http://pro-av.panasonic.net
≥ When using an SDHC Memory Card/SDXC Memory Card with other equipment, check the 
equipment is compatible with these Memory Cards.
≥ We do not guarantee the operation of SD cards other than the ones above. Further, SD cards 
with a capacity of less than 32 MB cannot be used for video recording.
≥ 4 GB or more Memory Cards that do not have the SDHC logo or 48 GB or more Memory Cards 
that do not have the SDXC logo are not based on SD Memory Card Specifications.
≥ When the write-protect switch  A on SD card is locked, no recording, deletion 
or editing will be possible on the card.
≥ Keep the Memory Card out of reach of children to prevent swallowing.
Preparation
Preparation of SD cards
Card typeCapacity
SD Memory Card 512 MB/1 GB/2 GB
SDHC Memory Card 4 GB/6 GB/8 GB/12 GB/16 GB/24 GB/32 GB
SDXC Memory Card48 GB/64 GB
e.g.:
32
AG-AC90-VQT4M99_mst.book  16 ページ  ２０１２年９月２５日　火曜日　午後１２時６分 
						

							- 17 -
Inserting/removing an SD card
Caution:
Check that the access lamp has gone off.
1Open the SD card slot cover and 
insert (remove) the SD card into 
(from) the card slot B.
≥ One SD card can be inserted into each of the 
card slot 1 and the card slot 2.
≥ Face the label side C  in the direction shown 
in the illustration and press it straight in as far 
as it will go.
≥ Press the center of the SD card and then pull 
it straight out.
2Securely close the SD card slot 
cover.
≥Securely close it until it clicks.
≥Do not touch the terminals on the back of the 
SD card.
≥ Do not apply strong shocks, bend, or drop the 
SD card.
≥ Electrical noise, static electricity or the failure 
of this unit or the SD card may damage or 
erase the data stored on the SD card.
≥ When the card access lamp is lit, do not:
jRemove the SD card
j Turn the unit off
j Insert and remove the USB cable
j Expose the unit to vibrations or shock
Performing the above while the lamp is on 
may result in damage to data/SD card or this 
unit.
≥ Do not expose the terminals of the SD card to 
water, dirt or dust. ≥
Do not place SD cards in the following areas:
jIn direct sunlight
j In very dusty or humid areas
j Near a heater
j Locations susceptible to significant 
difference in temperature (condensation 
can occur.)
j Where static electricity or electromagnetic 
waves occur
≥ To protect SD cards, return them to their 
cases when you are not using them.
≥ About disposing of or giving away the SD 
card. ( l11 5 )
When using a non Panasonic SD card for the first time, or one which was previously used on 
another equipment, it is necessary to format the SD card. (
l28) When the SD card is formatted, 
all of the recorded data is deleted. Once the data is deleted, it cannot be restored.


Access lamp  A≥When this unit is accessing the SD card, 
the access lamp lights up.
AG-AC90-VQT4M99_mst.book  17 ページ  ２０１２年９月２５日　火曜日　午後１２時６分 
						

							- 18 -
Set the power switch to ON while pressing the lock release button B to turn on 
the unit.
A The status indicator lights on.
≥To turn on the unit again after the [ECONOMY (BATT)] or [ECONOMY (AC)] is activated, set the 
power switch to OFF once, and then to ON again. ( l101 )
Operate the mode switch to change the mode to   or  .
Preparation
Turning the unit on/off
Preparation
Selecting a mode
Recording Mode ( l30, 31 )
Playback Mode ( l65)

To turn off the unitSet the power switch to OFF while 
pressing the lock release button.
The status indicator goes off.

C Mode switch
AG-AC90-VQT4M99_mst.book  18 ページ  ２０１２年９月２５日　火曜日　午後１２時６分 
						

							- 19 -
The viewfinder is turned off and the LCD monitor is turned on when the LCD monitor is extracted. 
The viewfinder is turned on when the LCD monitor is retracted.
Using the LCD monitor
1Extract the LCD monitor in the 
direction as indicated in the figure.
≥ Hold the LCD monitor extract part  A when 
pulling out.
2Rotate to the position that is easy to 
view.
To retract the LCD monitor
Retract as shown in the figure with the LCD facing 
downward.
Range of rotation of the LCD monitor≥ It can rotate up to 270 o B towards the lens.
Preparation
Using the LCD monitor/Viewfinder


AG-AC90-VQT4M99_mst.book  19 ページ  ２０１２年９月２５日　火曜日　午後１２時６分 
						

							- 20 -
How to use the touch screen
You can operate by directly touching the LCD monitor (touch screen) with your finger.
∫Touch
Touch and release the touch screen to select icon or 
picture.
≥Touch the center of the icon.
≥ Touching the touch screen will not operate while you 
are touching another part of the touch screen.
∫ Slide while touching
Move your finger while pressing on the touch screen.
∫About the operation icons
///:
Touch when changing a page or performing settings. :
Touch to return to the previous screen.
≥ Do not touch the LCD monitor with hard pointed tips, such as ball point pens.
LCD monitor adjustment
≥These settings will not affect the images actually recorded.
This makes it easier to view the LCD monitor in bright places including outdoors.
Select the menu. ( l24)
≥When the AC adaptor is in use, [POWER LCD] is set to [ON] automatically.
≥ Recordable time with the battery is shortened when the LCD is made brighter.
[POWER LCD]
: [SW & DISP SETUP]  # [POWER LCD]# [ON]MENU
AG-AC90-VQT4M99_mst.book  20 ページ  ２０１２年９月２５日　火曜日　午後１２時６分