Panasonic Memory Card SRecorder AG-AC90P AG-AC90PJ AG-AC90PX Operating Instructions

- 11 -
∫
About batteries that you can use with this unit
(AG-AC90P/PJ)
The battery that can be used with this unit is CGA-D54.
(AG-AC90PX)
The battery that can be used with this unit is CGA-D54s.
Preparation
Power supply
It has been found that counterfeit battery packs which look very similar to the genuine 
product are made available to purchase in some markets. Some of these battery packs 
are not adequately protected with internal protection to meet the requirements of 
appropriate safety standards....

- 12 -
Charging the battery
Important:
≥Do not use the AC cable with any other equipment as it is designed only for this unit. Also, 
do not use the AC cable from other equipment with this unit.
≥ It is recommended to charge the battery in a temperature between 10 oC and 30 oC (50 °F to 
86 °F).
(The battery temperature should also be the same.)
C AG-AC90P/PJ: AC cable (K2CA2CA00025; supplied)
AG-AC90PX: AC cable (K2CA2YY00129; supplied)
≥ Insert the plugs as far as they will go.
1Connect the AC cable to...

- 13 -
Inserting/removing the battery
Install the battery by inserting it in the direction shown in the figure.
Removing the batteryMake sure that the power switch is set to OFF 
and the status indicator is turned off, and then 
remove by holding onto it taking care not to 
drop. (l18)
While pressing the battery release button, 
remove the battery.
Insert the battery until it clicks and locks.
AG-AC90-VQT4M99_mst.book  13 ページ  ２０１２年９月２５日　火曜日　午後１２時６分 

- 14 -
Charging and recording time
∫Charging/Recording time
≥Temperature: 25 oC (77 oF)/humidity: 60%RH
≥ When using the viewfinder (times in parentheses are when using the LCD monitor)
≥ These times are approximations.
≥ The indicated charging time is for when the battery has been discharged completely. 
Charging time and recordable time vary depending on the usage conditions such as high/
low temperature.
≥The actual recordable time refers to the recordable time when repeatedly starting/stopping...

- 15 -
Connecting to the AC outlet
The unit is in the standby condition when the AC adaptor is connected. The primary circuit is always 
“live” as long as the AC adaptor is connected to an electrical outlet.
Important:
≥Use the supplied AC adaptor. Do not use the AC adaptor of another device.
≥ Do not use the AC cable with any other equipment as it is designed only for this unit. Also, 
do not use the AC cable from other equipment with this unit.
(AG-AC90P/PJ)
A AC cable (K2CB2CB00022; supplied)...

- 16 -
The unit can record motion pictures or still pictures to an SD card.
Cards that you can use with this unit
Use SD cards conforming to Class 4 or higher of the SD Speed Class Rating* for motion 
picture recording.
* SD Speed Class Rating is the speed standard regarding continuous writing. Check 
via the label on the card, etc.
≥Please check the latest information on the support website below.
http://pro-av.panasonic.net
≥ When using an SDHC Memory Card/SDXC Memory Card with other equipment, check...

- 17 -
Inserting/removing an SD card
Caution:
Check that the access lamp has gone off.
1Open the SD card slot cover and 
insert (remove) the SD card into 
(from) the card slot B.
≥ One SD card can be inserted into each of the 
card slot 1 and the card slot 2.
≥ Face the label side C  in the direction shown 
in the illustration and press it straight in as far 
as it will go.
≥ Press the center of the SD card and then pull 
it straight out.
2Securely close the SD card slot 
cover.
≥Securely close it until...

- 18 -
Set the power switch to ON while pressing the lock release button B to turn on 
the unit.
A The status indicator lights on.
≥To turn on the unit again after the [ECONOMY (BATT)] or [ECONOMY (AC)] is activated, set the 
power switch to OFF once, and then to ON again. ( l101 )
Operate the mode switch to change the mode to   or  .
Preparation
Turning the unit on/off
Preparation
Selecting a mode
Recording Mode ( l30, 31 )
Playback Mode ( l65)

To turn off the unitSet the power switch to OFF while...

- 19 -
The viewfinder is turned off and the LCD monitor is turned on when the LCD monitor is extracted. 
The viewfinder is turned on when the LCD monitor is retracted.
Using the LCD monitor
1Extract the LCD monitor in the 
direction as indicated in the figure.
≥ Hold the LCD monitor extract part  A when 
pulling out.
2Rotate to the position that is easy to 
view.
To retract the LCD monitor
Retract as shown in the figure with the LCD facing 
downward.
Range of rotation of the LCD monitor≥ It can rotate up...

- 20 -
How to use the touch screen
You can operate by directly touching the LCD monitor (touch screen) with your finger.
∫Touch
Touch and release the touch screen to select icon or 
picture.
≥Touch the center of the icon.
≥ Touching the touch screen will not operate while you 
are touching another part of the touch screen.
∫ Slide while touching
Move your finger while pressing on the touch screen.
∫About the operation icons
///:
Touch when changing a page or performing settings. :
Touch to return to the...