Panasonic Lcd Tv Ct L1400 Operating Instructions

 LCD TV
Operating Instructions
TQBC0631
Before connecting, operating or adjusting this product, please read thes\
e instructions completely.
Please keep this manual for future reference.
English
Model No. CT-L1400
CT-L2000 

2
Important Safety Instructions
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
The exclamation point within a
triangle is intended to tell the
user that important operating
and servicing instructions are in
the papers with the appliance.

 Note to CATV System Installer: This reminder is provided to direct the CATV system installer’s
attention to Article 820–40 of the NEC that provides guidelines for proper grounding and, in particular,
specifies that the cable ground shall be connected to the grounding...

3
17) If an outside antenna is connected to the
television
 equipment, be sure the antenna system
is grounded so as to provide some protection
against voltage surges and built up static
charges. In the U.S. Selection 810-21 of the
National Electrical Code provides information
with respect to proper grounding of the mast and
supporting structure, grounding of the lead-in wire
to  an antenna discharge unit, size of grounding
conductors, location of antenna discharge unit,
connection to grounding...

4
Dear Panasonic Customer
Welcome to the Panasonic family of customers.
We hope that you will have many years of enjoyment from your new LCD TV.
To obtain maximum benefit from your set, please read these instructions before
making any adjustments, and retain them for future reference.
Retain your purchase receipt, and record the model number and serial number
of your set in the space provided on the rear cover of these instructions.
This equipment has been tested and found to comply with the limits for...

5
Table of Contents
Important Safety Instructions .............................. 2
Table of Contents .................................................. 5
Installation ............................................................. 6SUPPLIED ACCESSORIES ................................ 6
Remote control battery installation ...................... 7
Maintenance .......................................................... 7
Connections .......................................................... 8
Connecting the...

6
Installation
Receiver Location
Locate for comfortable viewing. Avoid placing where sunlight or other bright light (including reflection\
s) will fall on the screen.
Use of some types of fluorescent lighting can reduce remote control tran\
smitter range.
Adequate ventilation is essential to prevent internal component failure.\
 Keep away from areas of excessive heat or moisture.
Optional External Equipment
The Video/Audio connection between components can be made with shielded video\
 and audio cables....

7
 
Precaution on battery use
Incorrect installation can cause battery leakage and corrosion that will damage the remote control
transmitter.
Observe the following precautions:
1.   Always use new batteries when replacing the old set.
2.   Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
3.   Battery replacement is necessary when remote control acts sporadically or stops operating this unit.
Notes:
• Do not drop, apply shock to or step on the remote control.
• Do not...

8
Connections
Connecting the Antenna Cable to the Antenna Terminal
ANT
ANT
UHF AntennaAntenna Terminal
(ANT or VHF/UHF)
VHF Antenna
Mixer
75 Ohm
Coaxial Cable
Coaxial Antenna Plug
Antenna Connection -  For proper reception of VHF/UHF channels, an external antenna is require\
d. For best
reception an outdoor antenna is recommended. Antenna Mode must be set to TV.
Incoming 75 Ohm Cable from Home Antenna /  Cable Company
Note:
Certain cable systems offset some channels to reduce interference or have Premium...

9
Connections
Use this configuration when connecting the TV to a cable TV system using a Cable Box.
Antenna Connection (Cable Box, no VCR)
Use this configuration when connecting the TV to a cable TV system using a Cable Box and VCR.
Antenna Connection (Cable Box, and VCR)
ANT
ANT
Connect the cable from the Output
terminal on the back of the Cable
Box to the ANTENNA terminal on
the back of the TV.CABLE BOX
TERMINALS ON THE BACK OF
THE CABLE BOX
Incoming Cable from
Antenna or Cable TV
System OUTPUT INPUT...

10
How to connect the input terminals
Connections
Connect VCR and other peripheral equipment
ANTDC IN   15V
L
R AUDIO
1
INPUT VIDEO S-VIDEOL
R AUDIO
2 VIDEO S-VIDEO
L
R AUDIOCOMPORNENT VIDEO INPUTVIDEOPBYPR
L
R AUDIO
1
INPUT VIDEO S-VIDEOL
R AUDIO
2 VIDEO S-VIDEO
L
R AUDIO
COMPORNENT VIDEO INPUT
VIDEO
PB
Y
PRS-VIDEO cable
VIDEO
AUDIO
(Super-VHS VCR)(DVD/STB)
Audio
OUT RLS-Video
OUT Video
OUT
VIDEO
Pr Pb YCOMPONENT VIDEO OUT
AUDIO
Audio
OUT
LR
Connect the
 S-VIDEO or
VIDEO Terminal.
Notes:
(1) When a...