Panasonic LCD Projector PT-FZ570 PT-FW530 PT-FX500 Operating Instructions

Chapter 1 Preparation — Precautions for use
ENGLISH - 21
About Wireless LANs
The advantage of a wireless LAN is that information can be exchanged between a PC or other such equipment 
and an access point using radio waves as long as you are within range fo\
r radio transmissions.
On the other hand, because the radio waves can travel through obstacles (such as walls) and are available 
everywhere within a given range, problems of the type listed below may o\
ccur if security-related settings are 
not...

Chapter 1 Preparation — Precautions for use
22 - ENGLISH
Cautions on use
 
r To get a good picture quality
 
f In order to view a beautiful image in higher contrast, prepare an approp\
riate environment. Draw curtains or 
blinds over windows and turn off any lights near the screen to prevent outside light or light from indo\
or lamps 
from shining onto the screen.
 
r Do not touch the surface of the projection lens with your bare hands.
If the surface of the projection lens becomes dirty from...

Chapter 1 Preparation — Precautions for use
ENGLISH - 23
Accessories
Make sure that the following accessories are provided with your projector
. Numbers enclosed in < > show the 
number of accessories.
Wireless remote control unit 
(N2QAYA000123)
                                      
Lens cover 
(TXFKK01XMQZ)
Power cord 
(TXFSX02RYJZ)CD-ROM 
(TXFQB02XSLZ)
(TXFSX02RYLZ)AAA/R03 or AAA/LR03 battery 
(For remote control unit)
(TXFSX02RWFZ)
(TXFSX02UTRZ)
Attention
 
f After unpacking the projector, discard...

Chapter 1 Preparation — Precautions for use
24 - ENGLISH
Contents of the supplied 
CD-ROM
The contents of the supplied CD-ROM are as follows.
Instruction/list (PDF) Operating Instructions
Multi Monitoring & Control Software Operating Instructions
Logo Transfer Software Operating Instructions
Presenter Light Software Operating Instructions
List of Compatible Device ModelsThis is a list of display models (projector or 
flat panel display) that are compatible with the 
software contained in the CD-ROM and...

Chapter 1 Preparation — 
About your projector
ENGLISH - 25
About your projector
Remote control
2 1
3
5 4 4
6
7 11 10
23
24
16 15
17 20 19 18
21
22
8
9
14 13 12
1 Power  button ( v standby/b power on)
Sets the projector to the state where the projector is switched 
off (standby mode) when the  switch on the 
projector is set to  and in the projection mode.  
Also starts projection when the power is switched off (standby 
mode).
2  Remote control indicator
Blinks if any button in the remote control is...

Chapter 1 Preparation — 
About your projector
26 - ENGLISH
Attention
 
f Do not drop the remote control.
 
f Avoid contact with liquids or moisture.
 
f Do not attempt to modify or disassemble the remote control.
 
f Please observe the following contents that are described on the back  of\
 the remote 
 
control unit (see the right picture).
    1. Do not use a new battery together with an old battery.
    2. Do not use unspecified batteries.
    3. Make sure the polarities (+ and -) are correct when...

Chapter 1 Preparation — 
About your projector
ENGLISH - 27
13  terminal
Connect the supplied power cord.
14   switch
Turns off/on the main power.
15  Connecting terminals ( x page 28)
16  Security slot
This security slot is compatible with the Kensington security 
cables. 17 
Control panel ( x page 27)
18  Air filter cover
The air filter units are inside.
19  Air intake port
2220 2119
20 
Burglar hook port
Attaches a burglar prevention cable, etc.
21  Luminance sensor  
Measures the brightness of the...

Chapter 1 Preparation — 
About your projector
28 - ENGLISH
 
r Connecting terminals
1 3
2 456
7 8910 11
1  terminal
Insert the optional wireless module (Model No.: ET-WML100) 
directly to this terminal when using the wireless LAN function.
2   terminal
This is the terminal to input RGB signals or YC
BCR/YPBPR 
signals, also to output the  RGB signals 
and YC
BCR/YPBPR signals, which is input to the terminal.
3   terminal
This is the terminal to input RGB signals, YC
BCR/YPBPR signals, 
or Y/C signals.
4...

Chapter 1 Preparation — Preparing the remote control
ENGLISH - 29
Preparing the remote control
Inserting and removing the batteries
ii)i)
1) 
Open the cover. (Fig. 1)
2)  Insert the batteries and close the cover (insert the m side first). (Fig. 2)
 
f When removing the batteries, perform the steps in reverse order.
When using the system with multiple projectors
When you use the system with multiple projectors, you can operate all th\
e projectors simultaneously or each 
projector individually by using...

30 - ENGLISH
Chapter 2 Getting Started
This chapter describes things you need to do before using the projector \
such as the setup and connections.