Panasonic Kx Tge463 Operating Instructions Manual

you specify. You can then operate the
answering system remotely to listen to the
new message.
To use this feature, you must:
– store a phone number to which the unitmakes the call to.
– turn on the new message alert setting.
After you answer the new message alert call,
you can listen to messages from that call
(page 61).
This feature is only available for landline.
Important:
R A new message alert is stopped 1 minute
after the unit starts to call. The unit will not
retry the call even if the call is not...

nWhen the remote access code is set to
“Inactivate ”:
Press  4 to play the new message during
the announcement.
n When the remote access code is set to
“Activate ”:
1 Enter the remote access code
(page 62) during the announcement.
2 Press  4 to play the new message.
Note:
R Within 10 seconds after listening to new
messages, you can press  #9 during the
call to turn off the new message alert by a
call feature.
R Even if the unit makes a new message alert
call, the handset redial list does not show
the...

KeyOperation
*5Erase all messages
*#End remote operation
(or hang up)
*1 If pressed within the first 5 seconds of a message, the previous message is
played.
*2 For English voice guidance only
*3 For Spanish voice guidance only
Turning on the answering system
remotely
1 Dial your phone number from a
touch-tone phone.
2 Let the phone ring 15 times.
RA long beep is heard.
3 Enter your remote access code within 10
seconds after the long beep.
RThe greeting message is played back.
R You can either hang up,...

Handset message indicator
You can select whether or not the message
indicator on the handset flashes slowly when
new messages are recorded. The default
setting is “On ”.
Important:
R If you stored the voicemail access number
(page 65), the message indicator also
flashes for newly recorded voicemail
messages (page 66).
1 MMENU N#340
2 Mb N: Select the desired setting.  a
M SAVE N a  M OFF N
Note:
R While message indicator is on, battery
operating time is shortened (page 12).
64For assistance, please...

Voicemail service forlandline
In addition to your unit’s answering system
you may also have voicemail service from
your phone service provider.  Voicemail is
an answering service that may be offered by
your phone service provider. This service can
also record calls when you are unavailable to
answer the phone or when your line is busy.
Messages are recorded on the phone
company system and not on the unit’s
answering system.
R To use the voicemail service rather than the
unit’s answering system, turn off...

Listening to voicemail messages
When new messages have been recorded:
–“Voicemail msg. via phone co. ” is
displayed if message indication service is
available.
– The message indicator on the handset flashes slowly if the message indicator is
turned on (page 64).
Handset
1 MMENU N#330
R The speakerphone turns on.
2 Follow the pre-recorded instructions.
3 When finished, hang up.
Note:
R You can also use the  MACCESS N soft key,
if displayed, to play new voicemail
messages.
R If the handset still indicates...

3Insert the hooks on the wall mounting
adaptor into holes () and () on the
base unit.
4 Adjust the adaptor to hold the base unit,
then push it in the direction of the arrow
until it clicks into place.
5Mount the unit on a wall then slide down
to secure in place.
 AC adaptor cord
R This product is compliant with the
following wall phone plate sizes (2
types).
 83 mm (3  1
/4  inches) 102 mm (4 inches)
Fit the slots of the unit onto the
corresponding wall phone plate tabs
for (
) and () respectively.
For...

To remove the wall mounting adaptor
While pushing down the release levers (A),
remove the adaptor ( B).
Charger
Drive the screws (
) (not supplied) into the
wall.
 27.2 mm (1  1
/16  inches)
68For assistance, please visit http://shop.panasonic.com/support
Useful Information

TGE46x47x(en)_1117_ver061.pdf   682015/11/17   15:14:16B
AA 1 2 1
2  

Error messages
Display messageCause/solution
Ask phone
company for
VM access #RYou have not stored the voicemail access number.
Store the number (page 65).
Base no power
or
No link. Re-
connect base
AC adaptor.
or
No link.RConfirm the base unit’s AC adaptor is connected to
the unit and the power outlet correctly.
R The handset has lost communication with the base
unit. Move closer to the base unit and try again.
R Unplug the base unit’s AC adaptor to reset the unit.
Reconnect the adaptor and try again....

Display messageCause/solution
InvalidRThere is no handset registered to the base unit
matching the handset number you entered.
R The handset is not registered to the base unit.
Register the handset (page 49).
Requires
subscription
to Caller ID.RYou must subscribe to a Caller ID service. Once you
receive caller information after subscribing to a Caller
ID service, this message will not be displayed.
Use
rechargeable
battery.RA wrong type of battery such as alkaline or
manganese was inserted. Use only the...