Panasonic Kx Tgc350 Operating Instructions Manual

Storing unwanted callers
Y
ou can store up to 30 phone numbers in the
call block list.
Important:
R We recommend storing 10 digits (including
the area code). If only 7 digits are stored, all
numbers that have the same last 7 digits
will be blocked.
n  From the caller list:
1 MC N CID
2 Mb N: Select the entry to be blocked.
R To edit the number:  MMENU N a  M b N:
“ Edit ” a  M SELECT N
Press  MEDIT N repeatedly until the
phone number is shown in the 10-digit
format. And then, press  MSAVE N. Go to
step...

Registering a handset to
t he base unit
If for some reason the handset is not
registered to the base unit, re-register the
handset.
1 Handset:
MMENU N#130
2 Base unit:
Press and hold  M N
 
for about 5 seconds.
R If all registered handsets start ringing,
press  M N
 
again to stop, then repeat
this step.
3 Handset:
Press  MOK N, then wait until a long beep
sounds. Deregistering a handset
1 MM

ENUN#131
R All handsets registered to the base unit
are displayed.
2 Mb N: Select the handset you want to...

Using Caller ID service
I mportant:
R This unit is Caller ID compatible. To use
Caller ID features, you must subscribe to a
Caller ID service. Contact your phone
service provider for details. Caller ID features
W

hen an outside call is being received, the
caller information is displayed.
Caller information for the last 50 callers is
logged in the caller list from the most recent
call to the oldest.
R If the unit cannot receive caller information,
the following is displayed:
–“Out of area ”: The caller...

Answering system
(
KX-TGC360 series)
The answering system can answer calls and
record caller messages. If you do not want to
record messages, select  “Greeting only ”
as the recording time setting (page 27). Recording capacity
T

he total recording time is about 17 minutes,
including your greeting message. Up to 64
messages can be recorded.
Note:
R When message memory becomes full:
–“Messages full ” is shown on the
handset display.
– The ANSWER ON/OFF indicator on the base unit flashes rapidly if the...

Erasing all messages
P
ress  MERASE N 2 times while the unit is not in
use. Using the handset
W
 hen new messages have been recorded,
“ New message ” is displayed.
1 To listen to new messages:
MMENU N#323
To listen to all messages:
M MENU N#324
2 When finished, press  MOFF N. Operating the answering system
M
M

ENU N a  M b N:  “Answering device ” a
M SELECT NKey Operation
M D N 
or  MC N Adjust the receiver/speaker
v
olume (during playback)
1  
or  MF N Repeat message (during
p
layback)
2  
or  ME N...

Voice guidance
n
W
hen the English voice guidance is
selected
During remote operation, the unit’s voice
guidance starts and prompts you to press
1  to perform a specific operation, or press
2  to listen to more available operations.
n When the Spanish voice guidance is
selected
To start the voice guidance, press  9. The
voice guidance announces the available
remote commands (page 26).
Note:
R If you do not press any dial keys within 10
seconds after a voice guidance prompt, the
unit disconnects your...

Caller’s recording time
Y ou can change the maximum message
recording time allowed for each caller.
1 MMENU N#305
2 Mb N: Select the desired setting.  a
M SAVE N a  M OFF N Selecting “
G
 reeting only ”
You can select  “Greeting only ” which sets
the unit to announce a greeting message to
callers but not record messages.
Select  “Greeting only ” in step 2 on
“Caller’s recording time”, page 27.
For assistance, please visit http://shop.panasonic.com/support 27Answering System
TGC35x_36x(en)_1116_ver012.pdf...

Voicemail service
I n addition to your unit’s answering system
you may also have voicemail service from
your phone service provider.  Voicemail is
an answering service that may be offered by
your phone service provider. This service can
also record calls when you are unavailable to
answer the phone or when your line is busy.
Messages are recorded on the phone
company system and not on the unit’s
answering system.
R To use the voicemail service rather than the
unit’s answering system, turn off the...

Error messages
Display message Cause/solution
Base no power
o r
No link. Re-connect base
AC adaptor. R
The handset has lost communication with the base
unit. Move closer to the base unit and try again.
R Unplug the base unit’s AC adaptor to reset the unit.
Reconnect the adaptor and try again.
R The handset’s registration may have been canceled.
Re-register the handset (page 22).
Busy RO
ther units are in use and the system is busy. Try
again later.
Call phone company for
y
 our access # R
You have not...

Problem Cause/solution
I cannot hear a dial tone. RThe base unit’s AC adaptor or telephone line cord is not
connected. Check the connections.
Time on the unit has shifted. RI
ncorrect time information from incoming Caller ID
changes the time. Set the time adjustment to  “Manual ”
(off) (page 18). Battery recharge
Problem Cause/solution
I fully charged the batteries, but
–  still flashes,
–  is displayed, or
–

the operating time seems to be shorter. R
C
lean the battery ends ( ,  ) and the charge...