Panasonic Kx Tga200 Operating Instructions Manual

							– 11 –
Base unit: 
1. Press 
(FUNCTION).
2. Select  “Registration ” by
pressing  or  , and press  H.
3. Select  “Deregistration ” by
pressing  or  , and press  H.
4. Press  Ior H to move the cursor
to the handset number to be 
canceled.
5. Press 
(ENTER).
6. Press 
(CLEAR), and press (EXIT).
Canceling Handset Registration
Make sure that the base unit and cordless handset a re in the standby mode. 
Cordless handset: 
1. Press 
(FUNCTION).
2. Select  “Registration ” by
pressing  or  , and press  H.
3. Select  “Deregistration ” by
pressing  or  , and press  H.
4. Press 
(CLEAR), and press (EXIT).
Using an Optional Headset
Plugging an optional headset into the cordless hand set allows a hands-free
phone conversation. Please use only a Panasonic KX- TCA88 headset.  To
order, call the accessories telephone number on pag e 1. 
Connecting the headset to the cordless handset 
Open the headset jack cover, and connect the headse t to the headset jack
as shown.
Headset Jack
When the headset is 
connected, make sure
to use the headset to 
talk with the caller. If 
you want to have a 
normal cordless 
phone conversation,
disconnect the 
headset.
Wall Mounting
The charger can be wall 
mounted.
Install screws using the 
wall template on the right. 
Connect the AC adaptor. 
Mount the charger, then 
slide it down.
Screws
3 cm
Wall Template
3 cm
To Power Outlet 
						

							– 12 –
CAUTION:
To reduce the risk of fire or injury to persons, re ad and follow these instructions.
1. Use only the battery(ies) specified. 
2. Do not dispose of the battery(ies) in a fire. The y may explode. Check with local
waste management codes for special disposal instruc tions.
3. Do not open or mutilate the battery(ies). Release d electrolyte is corrosive and may
cause burns or injury to the eyes or skin. The elec trolyte may be toxic if swallowed.
4. Exercise care in handling batteries in order not  to short the battery to conductive
materials such as rings, bracelets, and keys. The b attery and/or conductor may
overheat and cause burns.
5. Charge the battery(ies) provided with or identifi ed for use with this product only in
accordance with the instructions and limitations sp ecified in this manual.
1Remove the cover by sliding 
while pressing the arrow.
2Replace the battery, and close
the cover. Be sure to charge the
new battery for about 8 hours.
The handset battery is a Nickel-Metal
Hydride battery. You cannot recycle 
this battery.
Using the Belt Clip
You can hang the cordless handset on your belt or p ocket using
the belt clip.
To attach the belt clip To remove the belt clip
Battery Replacement
If  “Recharge ” is displayed and/or  “ ” flashes on the display after being
fully charged, replace the battery with a new Panas onic 
HHR-P506 (PQHHR150AA21) battery. To order, call the  accessories
telephone number on page 1.  
						

							WARNING: 
TO PREVENT FIRE OF SHOCK HAZARD, DO NOT EXPOSE THIS 
PRODUCT TO RAIN OR ANY TYPE OF MOISTURE. 
FCC and other Information
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not c ause harmful interference, and (2)
this device must accept any interference received,  including interference that may
cause undesired operation. 
Privacy of communications may not be ensured when u sing this phone.
CAUTION: 
Any changes or modifications not expressly approved  by the party responsible for
compliance could void the user ’s authority to operate this device.
Note:
This equipment has been tested and found to comply  with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rule s. These limits are designed to
provide reasonable protection against harmful inter ference in a residential
installation. This equipment generates, uses, and c an radiate radio frequency energy
and, if not installed and used in accordance with t he instructions, may cause harmful
interference to radio communications. However, ther e is no guarantee that
interference will not occur in a particular install ation. If this equipment does cause
harmful interference to radio or television recepti on, which can be determined by
turning the equipment off and on, the user is encou raged to try to correct the
interference by one or more of the following measur es: 
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and r eceiver.
— Connect the equipment into an outlet on a circuit d ifferent from that to which the
receiver is connected.
— Consult the dealer or an experienced radio/TV techn ician for help.
Panasonic Consumer Electronics Company, 
Division of Matsushita Electric Corporation of Amer ica
One Panasonic Way, Secaucus, New Jersey 07094 
Panasonic Sales Company, 
Division of Matsushita Electric of Puerto Rico, Inc .
Ave. 65 de Infanter ía, Km. 9.5, San Gabriel Industrial Park
Carolina, Puerto Rico 00985