Panasonic Kx T5200 Operating Instructions Manual

| oPERATroilFRoMTol{EPHol{E mt,-_I 1-_l lABc-l FFnI ltt tzt t3l T----lI lRepeatl lstinl lResetlL_rl-:
Call your unit
Press remote code no.
-To playback all messages,press !.-Io playback new messages,press [.-For repeat, press E.-For skip, pressEl.-To resel the tape atler playback,
press S.-To save lhe messages, hang up
after playback.
When you press a button, press firmly.
-41 - 

To skip grecling message,
press $.
To tum oll lhe answering syslem,press @then hang up.
To re-record greeting message1. Pressfl to re-record firstgreeting message.
0rPress @ to re-record secondgreeung message.
2. Speak after a long beep. Donot pause for over 5 seconds3. When finished, press f,1.
To monitol loom sound, press E.
To change the greeting messageTo firsl greeting;
PressS, then [.To second greeting;
Press f,1, then E.To pre-recorded greeting;
Press $, then S.-The unit will play back thegreeting...

Troubleshooting guide
PROBLEMCAUSE & REMEDY
The unit does not work,
and/or I cannot remove the
tape from the unit.
-Plug in the AC adaptor again.
The answering system is on
but no incoming messages
are recorded.
-The REC TIME selector is set to the
GREETING ONLY position. Change
it to the VOX or 1 MIN position.
-The greeting message is recorded
improperly or not recorded, so no
one can leave a message. Check
and record a new greeting message.
The call counter shows Err. -The greeting message tape is not...

,.s{*14{4j*/}H,]i
PROBLEMCAUSE & REMEDY
I press the dial button of a
touch tone phone after the
unit answers, but the
answering system does not
respond.
-Make sure that you press your
correct remote code number. To
check your remote code number.
(See page 30.)
-The answering system may not
respond if a remote touch tone
phone produces tones that are too
short to activate the unit, so when
you press any button, press firmly.
Some incoming messages
have not been recorded up to
the end.
--Program the CPC...

Maintenance
Tape deck
Since the head and capstan assemblies are in contact with the tape, dirt
and residue from the tape may easily adhere to these parts, causing
distortion. These parts should be cleaned periodically in the manner
described below.
Clean the head surface, pinch roller and capstan with a cotton swab. lf
these surfaces are extremely dirty, wipe them with the cotton swab
dampened with alcohol, then wipe them with a dry soft cloth.
Heads Pinch roller
@@
Notes:-Do not bring magnetic or metal...

Cassette tape-For optimum sound quality and
performance, we recommend
that you use the opposite
side (side-2) after six
months and replace the tape
with a new one every year,
assuming that the unit answers
about ten calls a day.-Never place a cassette tape
near a magnetic source, such
as a magnet or a TV set;
because it may erase or distort
the recorded message on the
tape.-Slack in the tape can be
tightened by rotating the tape
reel with an instrument like a
pencil, as shown.
Cassette panel...

lm portant safety i nstructions
When using this unit, basic safety
precautions as below should
always be followed to reduce the
risk of fire, electric shock, or
personal injury.
1. Read and understand all
instructions.
Follow allwarnings and
instructions marked on this
unit.
Unplug this unit from wall
outlets before cleaning. Do
not use liquid or aerosol
cleaners. Use a damp cloth
for cleaning.
Do not use this unit near
water, for example, near a
bath tub, wash bowl, kitchen
sink, or the like.
Install...

D. lf the unit does not work
normally by following the
operating instructions.
Adjust only controls
covered by the operating
instructions, for improper
adjustment may require
extensive work by a
qualified technician.
E. lf the unit has been
dropped or damaged.
F. lf the unit exhibits a
distinct change in
performance.
During thunderstorms, avoid
using telephones except
cordless types. There may
be a remote risk of electric
shock from lightning.
Do not use this unit to report
a gas leak in the vicinity of...

t
FCC and other information
lf requested by the telephone
company, inform them as follows:
FCC registration No.
(found on the bottom of the unit)
RingerEquivalence . .. O.2B
The particular telephone line to which
the equipment is connected.
This unit must not be connected to a
coin ooerated line.
lf you are on a party line, check with
your local telephone company.
Ringer Equivalence No. (REN):
The REN is useful in determining the
quantity of devices you may connect
to your telephone line and still have...

Note:
This equipment has been tested and
found to comply with the limits for a
Class B digital device, pursuant to
Part 15 of the FCC Rules. These
limits are designed to provide
reasonable protection against
harmful interference in a residential
installation. This equipment
generates, uses, and can radiate
radio frequency energy and, if not
installed and used in accordance with
the instructions, may cause harmful
interference to radio
communications. However, there is
no guarantee that interference will...