Panasonic Kx T2375 Operating Instructions Manual

							11
Preparation
Setting the LCD Contrast
You can select the LCD contrast level from 1 to 4 by programming. Your
phone comes from the factory set to 3.
Make sure that a call is not put on hold.
1
Press (PROGRAM).
2
Press (MUTE).
3
Press (7).
³The current setting is displayed.
4
Press (1)to (4).
³Each time you press a button, the level
will change on the display.
5
Press (PROGRAM).
³A long beep sounds.
³The unit will return to the standby mode.
Selecting the Ringer Volume
You can select the ringer volume to HIGH, LOW or OFF. Your phone
comes from the factory set to HIGH.
Ò
HIGH
RINGEROFF
LOW
RINGER Selector:
Set to HIGH, LOW or 
OFF.
³When set to OFF, the 
unit will not ring. 
						

							ÒSettings
12Wall Template
8.5 cm
To temporarily set the handset
down during a conversation,
place it as shown here.
Wall Mounting
This unit can be mounted on a wall.
1
Pull down the handset hook until it
locks, so the tab holds the handset.
2
Tuck the telephone line cord inside
the wall mounting adaptor, and
push it in the direction of the arrow.
³“UP” should be facing upward.
3
Install screws using the wall
template below. Connect the
telephone line cord. Mount the
unit, and slide down.
Screws
8.5 cm
To Single-Line
Telephone Jack 
						

							13
Basic Operation
Using the speakerphone
1
Press (SP-PHONE/HEADSET).
³The indicator lights.
2
Dial a phone number.
³The dialed number is displayed.
³After a few seconds, the display will show the length of the call.
³If you misdial, press (SP-PHONE/HEADSET)and start again from step 1.
3
When the other party answers, talk into the MIC(microphone).
4
To hang up, press (SP-PHONE/HEADSET).
³The indicator light goes out.
³The display will return to the standby mode.
To redial the last number dialed
Using the handset:Lift the handset Ûpress (REDIAL).
Using the speakerphone: Press 
(SP-PHONE/HEADSET)Û
Ûpress 
(REDIAL).
Making CallsÒ
You can make a call by simply lifting the handset. To hang up, place the
handset on the cradle.
VOLUME (_), (^) 
(SP-PHONE/HEADSET) and Indicator
(HOLD)
(REDIAL)
MIC (Microphone) 
Automatic Redial:
When using the speakerphone, the unit redials the last dialed number up to
15 times within a 10-minute period if the line is busy. During redial, the
SP-PHONE/HEADSET indicator light flashes. 
						

							14
Ò Making Calls
During speakerphone operation
For best performance, please note the following:
³Talk alternately with the other party in a quiet room.
³If the other party has difficulty hearing you, press VOLUME(_)to decrease
the speaker volume.
³You can switch to the handset by lifting it up. To switch back to the
speakerphone, press (SP-PHONE/HEADSET).
To adjust the handset volume (4 levels) or the speaker
volume (8 levels) while talking
To increase, press VOLUME(^).To decrease, press VOLUME(_).
³One level of the handset volume is
shown by “”.
³The display shows the volume level
for a few seconds.³One level of the speaker volume is
shown by “”.
³The display shows the volume level
for a few seconds.
To put a call on hold
Press (HOLD).
³The SP-PHONE/HEADSET indicator light flashes.
³If using the handset, you can place it on the cradle.
³During the hold, the caller will hear music. For canceling music, see page 22.
To release the hold
If the handset is on the cradle, lift the handset.
If the handset is off the cradle, press 
(HOLD).
If using the speakerphone, press 
(SP-PHONE/HEADSET).
³If another phone is connected on the same line, you can also release the hold by
lifting its handset. Ex. Handset volume level: 2Ex. Speaker volume level: 3
³When you dial a phone number in using pulse line or lift the handset off the
cradle, the Ringer indicator also flashes. This is normal. 
						

							Answering Calls
15
Basic Operation
While a call is being received, the unit rings and the ringer indicator
flashes. You can answer it by simply lifting the handset.
Using the speakerphone
1
Press (SP-PHONE/HEADSET).
³The indicator lights.
2
Talk into the MIC (microphone).
3
To hang up, press (SP-PHONE/HEADSET).
³The indicator light goes out.
³When the ringer volume is set to OFF (p. 11), the unit will not ring.
MIC
(SP-PHONE/HEADSET) and Indicator
Ringer Indicator 
						

							16
Storing Phone Numbers in Memory
You can store up to 10 phone numbers in memory. The dialing buttons
(
(0)to (9)) function as memory stations. Do not press any memory stations
before storing to prevent misoperation.
Make sure that a call is not put on hold.
1
Press (PROGRAM).
2
Enter a phone number, up to 22digits.
³If you enter a wrong number, press
(PROGRAM)and start again from step 1.
3
Press (AUTO/LOWER).
4
Press a memory station number ((0)to
(9)).
³A long beep sounds.
³The unit will return to the standby mode.
³If 3 beeps sound, the number entered in step 2 may be over 22 digits. Lift
the handset and place it on the cradle to return to the standby mode, and
start again from step 1.
³You can exit the programming mode in step 1 and 2 by pressing (PROGRAM).
³If a pause is required for dialing, press (PAUSE)where needed. Pressing
(PAUSE)counts as one digit (p. 21).
Speed Dialer
(SP-PHONE/HEADSET) and 
Indicator
(PAUSE)

 Memory Station Numbers
(AUTO/LOWER) (PROGRAM) 
						

							Advanced Operation
17 To erase a stored number
1
Press (PROGRAM).
2
Press (AUTO/LOWER).
3
Press a memory station number ((0)to
(9)) for the phone number to be
erased.
³A long beep sounds.
³The unit will return to the standby mode.
Dialing a Stored Number
1
Lift the handset or press
(SP-PHONE/HEADSET).
2
Press (AUTO/LOWER).
3
Press the memory station number
(
(0)to (9)).
³The stored number is displayed and
dialed. 
						

							18
Storing Phone Numbers in Memory
You can store up to 20 phone numbers in the one-touch auto dial buttons
(10 numbers in UPPER memory locations, 10 numbers in LOWER
memory locations).
Make sure that a call is not put on hold.
To store in an UPPER memory location
It is recommended that you program an emergency number in the
EMERGENCY button.
1
Press (PROGRAM).
2
Enter a phone number, up to 22digits.
³If you enter a wrong number, press
(PROGRAM)and start again from step 1.
3
Press one of the one-touch auto dial
buttons.
³A long beep sounds.
³The unit will return to the standby mode.
³If 3 beeps sound, the number entered in step2 may be over 22digits.
Press (PROGRAM)to return to the standby mode, and start again from
step1.
³If a pause is required for dialing, press (PAUSE)where needed. Pressing
(PAUSE)counts as one digit (p. 21).
Do not press any one-touch auto dial buttons before storing to prevent
misoperation.
One-Touch Dialer
(EMERGENCY)
One-touch auto dial buttons
(PAUSE) (PROGRAM)
(AUTO/LOWER)
(SP-PHONE/HEADSET) and Indicator 
						

							Advanced Operation
19
Ò
To store in a LOWER memory location
1
Press (PROGRAM).
2
Enter a phone number, up to 22digits.
³If you enter a wrong number, press
(PROGRAM)and start again from step 1.
3
Press (AUTO/LOWER).
4
Press one of the one-touch auto dial
buttons.
³A long beep sounds.
³The unit will return to the standby mode.
³If 3 beeps sound, the number entered in step2 may be over 22digits. Lift
the handset and place it on the cradle to return to the standby mode, and
start again from step1.
³If a pause is required for dialing, press (PAUSE)where needed. Pressing
(PAUSE)counts as one digit (p. 21).
To erase a stored number
1
Press (PROGRAM).
2
If the phone number is in an UPPER
memory location, press the one-touch
auto dial button for the phone number
to be erased.
OR
If the phone number is in a LOWER
memory location, press 
(AUTO/LOWER),
then press the one-touch auto dial
button for the phone number to be
erased.
³A long beep sounds.
³The unit will return to the standby mode. 
						

							20
Dialing a Stored Number
From an UPPER memory location:
1
Lift the handset or press
(SP-PHONE/HEADSET).
2
Press the required one-touch auto dial button.
³The stored number is displayed and dialed.
OR
From a LOWERmemory location:
1
Lift the handset or press
(SP-PHONE/HEADSET).
2
Press (AUTO/LOWER).
3
Press the required one-touch auto dial button.
³The stored number is displayed and dialed.
Memory card
Remove the memory card and use it as a name or phone number index
for the stored numbers.
Cover
Memory Card
Ò One-Touch Dialer