Panasonic Hx Wa20 Owners Manual

 VQT4F46 51
∫Recording yourself
Rotate the LCD monitor towards the lens side.
≥ The image is horizontally flipped 
as if you see a mirror image. 
(However the image recorded is 
the same as a normal recording.)
≥
During recording in Slow Motion 
Mode ( l81), the image is not 
horizontally flipped even if you 
rotate the LCD monitor towards the lens side.
∫ If the surface of the unit gets hot
Due to the characteristics of the unit, the outer surface may become 
warm during use, but this does not indicate...

52 VQT4F46
≥Before turning on the unit, remove the lens cap.
≥
Motion pictures are recorded to the SD card if one is inserted. If no SD 
card is inserted, the motion pictures are recorded to the built-in memory.
1Open the LCD monitor.
2Press the recording start/stop button to start 
recording.
A When you begin recording,  ¥ appears.
3Press the recording start/stop button again to pause 
recording.
Basic
Recording motion pictures
/
HX-DC2
HX-WA20HX-WA2HX-DC2
000:00:00000:00:00000:00:00
...

 VQT4F46 53
∫About the screen indications in the motion picture 
recording
Recording mode
Motion picture operation indicator (l 171)
μ  (Red) During motion picture recording
When the remaining recordable time drops to 
approximately 30 seconds or less, 
μ flashes.
(  During recording in Slow Motion Mode 
( l 81),  μ does not flash)
000:00:15 During recording:
Recording time elapsed
Each time the unit is put into recording pause, the 
counter display will be reset to 000:00:00.
During recording standby:...

54 VQT4F46
≥The images recorded between pressing the recording start/stop button 
to start recording and pressing it again to pause recording become one 
scene.
≥ If the file size exceeds 4 GB during recording, the unit saves the file 
and saves the continuation in a new file. (A new file is created 
automatically every 4 GB ( l192))
≥ While recording is in progress, the recording will not stop even if the 
LCD monitor is closed.
≥ Please refer to page 191 for details about approximate recordable 
time....

 VQT4F46 55
≥Before turning on the unit, remove the lens cap.
≥ Still pictures are recorded to SD card if one is inserted. If no SD card is 
inserted, the still pictures are recorded to the built-in memory.
1Open the LCD monitor.
2(For auto focus only) 
Press the   button halfway.
A Focus area (area inside brackets)
3Press the   button fully.
≥If you continue to hold down the   button, you can check the 
recorded image on the LCD monitor.
Basic
Recording still pictures
/
HX-DC2
HX-WA20HX-WA2HX-DC2...

56 VQT4F46
∫About the recording standby screen display
The field of view of the image disp layed on the LCD monitor differs for 
motion picture recording and still picture recording. At time of purchase, 
the recording standby screen displays video view. Press the   button 
halfway to change to photo view.
≥ When [PHOTO VIEW] is set to  (ON), you can change the recording 
standby screen display to the photo view. ( l107)
A Video recording area
∫About the screen indications in the still picture...

 VQT4F46 57
∫About the focusing area
≥When [FOCUS MODE] ( l98) is set to 
[9-PT AUTOFOCUS],   (focusing area  A) 
is displayed at the position where focus is 
achieved.
The unit automatically determines the 
position where focus is achieved from nine 
focus points within the recording area. If the 
focusing area doesn’t appear in a desired position, try adjusting the 
camera angle etc., and focus again.
When focus is achieved over a wide range at the center of the screen, 
a large focusing area is...

58 VQT4F46
About recording still pictures during 
motion picture recording and audio 
recording
You can record still pictures while recording a motion picture or while 
recording audio. (simultaneous recording)
Press the   button fully (press to the bottom) to take 
the picture.
≥When the recordable time drops to approximately 
30 seconds or less, the unit can no longer record still 
pictures while recording a motion picture or while 
recording audio.
∫ About picture size
When you record a still picture...

 VQT4F46 59
≥Audio is recorded to the SD card if one is inserted. If no SD card is 
inserted, the audio is recorded to the built-in memory.
1Open the LCD monitor.
2Select the menu. ( l68)
3Start recording by pressing the recording start/stop 
button.
4Press the recording start/stop button again to stop 
recording.
Basic
Recording audio
[MENU]:   # [REC MODE]  # [ (VOICE RECORD)]1
HX-WA20PPPCPU-VQT4F46_mst.book  59 ページ  ２０１２年２月１４日　火曜日　午後５時１０分 

60 VQT4F46
∫About the screen display for audio recording
≥When the recording time exceeds approximately 5 hours, the file is 
saved and the audio recording ends. Audio operation indicator (
l170)
(Red) During audio recording
When the remaining recordable time drops to 
approximately 30 seconds or less, 
μ flashes.
000:00:15 During audio recording:
Recording time elapsed
Every time recording is stopped, the indicator 
returns to 000:00:00.
During audio recording standby:
Approximate remaining recordable...