Panasonic Household Massae Lounger Ep30007 Operating Instructions

 8
11  Massage Area Display
Flashes to indicate areas 
currently being massaged
In the Massage Area Display, 
positions are estimated. 
Therefore, there may be some 
differences between the actual 
sensation and the display.
12
  Back Intensity/Speed Display
Intensity and speed of the 
massage heads are displayed.
The speed is displayed only in the 
manual operation.
13
  Manual Upper Body Complex 
Operation Display
Indicates optional operations 
added to manual upper body 
operation
See page 25
TAP 1...

9
Setting up the massage lounger
1Where to use the unit
Ensure there is adequate space to recline.
Caution
Do not use the unit in areas with high humidity, 
such as the bathroom, because this can lead to 
electric shock or other accidents.
Place the unit on a totally flat surface. 
Failure to do so may result in the unit tipping over.
•
•
Do not expose the massage lounger to direct sunlight or high 
temperatures, such as in front of a heater, etc., as this can cause 
discoloration or hardening of the...

 10
Confirm that the main unit and the accessories are in the box.
Main unit
Accessories
• Armrests (Right/Left)
Left/Right indication
Air plug
Small holes on the inside fabric are an intentional 
part of the functional design.• Pillow• Control Panel Stand
Fixing screw
Control panel 
holder
Clip
• Control Panel Stand Covers
• Attachment Screws (M6 × 16) — 7
• Allen Key — 1(Cross-section)0.2" 
(4 mm)• Shoulder Plates• Sole Reflexology Plates
This is installed on the sole 
massage section prior to...

11
1Attaching the 
armrests
 (On both the right and left 
sides)
1. Insert the armrest into the 
unit.
Be careful to a v

oid pinching 
your fingers.
•
Assembly
2.
 Fasten the armrest with the 
attachment screws.
Set the two attachment 
screws in place by hand 
first and then tighten 
firmly with the allen key.
Use this Screw
Attachment Screw (M6 × 
16)
  × 4
Make sure that the seat 
surface is not damaged.
2Connecting the air plugs
(On both the right and left sides)
Insert the air plugs into the unit....

 12
3Attaching the control panel stand to the right or left side panel of the unit
(Diagram shows attachment to right armrest.)
The position of the control panel when seated can be 
selected by choosing the appropriate hole for the screw.
NearApprox.  
20˚
Far
4Attaching the control panel stand covers
(On both the right and left sides)
The method for attaching the covers is the same for both sides. 
The diagram shows the side where the control panel stand is 
attached.
1. Inser
t the top tabs on the co...

13
When removing the control panel stand cover
1. Insert the head of a flat-tip screwdriver in the gap 
under the mark (O).
2.  Push the bottom tab of the cover up to lift the co ver

.
3.  Perform the same procedures as 1 and 2 above for 
the other gap.
4.  Pull the co
ver up diagonall

y.
Performing this procedure with the allen key or a 
Phillips screwdriver could damage the unit.
•
5Raising the backrest to the 
upright position
1.
 Insert the power plug into the power outlet.
2.  Confirm the key lock...

 14
Moving the control panel cord to the left side (when control panel stand is on left 
side)
1. Press the  button on the control panel to turn on the power.
2.  Press the 
 button on the control panel and hold until the legrest 
has risen far as it will go.
Continue pressing until a “beep-beep-beep” sound is heard.
3.  Remove the contr ol panel cor

d from the cord-holder groove.
4.  Move the control panel cord under the legrest to the left side.
5.  Fasten the control panel cord at two points in the...

15
8Attaching the pillow
1. Attach the pillow to the velcro fasteners.
See page 38 for a guide to the position of the pillow
Pillow
Velcro 
fasteners
•
2.
 Fasten the contr ol panel cor
 d using the clip.
Clip
Control panel cord Fasten the cord so that the 
portion under the clip is 
not slack. Lift the control panel to remove.
1.
 Insert the plate into the pocket on the outer shoulder 
massage unit.
Grasp the pocket and pull it slightly to expand the 
opening, so that the plate can be inserted easily....

 16
Before sitting down
Check the following before using the unit
1Check the surrounding area
Make sure there are no objects, people, or pets in the vicinity of the unit.
2Check the power cord and the power plug
Warning
Remove dust from the power plug periodically. 
Failure to observe this precaution may result in 
defective insulation of the cord due to moisture. 
Clean dust from the cord using a dry cloth.
Do not damage the power cord and the power 
plug. 
(Do not damage, expose to heat sources, bend,...

17
3. Make sure the massage heads are in the retracted position.
Caution
Sit on the unit after confirming the massage 
heads are in the retracted position. 
Failure to observe this precaution may result in 
accident or injury.
•
When the massage heads are not in the retracted position Press the 
 button twice to return the massage heads to the 
retracted position.
4.  Make sure the legrest is in the fully lo wered position.
Caution
Do not stand on the legrest or place any object on 
it when the legrest...