Panasonic Home Network System Kx Hn Users Guide

→ If many notifications were sent from the hub in a short time, notifications may be received late. Thisis a characteristic your mobile device’s notifications service.
The siren stops sounding or flashing before I cancel an alert
R When the alarm system is triggered, the hub signals the siren to begin sounding or flashing its strobe
light. If the alert has not been canceled, the hub signals the siren to stop sounding or flashing 1 minute
later. If for some reason the hub cannot signal the siren, the...

Smart plugs stay on longer than they should be
R If you configure a smart control scenario to turn on a smart plug when triggered by a sensor, and if the
sensor is triggered multiple times, the smart plug may stay turned on longer than anticipated.
→ This is not a malfunction. The smart plug stays turned on for the set amount of time each time the sensor is triggered. If the sensor is triggered again before the previous “power on” time ends, the
smart plug may stay turned on longer than you anticipated....

→ Format the card ( “SD card formatting”, Page 66).
R You just inserted the SD card into the hub.
→ Wait and try again.
[Failed] is displayed
R An error occurred while saving the picture.
→ Check all connections and try again.
Colors in camera images appear different from normal
R The camera is aimed at a dark location, or it is nighttime.
→ If there is not adequate light to illuminate the subject, such as at night, the camera automatically switches to night vision mode. In this case, colors may appear...

– Areas where animals move in a limited area, such as birds in a nest or small animals close to theground
– Areas where brightness significantly, such as when shadows form in the afternoon, lights turn on at night, or vehicles pass by at night with their headlights or brakelights on
You can prevent these false detections by adjusting the position of the camera, by limiting the
detection area so that the camera ignores motion in unneeded areas of the camera’s image
( “Detection area”, Page 65), or by...

→ Arm the alarm system ( “Arming and disarming the alarm system”, Page 45).
R The sensor is not enabled for the current arm mode.
→ Change the settings for the current arm mode ( “Alarm system settings”, Page 46).
R The desired feature is not enabled.
→ Temperature alert (indoor cameras only) and sound alert (indoor camera only) do not function as part of the alarm system. Make sure the desired feature is enabled ( “Temperature alert (indoor
cameras only)”, Page 62,  “Sound alert (indoor cameras only)”,...

→ Use a cordless handset to change the call restriction feature settings as appropriate. Refer to theOperating Instructions included with your cordless handset. (Note that this feature is supported by
certain models only.)
I cannot use phone features
R You are away from home or your mobile device is not connected to the same wireless router as the
hub.
→ Connect your mobile device to the same wireless router as the hub.
R The hub is not connected to your landline.
→ Connect the hub to your landline....

Compatible environments
For best results when viewing this document, we recommend the following environments.
When using a computer
– Internet Explorer 9 or later
– Firefox, latest version
– Google Chrome, latest version
– Safari 4.1 or later
When using a mobile device
– iOS 6.0 or later
– Android 4.1 or later
Note:
R Internet Explorer 8 and earlier versions are not supported.
R Some content may not be displayed properly when using Android 4.0.
Terms used in this document
R The hub supports microSD and...

118
Notes 

119
Notes 

 PNQP1107MA/eng   CC1014WK12016