Panasonic Hdc Sx5 Operating Instructions

Others
141VQT1J42
ProblemCheck points
This unit cannot be 
operated though it is 
turned on.
This unit does not 
operate normally.≥The unit cannot be operated unless you open the LCD monitor or 
extend the viewfinder.
≥Press the RESET button. (l145) If normal conditions are not 
restored yet, remove the battery or AC adaptor, wait about 1 minute 
and then reconnect the battery or AC adaptor. Then about 1 minute 
later, turn on the power again. (Conducting the above operation 
when the access lamp is on...

Others
142VQT1J42
ProblemCheck points
The disc cannot be read.≥Are there fingerprints or dirt on the surface of the disc?
#If there are fingerprints or dirt on the disc, wipe them off. (l30)
Recording does not start 
although power is 
supplied to this unit and 
the disc or SD card is 
correctly inserted.≥(HD mode) Has the DVD-RW, DVD-R or DVD-R DL been finalized?
#After finalizing, the discs become play-only and cannot record. If 
you un-finalize a DVD-RW, it can be used for recording. (l96)
≥(STD mode)...

Others
143VQT1J42
ProblemCheck points
Recorded still pictures 
are not clear.≥Are you trying to record small or finely detailed objects with 
[PICT.QUALITY] set at [ ]?
#If you try to record small or finely detailed objects with 
[PICT.QUALITY] set at [ ], the images may break up into a 
mosaic-like pattern. Record with [PICT.QUALITY] set at [ ] 
instead. (l60)
Sound is not played back 
from the built-in speaker 
of this unit.≥Is the volume too low?
#During playback, move the volume lever to display the...

Others
144VQT1J42
ProblemCheck points
Even if a disc or an SD 
card is formatted, it 
cannot be used.≥Either this unit or the disc or SD card may be damaged. Please 
consult a dealer. Use an SD card from 8 MB to 8 GB with this unit.
If the SD card is inserted 
in this unit, it is not 
recognized.≥Is the SD card formatted on a computer inserted?
#Use this unit to format SD cards. Please be aware that if an SD 
card is formatted, then all the data recorded on the card will be 
erased. (l94)
If the SD card...

Others
145VQT1J42
ªWhen connected to another device
ProblemCheck points
“PUSH THE RESET 
SWITCH.” or “CHECK 
THE DISC AFTER 
PUSHING THE RESET 
SWITCH TO REPAIR THE 
DISC.” is displayed.≥Is the disc scratched or dirty?
#After using the following method to restart the unit, eject the disc 
and clean it. (l30) If there are scratches on the disc, use a new 
disc.
≥The unit has automatically detected an error. Press the RESET 
button with the projecting part of the grip belt A. This will restart the 
unit....

Others
146VQT1J42
ªWith a computer
ProblemCheck points
Even if connected by the 
USB cable, this unit is not 
recognized by the 
computer.≥Is the AC adaptor connected?
#Use the AC adaptor when connecting this unit and a computer.
≥Select another USB terminal on the computer.
≥Check the operating environment. (l115)
≥Turn the power to the unit off and then back on again and reconnect 
the USB cable.
When the USB cable is 
disconnected, an error 
message will appear on 
the computer.≥To disconnect the USB...

Others
147VQT1J42
The images may be still for several seconds at the joins between the scenes if the following operations 
are performed when multiple scenes have been continuously played back using another unit.
* Just how smoothly the scenes will be played back continuously depends on the playback unit. 
Depending on the unit used, the images may stop moving and become still for a moment even when 
none of the following conditions are applicable.
ªWhen the scenes were recorded on different dates
AThe...

Others
148VQT1J42
ªWhen PRE-REC was used for recording
1Normal recording
2PRE-REC recording
AThe picture momentarily stops at the end of the last scene that was recorded normally before 
PRE-REC recording.
ªWhen the recording mode was changed from HN/HE to HG or from HG to 
HN/HE
AThe picture momentarily stops where the scenes switch between HN/HE and HG modes.
BPlayback is smooth if the same mode is used or the mode is switched between HN and HE.
ªWhen deleting scenes
e.g. 1: Deleting scenes midway...

Others
149VQT1J42
e.g. 2: When recording again after having deleted the last scene.
1Scene to be deleted
2A new scene is recorded here.
AThe image will be still for several seconds wherever a scene was deleted.
BThe images of consecutive scenes where they are no deletions are played back smoothly one after 
another.
ªWhen editing scenes on a computer using a program such as HD Writer 
2.0E for SX/SD
e.g. 1: When scenes were selected using HD Writer 2.0E for SX/SD and output  to the 
media
If scenes were...

Others
150VQT1J42
e.g. 2: When deleting scenes was initiated by HD Writer 2.0E for SX/SD
When a scene is deleted, the images may be still for several seconds where that scene was deleted.
e.g. 3: When merging scenes was initiated by HD Writer 2.0E for SX/SD
Wherever scenes are merged, the images may be still for several seconds where the original scenes 
were split.
VQT1J42ENG.book  150 ページ  ２００７年７月２０日　金曜日　午前１０時３６分