Panasonic Hdc Sd90 Owners Manual

21VQT3J56
Charging and recording time
∫Charging/Recording time
≥Temperature: 25 oC (77 oF)/humidity: 60%RH
≥ The stated times are when the AC adaptor is used.
 
≥These times are approximations.
≥ The indicated charging time is for when the battery has been discharged completely. 
Charging time and recordable time vary depending on the usage conditions such as 
high/low temperature.
≥ Recordable time of 3D recording mode is the same.
(During 3D recording mode, 1080/60p and iFrame recording mode cannot be...

22VQT3J56
The unit can record still pictures or motion pictures to an SD card or built-in memory. To 
record to an SD card, read the following.
Cards that you can use with this unit
Use SD cards conforming to Class 4 or higher of the SD Speed Class Rating* for 
motion picture recording.
* SD Speed Class Rating is the speed standard regarding continuous writing. 
Check via the label on the card, etc. e.g.:
≥
Please confirm the latest information abo ut SD Memory Cards/SDHC Memory Cards/
SDXC Memory Cards...

23VQT3J56
Inserting/removing an SD card
Caution:
Check that the access lamp has gone off.
1Open the SD card cover and 
insert (remove) the SD card 
into (from) the card slot B.
≥Face the label side  C in the direction 
shown in the illustration and press it 
straight in as far as it will go.
≥ Press the center of the SD card and then 
pull it straight out.
2Securely close the SD card 
cover.
≥Securely close it until it clicks.
≥Do not touch the terminals on the back of 
the SD card.
≥ Do not apply strong...

24VQT3J56
You can turn the unit on and off using the power button or by opening and closing the LCD monitor.
Turning the unit on and off with the power button
Open the LCD monitor and press the power button to turn on the unit.
AThe status indicator lights on.
Turning the unit on and off with the LCD monitor
The unit is turned on when the LCD monitor is opened, and the unit is turned off when it is closed.During normal use, opening and closing of the LCD monitor can be conveniently used 
to turn the unit...

25VQT3J56
Slide the mode switch to switch between recording and playback.
Operate the mode switch to change the mode to  ,   or  .
You can operate by directly touching the LCD monitor (touch screen) with your finger.
It is easier to use the stylus pen (supplied) for detailed operation or if it is hard to operate with 
your fingers.
∫Touch
Touch and release the touch screen to select icon or 
picture.
≥Touch the center of the icon.
≥ Touching the touch screen will not operate while 
you are touching...

26VQT3J56
∫About the operation icons
///:
These icons are used to switch the menu and thumbnail 
display page, for item selection and setting etc.
:
Touch to return to the previous screen such as when 
setting menus.
About the Touch Menu
Touch   (left side)/  (right side) of   on the Touch Menu to switch the operation icons.
Touch   (left side)/  (right side) of   on the Touch Menu.
≥ It is also possible to switch the operation icons by sliding the Touch Menu right or left while 
touching it.
B Touch...

27VQT3J56
≥Perform the touch screen calibration when the touch is not recognized or wrong location is 
recognized. ( l46)
When the unit is turned on for the first time, a message asking you to set the date and time 
will appear.
Select [YES] and perform steps 2 to 3 below to set the date and time.
1Select the menu. ( l39)
2Touch the date or time to be set, then set the desired value using 
/.
A Displaying the World time setting ( l40):
[HOME]/ [DESTINATION]
≥ The year can be set between 2000 and 2039.
≥...

28VQT3J56
∫Basic camera positioning
1 Hold the unit with both hands.
2 Put your hand through the grip belt.
3 It is convenient to use the Recording button icon  A when holding the unit at waist level.
≥ When recording, make sure your footing is stable and there is no danger of colliding with 
another person or object.
≥ When you are outdoors, record pictures with the sunlight behind you. If the subject is 
backlit, it will become dark in the recording.
≥ Keep your arms near your body and separate your...

29VQT3J56
The card and built-in memory can be selected separately to record motion pictures or still 
pictures.
1Change the mode to  or .
2Select the menu. ( l39)
3Touch the media to record motion pictures or still pictures.
≥The media is selected separately to motion pictures or still pictures is highlighted in yellow.
4Touch [ENTER].
Basic
Selecting a media to record [HDC-TM90]
: [MEDIA SELECT]
A[VIDEO/SD CARD]
B [VIDEO/Built-inMemory]
C [PICTURE/SD CARD]
D [PICTURE/Built-inMemory]MENU

 ...

30VQT3J56
1Change the mode to  .
2Open the LCD monitor.
3Press the recording start/stop 
button to start recording.
AWhen you begin recording, ;  changes 
to  ¥.
B Recording button icon
≥ Recording can also be started/stopped by touching the Recording button icon. This icon 
functions in the same manner as the recording start/stop button.
4Press the recording start/stop button again to pause recording.
∫ Screen indications in the Motion Picture Recording Mode
≥There are 3 recording formats that can be...