Panasonic Gh5 Manual

181
7. Recording Motion Pictures
∫[Rec Format] and [Rec Quality] settings available for recording
[Rec Format][System Frequency][Rec Quality]
[AVCHD] s
[MP4] [59.94Hz (NTSC)]
[FHD/28M/60p]
[FHD/20M/30p]
[50.00Hz (PAL)] [FHD/28M/50p]
[FHD/20M/25p]
[24.00Hz (CINEMA)] s
[MP4 (LPCM)] [MOV] [59.94Hz (NTSC)]
[FHD/8bit/100M/60p]
[FHD/8bit/100M/30p]
[FHD/8bit/100M/24p]
[50.00Hz (PAL)] [FHD/8bit/100M/50p]
[FHD/8bit/100M/25p]
[24.00Hz (CINEMA)] [FHD/8bit/100M/24p]
• Brightness is measured and focus is done in the...

7. Recording Motion Pictures
182
Set the functions available only for Creative Video Mode.
Select the menu. (P55)
You can perform recording suited to an anamorphic lens. Motion pictures in 4K resolution 
will be recorded with an aspect ratio of 4:3.
1Select the recording format that supports [Anamorphic(4:3)].  (P55)
• Recording with [AVCHD] or [MP4] is not possible.
2Select the recording quality.
[Creative Video] menu
> [Creative Video]
[Anamorphic(4:3)]
> [Motion Picture]  > [Rec Format]  > [MP4...

183
7. Recording Motion Pictures
Even when recording uses up the card’s free space, the camera continues the recording 
by deleting the oldest segment of the recorded data.
• Only available when [Rec Format] is set to [MP4 (LPCM)] or [MO V] in Creative Video 
Mode.
Settings: [ON]/[OFF]
• While recording is in progress, the elapsed recording time is  indicated with [ ] ( A) and the available recording time ( B) 
decreases.
• When recording uses up the card’s free space, the available  recording time...

7. Recording Motion Pictures
184
Fine-adjust the shutter speed to reduce flickering and horizontal stripes.• This function is available when [Exposure Mode] is set to eith er [S] or [M] in Creative 
Video Mode.
1Select the menu.  (P55)
2Select Shutter Speed with  2/1, and then press 
[MENU/SET] .
A Shutter speed
• Adjust the shutter speed while looking at the screen so that 
flickering and horizontal  stripes will be minimized.
• If you press and hold  2/1, the shutter speed will be 
adjusted faster.
•...

185
7. Recording Motion Pictures
You can switch the units of shutter speed values and gain (sensitivity) values.
You can display wave forms on the recording screen.
1Select the menu. (P55)
2Press 3/4 /2 /1  to select the display position, and press [MENU/SET].• Direct touch operation is also possible from the recording scr een.
Not available in these cases:• This function is not available in the following cases:
– When [Photo Style] is set to [V-Log L]
[SS/Gain Operation]
[SEC/ISO] Displays the shutter...

7. Recording Motion Pictures
186
Apply LUT (Look-Up Table) data to the recording screen image when [Photo Style] is set to 
[V-Log L].
• This function becomes available only after being activated in  [Activate] (P241) with an 
upgrade software key (DMW-SFU1: optional).
• Only available when [Photo Style] is set to [V-Log L].
∫ Importing LUT files• Supported LUT data format:
– The “.vlt” format, which meets the requirements specified in the “VARICAM 3DLUT  REFERENCE MANUAL Rev.1.0”
– File names consisting...

187
7. Recording Motion Pictures
Recording Motion Pictures Using a Connected 
External Device
You can connect the camera’s [HDMI] socket and an external monitor or recorder with an 
HDMI cable. HDMI output is contro lled separately for recording and playback. This section 
describes the HDMI output control for recording.
• Playback signals are output using the [HDMI Mode (Play)] setti ng in [TV Connection] of the 
[Setup] menu.  (P239)
• Use a “High Speed HDMI cable” with the HDMI logo. Cables that do...

7. Recording Motion Pictures
188
5Connect the HDMI cable to the [HDMI] 
socket (8).
BLeave some slack so that this section has 
a length of at least 10 cm (0.33 feet).
• You can also connect the HDMI cable and 
USB connection cable at the same time 
when the cable holder is attached.
Removing the cable holder
To remove the cable holder, follow the steps for attaching it i n the reverse order.
∫ Notes on images output via HDMI (sorted by Recording Mode)
• When [Rec Area] is set to [ ] in a mode except...

189
7. Recording Motion Pictures
∫Setting the output bit value for 4K/60p (4K/50p)
Settings: [4:2:2 10bit]/[4:2:0 8bit]
• Motion pictures cannot be recorded to the card at [4:2:2 10bit]  during HDMI output.
• This item works only when [Rec Quality] is set to [4K/8bit/150 M/60p] or [4K/8bit/150M/50p] in 
Creative Video Mode.
∫ Setting the picture quality (size/frame rate) for HDMI output
Down-convert the size/frame rate when the motion picture size i s set to [4K] or [C4K] in 
[Rec Quality].
• When [Down...

7. Recording Motion Pictures
190
• When [System Frequency] is set to [50.00Hz (PAL)]:
¢2 Output at 1080/50.00p if the connected device does not support  the value.
• When [System Frequency] is set to [24.00Hz (CINEMA)]:
∫ Setting the information displayed during HDMI output
Shows or hides the displays of information.
• Waveforms in [WFM/Vector Scope] cannot be output to HDMI devic es.
∫Outputting control information to an external recorderSet whether or not to output control information for recording...