Panasonic DP 1515P User Manual

21
Function
07 DIGITAL SKYSHOT Selects the default digital skyshot mode. 2:NORMAL
1:OFF / 2:NORMAL / 3:QUALITY
09 AUTO EXPOSURE Selects whether the auto exposure is enabled. 2:VALID
1:INVALID / 2:VALID
10 SORT PRIORITY ADF Selects the sort priority when using the ADF. 2:SORT
1:NON-SORT / 2:SORT
11SORT PRIOR. GLASS Selects the sort priority when using the Platen. 1:NON-SORT
1:NON-SORT / 2:SORT
19 KEY OPERATOR MODE Inputs the key operator password.
ENTER PASSWORD = 
■ Copier Settings
No.
Modes...

Function
22
For Example
■Changing the Paper Size (Paper Tray)
The Paper Trays are designed to accommodate A5, A4, B4 and A3 Size paper.
1
Press the FUNCTION key.
FUNCTION key
2
Select  1: GENERAL SETTINGS.
6
Press START key.
7
Select a Paper Size with  /
 key.
Enter 1 with keypad.
Press START key.
FUNCTION MODE (1-2)
ENTER NO. OR ∨ 
^
3
Enter 9 with keypad to select
09  KEY OPERATOR MODE.
GENERAL PARAM. (0-9)
ENTER NO. OR ∨ 
^
4
Enter key operator password
(3-digit) with key pad.
09 KEY OPERATOR MODE...

23
Function
●It is recommended that the paper guide B is fixed in place with a screw, consult your authorized service provider for
details on how to fasten the guide.
10
Pull out the Paper Tray.
11
Adjust the Paper Guide B to the
paper width.
12
Adjust the Paper Guide A to the
paper length.
13
Reinstall the Paper Tray.
Paper Tray
Paper Guide B
Paper Guide A
Paper Tray
Downloaded From ManualsPrinter.com Manuals 

Problem Solving
24
CheckAction
Unit Does Not Operate
Check if the Power Switch (Main Power Switch
on the Right Side of the machine) is turned ON
and if the power cord is plugged into the AC
outlet. Does the display light?
Press Energy Saver key on the control panel. Does the Energy Saver key flash (or light)
and the display is turned OFF?
(See page 18)
Perform actions in accordance with each
message. Does any of the U## codes and messages
appear on the display?
(U01, U07, U13, U14....etc.)
Add paper....

25
Problem Solving
Code Check Points
J70, Remove misfed Paper.
J71, (See page 32)
J79,
J92,
J93,
CheckAction
Marked Copies
Clean the Platen Glass or Sheet. Is the machine’s Platen Glass or Platen Sheet
dirty?
Cover the original with a sheet of white paper
before copying or lighten the exposure setting. Is the original an OHP film or a dark original?
Clean the Corona Wire of the Drum Unit.
(See page 28)
Check the copies.
If a dark vertical line is remained, repeat
above step to clean the Corona Wire...

Problem Solving
26
Maintenance
■ Adding Paper
●Paper Tray
1
Pull out the Paper Tray.
2
Load paper.
Paper TrayPaper Tray
3
Reinstall the Paper Tray.
NOTE
●When changing the paper size, refer to page 22.
Max Level
Indicator
Face Up
Paper Weight: 60 - 90 g/m2
Paper Capacity: 550 Sheets (80 g/m2)
●Make sure that the paper is set properly
and that it does not exceed the Max.
Level indicator.
Downloaded From ManualsPrinter.com Manuals 

27
Problem Solving
●Sheet Bypass
Copying on Special Paper, etc.
1
Open the Sheet Bypass.
2
Pull the Sheet Bypass.
4
Load paper.
(Do not exceed limit guides)
3
Adjust the Width Guides.
●Incorrect adjustment may cause the paper
to wrinkle, misfed or skew.Paper Weight: 55-133 g/m
2
Paper Capacity: 50 sheets / 80 g/m2
To add paper to the Sheet Bypass, remove the
leftover paper from the tray, and align it with the
additional paper and load them together onto
the tray.
PUSH
Sheet Bypass
Until it stops
Width...

Problem Solving
28
■ Replacing Toner Bottle/Toner Waste Container
1
Open the Front Cover.
2
Remove the old Toner Waste
Container.
4
Turn the Empty Toner Bottle to
counter clockwise, then remove
the old Toner Bottle.
3
Equip the Cap to the hole of
container.
●Do not reuse the toner from the Toner
Waste Container.
Maintenance
●For optimum copy quality use the recommended Panasonic Toner.
Do not unseal the Toner Bottle unless you are ready to use it.ATTENTION
5
Turn the Corona Cleaner Handle.
Front Cover...

29
Problem Solving
6
Slide the Corona Cleaner in and
out 3 or 4 times slowly, then return
the Corona Cleaner Handle to
original position.
7
Shake the New Toner Bottle well.
9
Turn the New Toner Bottle to
clockwise.
8
Install the New Toner Bottle.
10
Install the New Toner Waste
Container, then close the Front
Cover.
●Do not reuse the toner from the Toner
Waste Container.
To  Lock
Toner Bottle (New)
Corona Cleaner
Toner Bottle (New)
Toner Bottle (New)
Toner Waste 
Container (New)
Downloaded From...

Problem Solving
30
■Removing Misfed Paper (Paper Exit Area) (J46)
1
Open the Left Cover.
2
Turn the Jam Removal Knob.
4
Close the Left Cover.
●Do not scratch or touch the surface of the OPC Drum (Green) with bare hands. The OPC Drum is
sensitive to light.
To prevent optical exposure problems, do not expose the OPC Drum to direct sunlight or bright light.ATTENTION
3
Remove misfed paper.
●Make sure that the Jam Error Code and Misfed
Indicator disappears after removing the misfed paper.
●The Jam Error Code...