Panasonic Dmc Fx48 Operating Instructions Manual

11VQT1X57
Before Use
11 Camera ON/OFF switch (P17)
12 Zoom lever (P34)
13 Speaker (P84)
14 Microphone (P59, 76, 95)
15 Shutter button (P28, 59)
16 Mode dial (P27)
17 Hand strap eyelet•
Be sure to attach the hand strap when 
using the camera to ensure that you will 
not drop it.
18 Lens barrel
19 [COMPONENT OUT] socket (P104)
20 [AV OUT/DIGITAL] socket (P97, 99, 103)
21 Tripod receptacle
•When you use a tripod, make sure the 
tripod is stable when the camera is 
attached to it.
22 Card/Battery door (P14)...

VQT1X5712
Preparation
P reparationCharging the Battery
∫About batteries that you can use with this unit
The battery that can be used with this unit is DMW-BCF10PP.
•
Use the dedicated charger and battery.•This unit has a function that can distinguish useable batteries. Exclusive batteries  
(DMW-BCF10PP) are supported by this function. (Conventional batteries not supported 
by this function cannot be used)
•The battery is not charged when the camera is shipped. Charge the battery before use.•Charge the...

13VQT1X57
Preparation
∫When the [CHARGE] indicator flashes
•The battery temperature is excessively high or low. The charging time will be longer than 
normal. Also, charging may not be completed.
•The terminals of the charger or the battery are dirty. In this case, wipe them with a dry cloth.
Note
•After charging is completed, be sure to disconnect the power supply device from the electrical 
outlet.
•The battery becomes warm after using it and during and after charging. The camera also 
becomes warm...

VQT1X5714
Preparation
The number of recordable pictures and playback time will vary depending on the 
operating conditions and storing condition of the battery.
∫ Charging
Charging time and  number of recordable pictures with the optional battery pack 
(DMW-BCF10PP) are the same as above.
The charging time  will vary slightly depending on the status of the battery and the 
conditions in the charging environment.
When the charging has been completed successfully, the [CHARGE] indicator turns off.
Note
•...

15VQT1X57
Preparation
1:Close the card/battery door.
2 :Slide the release lever in the direction 
of the arrow.
•If the card/battery door cannot be completely 
closed, remove the card, check its direction and 
then insert it again.
Note
•Remove the battery after use. Store the removed battery in the battery case (supplied).•Do not remove the battery until the LCD monitor and the status indicator (green) turn off as the 
settings on the camera may not be stored properly.
•The supplied battery is designed...

VQT1X5716
Preparation
About the Built-in Memory/the Card
•Memory size: Approx. 40 MB•Recordable motion pictures: QVGA (320k240 pixels) only•The built-in memory can be used as a temporary storage device when the card being used 
becomes full.
•You can copy the recorded pictures to a card. (P96)•The access time for the built-in memory may be longer than the access time for a card.
The following types of cards can be used with this unit.
(These cards are indicated as  card in the text.)
¢The SDHC Memory...

17VQT1X57
Preparation
Note
•Do not turn this unit off, remove its battery or card or disconnect the AC adaptor 
(DMW-AC5PP; optional) when the access indication is lit [when pictures are being read 
or deleted or the built-in memory or the card is being formatted (P26)]. Furthermore, do 
not subject the camera to vibration or impact. The card or the data on the card may be 
damaged, and this unit may no longer operate normally.
•The data on the built-in memory or the card may be damaged or lost due to...

VQT1X5718
Preparation
Press [MENU/SET] to set.
•After completing the clock settings, turn the camera off. Then turn the camera back on, 
switch to Recording mode, and check that the display reflects the settings that were 
performed.
•When [MENU/SET] has been pressed to complete the settings without the clock having 
been set, set the clock correctly by following the “Changing the clock setting” procedure 
below.
Select [CLOCK SET] in the [REC] or [SETUP] menu, and press  1. (P20)
•It can be changed in...

19VQT1X57
Preparation
Setting the Menu
The camera comes with menus that allow you to choose the settings for taking pictures 
and playing them back just as you like and menus that enable you to have more fun with 
the camera and use it more easily.
In particular, the [SETUP] menu contains some important settings relating to the camera’s 
clock and power. Check the settings of this menu before proceeding to use the camera.Note
Due to the camera’s specifications, it may not be possible to set some of the...

VQT1X5720
Preparation
This section describes how to select the Normal picture mode settings, and the same 
setting can be used for the [PLAYBACK] menu and [SETUP] menu as well.
Example: Setting [AF MODE] from [
Ø] to [š] in the Normal picture mode
Setting menu items
Turn the camera on.
A [MENU/SET] button
B [REC]/[PLAYBACK] selector switch
C Mode dial
Slide the [REC]/[PLAYBACK] selector 
switch to [ !].
•When selecting the [PLAYBACK] mode menu 
settings, set the [REC]/[PLAYBACK] selector switch to 
[( ],...