Home
>
Panasonic
>
Projector
>
Panasonic DLP Based Projector PT-DZ110XE PT-DS100XE PT-DW90XE Operating Instructions
Panasonic DLP Based Projector PT-DZ110XE PT-DS100XE PT-DW90XE Operating Instructions
Here you can view all the pages of manual Panasonic DLP Based Projector PT-DZ110XE PT-DS100XE PT-DW90XE Operating Instructions. The Panasonic manuals for Projector are available online for free. You can easily download all the documents as PDF.
Page 11
Precautions with regard to safety ENGLISH - 11 Important Information Do not allow children to reach the AA/R6 batteries. The battery can cause personal injury if swallowed. z If swallowed, seek medical advice immediately. z If the battery fluid leaks, do not touch it with bare hands, and take the following measures if necessary. Battery fluid on your skin or clothing could result in skin inflammation or injury . z Rinse with clean water and seek medical advice immediately. Battery fluid coming...
Page 12
Precautions with regard to safety 12 - ENGLISH Important InformationCAUTION POWER When disconnecting the power cord, be sure to hold the power plug and power connector. If the power cord itself is pulled, the lead will become damaged, and fire, short-circuits or serious electric shocks will result. When not using the projector for an extended period of time, disconnect the power plug from the wall outlet and remove the batteries from the remote control. Disconnect the power plug from the...
Page 13
Precautions with regard to safety ENGLISH - 13 Important Information Cautions when installing After removing the projection lens, install the dust sponge attached to the projector. If the dust sponge is not installed, dust will be accumulated inside and\ can cause a trouble. Do not use under the following conditions. Do not set up the projector outdoors. z The projector is designed for indoor use only. Avoid setting up in places which are subject to vibration or shocks. z If the...
Page 14
Precautions with regard to safety 14 - ENGLISH Important Information Cautions when setting the projectors 1 When installing and using the projector with a method other than floor standing installing using adjustable z feet, fix it with the 5 ceiling mounting screws (shown in the figure). (Screw diameter: M6, Tapping depth inside set: 8 mm) Make a clearance of at least 5 mm between the projector bottom and setti\ ng surface by inserting spacers z (metallic) etc. between them. The...
Page 15
Precautions with regard to safety ENGLISH - 15 Important Information Cautions when setting the projectors 2 When placing the projector in confined space, a ventilation or air conditioning system must be equipped, and z keep enough ventilation space on the rear and both sides of the projecto\ r. Make a clearance of at least 5 mm between the projector bottom and setti\ ng surface by inserting spacers z (metallic) etc. between them. z Do not stack the projectors without using frame or...
Page 16
Precautions with regard to safety 16 - ENGLISH Important Information Do not touch the surface of the projector lens with your bare hand. If the surface of the lens becomes dirty from fingerprints or anything else, this will be magnified and projected onto the screen. Please put the lens cover on the projector when you do \ not use it. Do not move the projector while it is operating or subject it to vibration or impact. The service life of its internal components will be shortened....
Page 17
Precautions with regard to safety ENGLISH - 17 Important Information Accessories Make sure the following accessories are provided with your projector. Remote control (x1) (N2QAYB000550) Power cord (x1) (TXFSX01RGRZ) Power cord (x1) (TXFSX02RGRZ)Drop-prevention bracket (x2) (TTRA0238) Safety cables (x2) Washers (x4) Wire rope fixing screw (x2) CD-ROM (x1) (TXFQB02VKN) AA/R6 batteries for remote control (x2)Lens fixing screw (x1) (XYN4+J18FJ) Attention After unpacking the projector, discard the power...
Page 18
About Your Projector 18 - ENGLISH Preparation About Your Projector Attention Do not drop the remote control. z Avoid contact with liquids or moisture. z Do not attempt to modify or disassemble the remote control. z Do not let strong light shine onto the signal receptor. The remote control may malfunction under strong light such as z fluorescent. Note The remote control can be used within a distance of about 30 m if pointed directly at the remote control receiver. The z remote control can...
Page 19
About Your Projector ENGLISH - 19 Preparation Projector body JFront view Side views J Û : Attach a commercial burglar prevention cable. Burglar hook port Û Auto Cleaning Filter (ACF) compartment ( Æpage 110) Remote control signal receptor Air exhaust port Air intake port Air intake port Air intake port Lamp unit compartment ( Æpage 111) Air exhaust port Filter indicator (FILTER) Indicates the filter status. ( Æpage 109) Remote control signal receptor Temperature indicator (TEMP) Indicates...
Page 20
About Your Projector 20 - ENGLISH Preparation CONTROL PANEL J Terminals on side J Attention Do not touch the LAN terminal with your bare hands or body, as body parts may have charged static electricity. Failure to z do so may cause malfunctions. Do not touch the metallic parts of LAN terminal and cable. Please connect the LAN to indoor devices only. z VIDEO Switches to VIDEO input. S-VIDEO Switches to S-VIDEO input. RGB1 Switches to RGB1 input. RGB2 Switches to RGB2 input. DVI-D/HDMI Switches to...