Panasonic Cs Me5 7rkua Operating Instructions Manual

Français English
F569978
Operating Instructions
Air Conditioner
Model No.
Indoor Unit
CS-ME5RKUA
CS-ME7RKUA
CS-E9RKUAW
CS-E12RKUAW
Outdoor Unit
Single Split Multi Split
CU-E9RKUA
CU-E12RKUACU-2E18NBU
CU-5E36QBU
CU-3E19RBU
CU-4E24RBU
Operating Instructions
Air Conditioner2-12
Thank you for purchasing Panasonic Air Conditioner.
Installation instructions attached.
Before operating the unit, read these operating 
instructions thoroughly and keep them for future 
reference.
Instructions d’utilisation...

2
Operation conditions
Use this air conditioner under the following temperature range.
DBT  : Dry bulb temperature
WBT : Wet bulb temperature
Temperature (°F/°C)CS-ME5RKUA
CS-ME7RKUA
CS-E9RKUAW
CS-E12RKUAWCU-E9RKUA
CU-E12RKUACU-2E18NBU
CU-5E36QBU
CU-3E19RBU 
CU-4E24RBU 
DBT WBT DBT WBT DBT WBT
COOL Max. 89.6 / 32 73.4 / 23 114.8 / 46 78.8 / 26 114.8 / 46 78.8 / 26
Min. 60.8 / 16 51.8 / 11 0 / -17.8 - / - 14.0 / -10 - / -
HEAT Max. 86.0 / 30 - / - 75.2 / 24 64.4 / 18 75.2 / 24 64.4 / 18
Min. 60.8 / 16 - /...

3
English
Quick guide
123
Inserting the batteries
1
  Pull out the back cover of 
remote control
2  Insert AAA or R03 batteries 
(can be used ~ 1 year)
3
  Close the cover
TIMER
SET
CANCEL ON
OFF1
23
SETAC
RC
TIMER
CANCEL
ON
OFF
13
SETCHECKRESETACRC
23
1
Clock setting
1
  Press CLOCK
2
  Set the time
3
  Confi rm
AUTO
COMFORT
MODE
POWERFUL/
QUIET
TEMP
OFF/ON
TIMER
SET
CANCEL ON
OFF1
23
AIR SWING
FAN SPEED
SETAC
RC
ECONAVI
FAN
SPEED
AIR
SWINGAUTO
HEAT
COOL
DRY
FAN
AUTOCOMFORT
POWERFUL/QUIET
TIMERSET...

4
Safety precautions
To prevent personal injury, injury to others 
or property damage, please comply with the 
following: 
Incorrect operation due to failure to follow 
instructions below may cause harm or damage, 
the seriousness of which is classifi ed as below:
WARNINGThis sign warns of 
death or serious 
injury.
CAUTIONThis sign warns of 
injury or damage to 
property.
The instructions to be followed are classifi ed by 
the following symbols:
This symbol denotes an 
action that is PROHIBITED.
These...

5
English
To prevent overheating, fi re or electric shock:• Do not share the same power outlet with 
other equipment.
• Do not operate with wet hands. • Do not over bend the power supply cord.
If the supply cord is damaged, it must be 
replaced by the manufacturer, service agent 
or similarly qualifi ed persons in order to avoid 
a hazard.
It is strongly recommended to install this 
unit using an Earth Leakage Circuit Breaker 
(ELCB) or Ground Fault Interrupt (GFCI) or 
Appliance Leakage Current Interrupt...

6
AUTO
COMFORT
MODE
POWERFUL/
QUIET
TEMP
OFF/ON
TIMER
SET
CANCEL ON
OFF1
23
AIR SWING
FAN SPEED
SETAC
RC
ECONAVI
FAN
SPEED
AIR
SWINGAUTO
HEAT
COOL
DRY
FAN
/
TEMP
OFF/ON
TIMERSET
CANCEL
ON
OFF
123
CHECK
Remote control display
Human activity 
sensor
Remote control 
receiver and 
Indicator 
Auto OFF/ON button
Use when remote control is misplaced or a malfunction occurs. Raise the front panel:
• To use in AUTO mode, press the button once.
• To use in COOL mode, press and hold the button until 1 beep is...

7
English
Note
ECONAVI
 , 
POWERFUL/
QUIET
 , 
AUTO
COMFORT
• Can be activated in all modes and can be 
cancelled by pressing the respective button 
again.
• Cannot be selected at the same time.
To set the timer
2 sets of ON and OFF timers are available 
to turn ON or OFF the unit at different preset 
times.
TIMERSET
CANCEL ON
OFF1
23
AC
CCANCEL
3
ACC
213
1Select ON or OFF 
timerExample: 
OFF at 11:50PM
• Each time pressed:
OFFAMCancel
2Set the time2PM
3Confi rmSET
PM
TIMER
• To cancel ON or OFF timer,...

8
Operation mode
AUTO : During operation mode selection the POWER indicator blinks.Single• Unit selects operation mode every 10 minutes according to setting temperature and room temperature.
Multi• Unit selects operation mode every 3 hours according to setting temperature, outdoor temperature and room 
temperature.
HEAT
 : Unit takes a while to warm up. The POWER indicator blinks during this operation.
COOL : Provides effi cient comfort cooling to suit your needs.
DRY : Unit operates at low fan speed to...

9
EnglishTo learn more... / Cleaning instructions
Cleaning instructions
To ensure optimal performance of the unit, 
cleaning has to be carried out at regular 
intervals. Dirty unit may cause malfunction 
and you may see error code “H99”. Please 
consult authorised dealer.
• Switch off the power at the circuit breaker before 
cleaning.
• Do not touch the aluminium fi n, sharp parts may 
cause injury.
• Do not use benzene, thinner or scouring powder.
• Use only soap (
 pH 7) or neutral household...

10
The following symptoms do not indicate malfunction.
SymptomCause
Mist emerges from indoor unit. • Condensation effect due to cooling process.
Water fl owing sound during operation. • Refrigerant fl ow inside the unit.
The room has a peculiar odour. • This may be due to damp smell emitted by the wall, 
carpet, furniture or clothing.
Indoor fan stops occasionally during automatic 
fan speed setting.• This helps to remove the surrounding odour.
Airfl ow continues even after operation has 
stopped.•...