Panasonic Combination Vcr Pv C2063 Operating Instructions

 Initial Setup and Connection Procedures are on pages 8 and 9.
Please read these instructions carefully before attempting to connect, 
operate, or adjust this product. Please save this manual.
Spanish Quick Use Guide is included. 
(Guía para rápida consulta en español está incluida.)
Model No.  PV-C2063
LSQT0666A
Basic Operation
Initial Setup
TV Operation
Timer Operation
Advanced Operation
For Your  Information
As an ENERGY STA R® Partner, 
Matsushita Electric Corporation of Amer i ca has de ter mined...

2
  Important Safeguards and Pre cau tions
OUTDOOR ANTENNA INSTALLATION
USING THE  UNIT
INSTALLATION
1  POWER SOURCE CAUTION
  Operate only from power source indicated on unit or in 
this manual. If uncertain, have your Electric Utility Ser-
vice Company or Video Products Dealer verify your 
home power source.
2  POWER CORD PLUG
  For safety, this unit has a polarized type plug (one 
wide blade), or a three-wire grounding type plug. Al-
ways hold the plug  rmly and make sure your hands 
are dry when...

3
Safety Precautions/Mesures de sécurité
This product utilizes both a Cathode Ray Tube (CRT) and other components that contain lead. Disposal 
of these materials may be regulated in your community due to environmental considerations. For 
disposal or recycling information please contact your local authorities, or the Electronics Industries 
Alliance: 
Warning :  To prevent  re or shock hazard, do not expose this equipment to rain or 
mois ture.
Caution :  To prevent electric shock, match wide blade of...

4For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : [email protected]
Unit Information
Playing older or damaged tapes may eventually 
cause video heads to become clogged.
  Speci cations
 Designs and spec i   
ca tions are sub ject to change 
without no tice.
V I DEO  HEADS  MAY
NEED  CLEAN I NG  PL EASE   I NSERT  HEAD CLEAN I NG  CASSETTE 
OR  REFER   TO  MANUAL 
END : PLAY
  Head Cleaning
 
Record/Playback Time
Only use tapes with the  
 mark in this unit.Unit auto...

55
Initial Setup
Table of Contents
Basic Operation
TV Operation
Advanced Operation
For Your  Information
Initial Setup
Timer Operation
Important Safeguards and Precautions ................................................ 2
Safety Precautions/Mesures de sécurité............................................... 3
Unit Information ....................................................................................... 4
Location of Controls...

6For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : [email protected]
  Location of Controls
 
Remote Control Buttons
  When LIGHT is pressed, available buttons in the selected mode light up and the selected mode but ton (COM BO or 
DSS/CABLE)  ashes for 5 seconds. If no button is pressed, light goes out in 5 sec onds to con serve batteries. Also, by 
holding down a button, you can con rm the selected mode (mode but ton will  ash) in the dark.
  When EJECT is pressed,...

77
Initial Setup
VHF/UHF
  Front View of the Unit and  Indicators
 
Rear View of the Unit
VIDEO INPOWER VOL CHSTOP/EJECT REW/
PLAY/REPEATFF/ REC TIMER/FM
ACTIONR E C ON TIMERPROG TIMERAUDIO IN
Built-In Speaker
REWIND/SEARCHSee previous page.ACTIONPress together with STOP.
PHONES JackConnect an 
earphone or 
headphones.
TIMER/FMSets a timer alarm up 60 min.
Enables FM Radio.
AC Power PlugWhen plugged into  an AC outlet, the 
unit consumes 2.5 W of electric power 
in OFF condition.  VHF/UHF Antenna Input...

8For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : [email protected]
 2 /  6 / 2003  THU 12 : 00PMDST : ON
A
UTO  CLOCK   SET
COMPLETED
SETT I NG : CH 1 0
If AUTO CLOCK SET IS INCOMPLETE screen 
appears, set the clock using MANUAL CLOCK 
SET procedure on next page.
AUTO  CLOCK   SET
IS INCO
MPLETE
PLEASE   SET   CLOCK   BY
PRESSING   ACTION   KEY
  Initial Setup (Ready to Play)
1
Plug the unit power cord into AC wall 
outlet. 
  If you use a cable box, turn 
it on and...

99
Initial Setup
VIDEO INPOWER VOL CHSTOP/EJECT REW/
PLAY/REPEATFF/ REC TIMER/FMACTIONR E C ON TIMERPROG TIMERAUDIO IN
  Reset all unit Memory Functions
When moving unit to a new location, or if a mistake 
was made in the Initial Setup section.
 Make sure a tape is not inserted in the unit.
Manual Clock Set
If AUTO CLOCK SET was incomplete, manually 
set the clock as follows.
SET  CLOCK
DST
 : ON1 /     /:
SELECT :                  SET : END       : ACT I ON   
1
2
Press ACTION on the remote to display...

10For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : [email protected]
Reset Language, Channels, Clock,     
4)Press   
 and 
press  
  
 to select and 
set the month, date, year, 
time, and DST (Daylight 
Saving Time).
5) Press ACTION twice to 
start the clock
 and exit 
this mode. 3) Press 
  
 to select 
“ANTENNA,” then 
press 
   to set your 
antenna system
 (“TV” or “CABLE”).
4) Press 
  
 to select 
“AUTO SET,” then 
press 
  .
   After Channel Auto Set is...