Panasonic Color Cctv Cameras Wv Cf284 Operating Instructions

Direct mounting
If the camera is directly mounted on a
wall/ceiling, align the camera mounting posi-
tion with the position of the hole through
which the cables run and make the hole.
If no hole is made through a wall/ceiling and
open wiring along a wall/ceiling is used,
process the cover so that the cables can be
run through the side of the cover.
11
Installations and Connections
The following installation should be made by qualified service personnel or system installers.
Preparations
Important:
•...

Disassembling the Camera
1. Remove the top cover.
• Adjust the marker of this unit to INSERT
of the DOME COVER label on the top
cover and turn the top cover counter-
clockwise to remove it. 
• The clear dome cover and the inner
dome cover are joined into a single unit.
Therefore, never try to remove them.
To mount the camera directly on
the wall/ceiling
1. Prepare the mounting space.
2. Place the camera on the wall/ceiling and
DOME COVERL
O
C
K
A
D
J
U
S
TI
N
S
E
R
T
DOME COVERLOCKADJUSTINSERT
mark...

qAs a video output cable, the LAN cable
(Category 5) or the like is used. Cut off
the end of wires.
wPass the wiring materials, processed as
per q, through the twisted pair wire
13
WV-CF284T/
CF294T WV-CF284/
CF294ModelsCable type
Extensible length
RG-59/U (3C-2V)Approx. 250 m
{825 ft}
RG-6/U (5C-2V)Approx. 500 m
{1 650 ft}
RG-11/U (7C-2V)Approx. 600 m
{1 980 ft}
RG-15/U (10C-2V)Approx. 800 m
{2 640 ft}
LAN cable, etc.Approx. 100 m 
{328 ft}
holes and connect them to the twisted
pair wire terminals (+)...

14
Copper wire
size (AWG)
Length of
Cable
(Approx.)#24
(0.22 mm2)
20
65
#22
(0.33 mm2)
30
100
#20
(0.52 mm2)
45
160
#18
(0.83 mm2)
75
260
Recommended wire gauge for 24 V AC line.
(m)
(ft)
Power connection
Connect the three-conductor cable of the
camera to the power supply. The wire colors
and functions are shown in the table.
Wire color 12 V DC 24 V AC
Brown Positive Live
Blue Negative Neutral
Green/yellow Grounding
Grounding
Caution:Be sure to connect the GND
(grounding) lead of the camera and...

3. Zoom and focus adjustment
At the same time for the pan and tilt adjust-
ments (Step 2), make zoom and focus adjust-
ments.

qLoosen the zoom lock lever and move
the lever between TELE and WIDE to
obtain the appropriate angle of view.
Tighten the zoom lock lever. 
wLoosen the focus lock lever and move
the lever between FAR and NEAR to
obtain the optimum focus. Tighten the
focus lock lever. 
Note:To change the angle of view by
moving the zoom lock lever, also
move the focus lock lever to adjust
the...

• Subjects with laterally parallel lines
(e.g. shutters)
• Foggy or dirty dome cover
rFocus adjustment is available by press-
ing the AF switch with a pointed item
such as a ballpoint pen even after
mounting the dome cover. In such a
case, the direction of the camera and the
presence of the object should be
checked beforehand because visual
check is not available on the monitor.
Notes: 
• Before mounting the top cover, make
sure that the subject is present.
• Before pressing the AF switch, make
sure that...

eRotate the top cover clockwise to adjust
the marker to LOCK.
2. Fix the top cover and the camera main
unit by means of an accessory fixing
screw (M3).
17
Assembling the Camera
1. Mount the top cover.
qAdjust the marker of this unit to INSERT
of the DOME COVER label on the top
cover to install the top cover.
wAdjust the inner dome.
Rotate the top cover clockwise to adjust
the marker to ADJUST. 
Turn the dome cover block to the right
and left, watching at the monitor. Make
adjustments so that no eclipse...

18
Specifications
Power source and power 
consumption: 24 V AC 60 Hz, 2.7 W
12 V DC, 220 mA
Image sensor: 1/4 inch interline transfer CCD
Effective pixels: 768 (H) x 494 (V)
Scanning area: 3.6 (H) x 2.7 (V) mm 
Scanning system: 2 : 1 interlace
Scanning lines: 525 lines
Scanning frequency: Horizontal: 15.734 kHz
Vertical: 59.94 Hz
Synchronization: Internal, multiplexed vertical drive (VD2)
Resolution: Horizontal: 540 TV lines (at center)
Vertical: 350 TV lines (at center)
Video output: 1.0 V[P-P] NTSC...

19
Standard Accessories
Operating Instructions (this book) .................. 1 pc.
Warranty card  ................................................ 1 pc.
The following is for installation.
Top cover fixing screw ................................... 1 pc. 

20
Le numéro de série de ce produit se trouve sur
lappareil.
Nous vous conseillons de relever le numéro de série
de votre appareil dans lespace réservé ci-dessous et
de conserver précieusement votre notice dinstruc-
tions en tant que justificatif dachat aux fins didentifi-
cation en cas de vol.
No. de modèleNo. de série
CAUTION   ATTENTIONRISK OF ELECTRIC SHOCK DO NOT OPEN
RISQUE DE CHOCS ELECTRIQUES NE PAS OUVRIR
ATTENTION: AFIN DE PRÉVENIR LE RISQUE DE CHOCS
ÉLECTRIQUES, NE PAS RETIRER LES VIS. 
TOUTE...