Panasonic Color CCTV Camera Wv Cs580 Wv Cs584 Installation Guide

							21
Important:  
 The power supply of 24 V AC shall be insulated 
   against 220 to 240 V AC. 
Note:  
 Can only be connected to 24 V AC power supply. 
 When using an alarm input or output connector,  
please connect directly (there is no dedicated cable 
in between). 
Alarm In/Out Ratings 
Alarm In :    5 V DC pull-up input. Drive capacity of at  
lease 0.2 mA required.  
  OFF :  4 V to 5 V , or open  
  ON : 1 V DC or less, or short 
Alarm Out :   Open collector output. 16 V DC,  
    maximum drive current: 100 mA 
  OFF : Open 
  ON : 100 mA or less 
Note:  
 Do not turn off camera power within 30 seconds 
 after turning it on. Doing so can cause pan, tilt, 
 zoom, or focus to go out of position. 
• 24 V AC Power Supply Connection
Recommended wire gauge sizes for 24 V AC line
#24 (0.22mm2) Copper wire size (AWG)
Length of  cable (approx.)
#22 (0.33mm2) #20 (0.52mm2) #18 (0.83mm2) 
(m) 20 30 45 75 
						

							22
Troubleshooting
Before requesting service, check the following symptoms to see if you can solve the problem yourself.  
If the countermeasures described below do not correct the problem, or if the symptoms you are experiencing are not 
covered here, contact a quality service person or system installer. 
Problem  Cause and Recommended Action Reference Pages
No picture (dark screen)

operating instructions that come with your system 
controller. 
—
 Is the lens iris closed? 
    Execute the iris reset from the system controller you  
are using.
Operating  
Instructions
   Is the camera set up for a fixed shutter speed?  Operating 
Instructions
White picture
 
enhancement (SENS UP) setting?
Operating  
Instructions
   Is the lens iris open? Operating 
Instructions
Out of focus picture 
   Is the dome cover or lens of the camera dirty? If so,  
clean them. 7
 Is the object one that is not compatible with auto 
focus? For such objects, focus manually. 
Operating  
Instructions
Digital noise in the  
picture
 
cleaning function turned on?  
Operating  
Instructions
   Is the camera set up correctly?  9
   Is MANUAL selected for the auto focus mode?  Operating 
Instructions 
						

							23
Problem  Cause and Recommended Action Reference Pages
Poor picture color 
   Is the dome cover or lens of the camera dirty? If so,  
clean them. 7

quality.
Operating  
Instructions
   Check the white balance setting. Operating 
Instructions
Image flicker    If Super Dynamic  6 is turned on, turn it off. Operating  
Instructions
Afterimages in  
the picture    Check the DNR setting.  Operating  
Instructions
Black-and-white picture   The camera has an auto black-and-white switching  
mode function. Check the setting of this mode. 
Operating  
Instructions
Frequent switching  
between the color and 
the black-and-white 
modes 
 Adjust the black-and-white mode switching level,  
and the duration time setting. 
Operating  
Instructions
White specks in the  
picture  
 
compensation. 
Operating  
Instructions
Menu does not open. 
 
operating instructions that come with the system 
controller you are using. 
—
 Are camera communication settings configured 
correctly?
12-15 
20 
						

							24
Problem  Cause and Recommended Action Reference Pages
Black line appears in  
the image
 Whether or not the connected system controller is  
set as multiplex vertical driver (VD2)?7
Menu settings will not  
change.    Is the password lock function turned on?Operating  
Instructions
I forgot the password.    Contact a quality service person or system installer. —
Picture does not  
switch to black-and-
white. 
 Switching is not performed when the ALARM IN 4  
setting is BW. Check the setting. 
Operating  
Instructions
Pan, tilt, zoom, or  
focus do not work. 
 
operating instructions that come with the system 
controller you are using. 
—
 The camera has a pan limit function. Check the 
PAN LIMIT settings. 
Operating  
Instructions
 The motor or lens may be worn. Contact a quality  
service person or system installer. —
The camera movement  
modes (OFF, SEQ, 
SORT, AUTOPAN, 
PATROL, AUTOTRACK) 
do not work.   
   Check the self return function. Operating  
Instructions
   Check the ALARM IN settings. Operating 
Instructions
 
detector. 
Operating  
Instructions 
						

							25
Problem  Cause and Recommended Action Reference Pages
Power cord sheathing is  
damaged. 
 The power cord is damaged. Continued use creates the risk of  
electric shock and fire. Immediately unplug the power plug and 
contact a qualified service person or system installer for servicing. 
Power cord becomes  
hot during operation. 
Power cord becomes 
warm or hot when it is 
bent or stretched during 
use. 
  Periodically check the power cord. 
Camera position is  
different from the 
preset position setting.    Perform REFRESH from the special setup menu. Operating  
Instructions
Picture is different from  
the position setting. 
 Adjust the picture using the preset menu and a  
scene file. 
Operating  
Instructions
Upper part of the picture  
is black when the 
camera is in a horizontal 
orientation. 
 This is caused by the cameras internal cover. It  
does not indicate malfunction.  
Operating  
Instructions
Camera suddenly starts  
to pan by itself. 
 If the cleaning function is turned on, this is normal  
does not indicate malfunction. Check the 
CLEANING settings. 
Operating  
Instructions
 
symptom could be due to noise. 7, 9
Operating  
Instructions
The camera movement  
modes (OFF, SEQ, 
SORT, AUTOPAN, 
PATROL, AUTOTRACK) 
setting changes.   
   Check the self return function.  
						

							26
 General
         WV-CS580  WV-CS584 
Power Requirements  220 V - 240 V AC, 50 Hz  24 V AC, 50 Hz 
Power Consumption  4.6 W  4.3 W
Pick-up Device  1/4-type interline transfer CCD 
Effective Pixels  976 (H)  × 582 (V) 
Scanning Area  3.66 mm (H)  × 2.73 mm (V) 
Signal PAL 
Synchronization Internal (INT) 
Scanning 2:1 interlace
Scanning Frequencies  Horizontal: 15.625 kHz, Vertical: 50.00 Hz 
Video Output  VBS: 1.0 V [p-p]/75  Ω (BNC plug) 
Resolution (Center)  Horizontal:  650 TV lines typ. (Center)
 Vertical      :  400 TV lines minimum (Center) 
Minimum Illumination  0.5 lx (color mode) 
  0.04 lx (black-and-white mode) 
  When using smoke dome cover (option): 
  0.9 lx (color mode) 
  0.08 lx (black-and-white mode)
  SENS UP: OFF; AGC: HIGH  
Dynamic Range  54 dB typ. (SUPER-D6: ON)  
S/N Ratio  52 dB minimum (AGC: OFF) 
Ambient Operating Temperature  -10 °C to +50 °C; Humidity 90 % max. (non-condensation)
Dimensions  185 mm (D)  × 202 mm (H) (including Decorative Cover)  
Mass  Approx. 1.7 k g (including Decorative Cover) 
Finish  Camera: ABS + PC resin, coated (Paint color: Fine Silver)
  Dome: Clear acrylic resin
Panning Range 360° endless 
Panning Modes Manual, auto, manual position, sequential position  
Panning Speed Manual: Approx. 0.065 °/s to 120 °/s  8  steps, 16 steps, 64 steps 
Preset: Approx. 400 °/s 
Tilting Range -5° to 185° (horizontal - vertical - horizontal) 
Tilting Modes Manual, manual position, sequential position
Tilting Speed *1Manual: Approx. 0.065 °/s to 120 °/s  8  steps, 16 steps, 64 steps 
Preset: Approx. 400 °/s
Zoom Ratio 36x (Approx. 720x with digital zoom) 
Focal Length 3.3 mm to 119 mm  
Maximum Aperture Ratio 1:1.4 (WIDE) to 4.2 (TELE) 
Object Distance 1.8 m
Iris Range F1.4 to 22, Close 
Angular Field of View Horizontal: 1.7° (TELE) to 60.2° (WIDE) 
Vertical: 1.3° (TELE) to 46.0° (WIDE)
*1  Actual speed depends on type of controller being used. 
  Lens 
 Pan and Title 
Specifications 
						

							27
 Main Functions
Controller Interface  Coaxial Multiplex System, RS485 
Control Functions  Pan and tilt, zoom and focus, 256 preset positions, home position, patrol 
AGC  ON (LOW), ON (MID), ON (HIGH), OFF
Title (ID)  ON, OFF (Preset ID, camera ID, area title: 16 alphanumeric characters) 
Zoom Speed  around 6.0 seconds (TELE to WIDE) in manual mode 
Zoom Limit  1x to 720x (Over 36x is digital zoom)
Password Lock  All menus 
Auto Focus  MANUAL/AUTO (PAN, TILT, ZOOM linked) 
Iris  ALC (Adjustable OPEN/CLOSE output target level)/MANUAL
Shutter  OFF (1/50), AUTO, 1/120, 1/250, 1/500, 1/1000, 1/2000, 1/4000, 1/10000
Electronic Sensitivity Enhancement  32X max. AUTO, 512X max. FIX 
Auto Mode  OFF, SEQ, SORT, AUTOPAN, PATROL, AUTOTRACK
Auto Pan Key  SEQ, SORT, AUTOPAN, PATROL, AUTOTRACK 
Digital Flip  ON/OFF 
SUPER-D6 ON/OFF
VMD  OFF/MOTION DET/SCENE CHANGE 
Alarm Input/Output  4 inputs (ALARM IN 1 to ALARM IN 4) 
  2 outputs (ALARM/AUX1, BW/AUX2)
Black-and-white Mode Switching  AUTO/ON/OFF 
Privacy Zone  ON/OFF (8 zone settings)  
Patrol STOP/PLAY/LEARN 
Cleaning ON/OFF 
Image Hold  ON/OFF 
Auto Image Stabilizer  ON/OFF
Scene Select Setting  INDOOR (L) /INDOOR (H) /OUTDOOR (L) /OUTDOOR (H) 
Language Setting  Japanese, English, German, French, Italian, Spanish, Russian, Chinese 
Standard accessories
CD-ROM*   . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 pc. 
Installation Guide (this book)   . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 pc. 
*The CD-ROM contains the operating instructions (PDF). 
The following parts are used during installation procedures. 
Decorative Cover   . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 pc. 
Dust Protect Sheet   . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 pc.
Optional accessories
Ceiling Mount Bracket                                                                   WV-Q105 
Ceiling Mount Bracket                                                                   WV-Q126
Ceiling Mount Bracket                                                                   WV-Q117
Wall Mount Bracket                                                                         WV-Q118
Dome Cover (approx. 50% transparency, smoked type)              WV-CS4S
* Weight and dimensions indicated are approximate.  
						

							28
Information on Disposal for Users of Waste Electrical & Electronic Equipment (private  
households)
This symbol on the products and/or accompanying documents means that used electrical and  
electronic products should not be mixed with general household waste.
For proper treatment, recovery and recycling, please take these products to designated collection 
points, where they will be accepted on a free of charge basis. Alternatively, in some countries you 
may be able to return your products to your local retailer upon the purchase of an equivalent new 
product.
Disposing of this product correctly will help to save valuable resources and prevent any potential 
negative effects on human health and the environment which could otherwise arise from inappropriate waste 
handling. Please contact your local authority for further details of your nearest designated collection point.
Penalties may be applicable for incorrect disposal of this waste, in accordance with national legislation.
For business users in the European Union
If you wish to discard electrical and electronic equipment, please contact your dealer or supplier for further 
information.
Information on Disposal in other Countries outside the European Union
This symbol is only valid in the European Union.
If you wish to discard this product, please contact your local authorities or dealer and ask for the correct 
method of disposal. 
						

							29 
						

							30