Panasonic Cd Stereo System Sc-akx14 Owners Manual

Panasonic Consumer Marketing Company of North America,
Division of Panasonic Corporation of North AmericaOne Panasonic Way, Secaucus,
New Jersey 07094
http://www.panasonic.com© Panasonic Corporation 2012
Printed in Malaysia
Owner’s Manual
CD Stereo System
Model No.
 SC-AKX14
Thank you for purchasing this product. 
For optimum performance and safety, please read these instructions carefully.
Please keep this manual for future reference.
If you have any questions, contact:1-800-211-PANA (7262)La guía...

2
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
7) Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
8) Do not install near any heat sources such as radiators,  heat registers, stoves, or other apparatus (including 
amplifiers) that produce heat.
9) Do not defeat the safety purpose of the polarized or  grounding-type plug. A...

3
Inside of product
Safety precautionWARNING!Unit
• To reduce the risk of fire, electric shock or product damage,
– Do not expose this unit to  rain, moisture, dripping or 
splashing.
– Do not place objects filled wit h liquids, such as vases, 
on this unit.
– Use only the recommended accessories.
– Do not remove covers. 
– Do not repair this unit by yourself. Refer servicing to  qualified service personnel.CAUTION!Unit
• To reduce the risk of fire, electric shock or product damage,
– Do not install or...

4
Product service1) Damage requiring service — The unit should be 
serviced by qualified service personnel if:
a) The AC power supply cord or the plug has been  damaged; or
b) Objects or liquids have gotten into the unit; or
c) The unit has been exposed to rain; or
d) The unit does not operate normally or exhibits a  marked change in performance; or
e) The unit has been dropped or the cabinet damaged.
2) Servicing  — Do not attempt to service the unit beyond 
that described in these operating...

Limited Warranty Coverage 
(For USA and Puerto Rico Only)If your product does not work properly because of a defect in 
materials or workmanship, Panasonic Consumer Marketing 
Company of North America (referred to as “the warrantor”) will, for the 
length of the period indicated on the chart below, which starts with the 
date of original purchase (“warranty period”), at its option either (a) 
repair your product with new or refurbished parts, (b) replace it with a 
new or a refurbished equivalent value...

5
Supplied accessoriesCheck and identify the supplied accessories.
Use numbers indicated in parentheses when asking for 
replacement parts. (Product numbers correct as of 
February 2012. This may be subject to change.)
To order accessories, refer to “Accessory Purchases 
(United States and Puerto Rico)”.1 x AC power supply cord(K2CB2YY00059)1 x AM loop antenna(N1DYYYY00011)1 x FM indoor antenna(RSAX0002)1 x Remote control(N2QAYB000636)1 x Remote control battery
Placement of speakersThe right and left...

13
SpecificationsAmplifier sectionTuner, terminals section
Disc sectionUSB sectionSpeaker section
GeneralNote:
• Specifications are subject to change without notice.Mass (weight) and dimensions are approximate.
• Total harmonic distortion is measured by the digital 
spectrum analyzer.
RMS output power stereo mode
Front Ch (both ch driven) 125 W per channel (4  Ω), 1 kHz, 10% THD
Total RMS stereo mode power  250 W (10% THD) 320 W (max)
FTC output power stereo mode
Front Ch (both ch driven) 56 W per...

7
Making the connectionsConserving power
The system consumes approximately 0.2 W when it is in 
standby mode. Disconnect the power supply if you do not 
use the system.
Some settings will be lost after you disconnect the system. 
You have to set them again.
1
Connect the speakers.Be careful not to cross (short-
circuit) or reverse the polarity 
of the speaker wires as doing 
so may damage the speakers.
2
Connect the AM loop antenna.
Stand the antenna up on its base until it clicks.
3
Connect the FM...

6
Overview of controls
A
Standby/on switch [` ], [1 ] 
Press to switch the unit from on to standby mode or vice 
versa. In standby mode, the unit is still consuming a 
small amount of power.
B
Numeric buttons [1 to 9, 0,  10]
To select a 2-digit number
Example: 16: [ 10]  =[1]  =[6]
C
Delete a programmed track
D
Select audio source
E
Basic playback control
F
Select the sound effects
G
Auto preset the radio station
H
View content information
Decrease the brightness of the display panel
Press and hold the...

8
DiscPlaying disc1
Press [x, OPEN/CLOSE] on the main unit to open 
the disc tray.
Put in a disc with the label facing up.
Press [ x, OPEN/CLOSE] again to close the disc tray.
2
Press [CD] and then press [ 4/9 ] to start playback.
Viewing available informationYou can view the available information on the display panel.
Press [DISPLAY].
Note:
• Maximum characters that can be shown: 
approximately 16
• This system supports ver. 1.0 and 1.1 ID3 tags.
• Text data that the system does not support can show...