Panasonic Aj D700_200dpi Operating Instructions Manual

Adjusting the White Shading
The AJ-D700 is adjusted for the Fujinon S18x6.7 BERM4 (with extender) and S18X6.7 BRM4
(without extender) lenses when shipped from the factory. If a lens other than these two lenses is to
be used, adjusting the white shading before shooting is recommended. In particular, be sure to
adjust the white shading as indicated below when using a 1/2-inch camera lens without an ex-
tender (other than the S18X6.7 BRM4 noted above) or a 2/3-inch camera lens via an adaptor.
The AJ-D700 is...

7Set the WHITE BAL selector switch to A or B execute AWB.
Next, execute ABB and then execute AWB again.
WHITE BAL: A or B
8Repeat step 6.
9Set the MENU switch from OFF to SET while holding down the SHIFT/ITEM and UP buttons
to open the menu.
Press the PAGE button until the AUTO SHADING page appears.
Press the SHIFT/ITEM button to move the arrow on the left to the WHITE position and then
press the UP or DOWN button.
ACTIVE appears on the viewfinder to indicate that white shading automatic adjustment is...

Adjusting the Viewfinder 

Adjusting the Viewfinder 

Detaching the Eyecup
Detaching the eyecup allows the entire screen to be seen clearly even when shooting with your
eye removed from the viewfinder. This also facilitates the removal of dust which has adhered to
the CRT screen and mirror.

Absolutely do not wipe the mirror surface as it has been specially treated. Dust which has adhered
to the mirror should be blown away with a blower, etc.
1Press the lock button.
2Turn the lock ring as far as possible in the counter-clockwise direction and line up the...

Adjusting the Viewfinder 

Audio Input Preparations
Using the Microphone Mounted to the Main Unit
Using the AJ-MC700P microphone kit (option) or the AJ-MH700P microphone holder (option) al-
lows a microphone to be mounted to the main unit.
See the Handling Instructions for the microphone holder.
Using the AJ-MC700P Microphone Kit (Option) Microphone Mounted to the
Main Unit
1Mount the microphone holder.
Viewfinder
Microphone Holder
2Mount the microphone.
3Connect the microphone connecting cable to the unit’s MIC IN jack.
MIC IN...

Audio Input Preparations
Mounting the AJ-MH700P Microphone Holder (Option)
1Remove the microphone holder mounting screws.
2Mount the AJ-MH700P microphone adaptor (option) to the main unit.
Mount the microphone
adaptor using the
accessory screws.
3Mount the microphone to the microphone holder and tighten the screws.
4Connect the microphone connecting cable to the MIC IN jack.
To the MIC IN Connector
5Set the AUDIO IN switch to FRONT [MIC] in accordance with the audio channel to be re-
corded.
- 38 - 

Using the Microphone not Mounted to the Main Unit 

Audio Input Preparations
Using the Microphone not Mounted to the Main Unit
Up to two external microphones can be connected to
the AUDIO IN CH1/CH2 Connectors.
Phantom power supply type microphones can also be
supported by a menu setting.
AUDIO IN Switch: Set the AUDIO IN Switches
of the channels to which
microphones are
connected to REAR [MIC].
-40-